When
indicator lamp0043flashes green:pro-
gramming wassuccessf ul.The next step isto
synchr onizetherolling code.
X Release button0084ofremot econt rol0083 ofthe
garage doordrive.
If indicator lamp0043lights upred: repeat the
programmin gprocess forthe corr esponding
button onthe rear-v iewmirror. Whendoing
so, vary thedistanc ebetween remotecont rol
0083 and therear-v iewmirror.
The required distancebetween remotecon-
trol 0083and theintegr atedgarage dooropener
depends onthe garage doordrive system.
Several attemptsmight beneces sary.You
should testevery position foratleast
25 secon dsbefore tryinganother position.
Problems whenprogram ming
If you areexperien cingproblems programmin g
the integr atedgarage dooropener onthe rear-
view mirror, takenoteof the following instruc-
tions :
R Check thetran smitt erfrequenc yused by
garage doordrive remot econt rol0083 and
whether itis supported. Thetransmitt erfre-
quency canusually befound onthe back of
remot econt rol0083 for the garage doordrive.
The integr atedgarage dooropener iscom-
patible withdevices thathave units which
operate inthe frequenc yrange of280 to
433 MHz.
R Replace thebatter iesingarage doorremot e
cont rol0083. This increases thelikelihood that
garage doorremot econt rol0083 will tran smit a
stron gand precise signaltothe integr ated
garage dooropener.
R When programmin g,hold remot econt rol0083
at varying distancesand angles frombut-
ton s0044 to0085 which youareprogrammin g.Try
various anglesatadistanc ebetween 2and
8 inches (5to20cm) oratthe same angle but
at varying distances.
R Ifanother remotecont rol0083 isavailable for
the same garage doordrive, repeat thesame
programmin gsteps withthisremot econt rol
0083. Before perform ingthese steps, makesure
that new batter ieshave been installed in
garage doordrive remot econt rol0083.
R Note thatsome remot econt rolsonly transmit
for alimited amount oftime (theindicator
lamp onthe remot econt rolgoes out).Press button
0084onremot econt rol0083 again before
tran smission ends.
R Align theanten nacable ofthe garage door
opener unit.Thiscanimprove signalrecep-
tion/ transmission.
Opening/closi ngthe gara gedoor Aft
erithas been programmed, theintegr ated
garage dooropener perform sthe funct ionofthe
garage doorsystem remotecont rol.Please also
read theoperating instruction sfor the garage
door system.
X Turn theSmart Keytoposition 2in the ignition
lock (Ypage 123).
X Press button 0044,0087or0085 which youhave
programmed tooperate thegarage door.
Garage doorsystem withafixed code: indi-
cator lamp0043lights upgreen.
Garage doorsystem witharolling code:indi-
cator lamp0043flashes green.
The transmitt erwill tran smit asignal aslong
as the button ispressed. Thetransmission is
halted afteramaximum often secon dsand
indicator lamp0043lights upyellow.
X Press button 0044,0087or0085 again ifneces sary.
Clearing thememor y Make
surethatyouclear thememory ofthe
integr atedgarage dooropener beforesellingthe
vehicle.
X Turn theSmart Keytoposition 2in the ignition
lock (Ypage 123).
X Press andhold button s0044 and 0085.
The indicator lampinitially lightsupyellow
and then green.
X Release buttons0044 and 0085.
The memory ofthe integr atedgarage door
opener inthe rear-v iewmirror iscleared. Featur
es
257Stowage andfeatures Z
The
towing eyeislocated withthevehicle tool
kit under thecargo compart mentfloor
(Y page 274).
Vehicles withtheTIREFIT kit:the towing eyeis
beneath thetire inflation compressor
(Y page 274).
X Press themark oncover 0043inwards inthe
direction ofthe arrow.
X Take cover 0043offthe opening.
X Scr ewinthe towing eyeclock wisetothe stop.
Removing thetowing eye X
Unsc rewand remove thetowing eye.
X Attach cover 0043tothe bumper andpress until
it engages.
X Place thetowing eyeinthe stowage well
beneath thecargo compart mentfloorinthe
cargo compart ment(Ypage 274).
X Vehicles withtheTIREFIT kit:put back thetire
inflation compressor (Ypage 274). Towing
thevehicle withthefront axle
raised
Observe theimportant safetynoteswhen tow-
ing your vehicle withthefront axleraised
(Y page 284).
Only vehicles without4MATICcanbetowed
with thefront axleraised.
! Vehicles
with4MATI Cmust notbetowed
with either thefront orthe rear axle raised, as
doing sowill damage thetrans mission.
Vehicles with4MATI Cmay either betowed away
with both axles onthe ground orbe loaded up
and trans ported.
! The
ignition mustbeswitched offifthe vehi-
cle isbeing towed withthefront axleraised.
Otherwise, ESP®
may intervene anddamage
the brake system.
X On
vehicles withKEYL ESS-GO orthe KEY-
LESS-GO startfunction: youmust usethe
Smart Keyinstead ofthe Start /Stopbutton
(Y page 124).
X Make surethatthevehicle isstation ary.
X Turn theSmart Keytoposition 0048inthe igni-
tion lock.
X When thevehicle isstation ary,depress the
brake pedalandkeep itdepressed. X
Shift theautomatic transmission toposition
005D.
X Release thebrake pedal.
X Release theelectric parking brake.
X Switch offthe automatic locking
(Y page 189).
X Switch onthe hazard warning lamps
(Y page 103).
X Turn theSmart Keyinthe ignition locktoposi-
tion 005Aand leave theSmart Keyinthe ignition
lock. Towing
avehicle withboth axles on
the ground
It is important thatyouobserve thesafety
instr uctions whentowing awayyourvehicle
(Y page 284).
X On
vehicles withKEYL ESS-GO orthe KEY-
LESS-GO startfunction: youmust usethe
Smart Keyinstead ofthe Start /Stopbutton
(Y page 124).
The automatic transmission automatically shifts
to position 005Dwhen youopen thedriver's or
front -passenger doororwhen youremove the
Smart Keyfrom theignition lock.Inorder to
ensure thattheautomatic transmission staysin
position 005Cwhen towing awaythevehicle, you
must observe thefollowing points:
X Make surethatthevehicle isstation ary.
X Turn theSmart Keytoposition 0048inthe igni-
tion lock.
X Depress andhold thebrake pedal.
X Shift theautomatic transmission toposition
005C.
X Leave theSmart Keyinposition 0048inthe igni-
tion lock.
X Release thebrake pedal.
X Release theelectric parking brake.
X Switch onthe hazard warning lamps
(Y page 103).
i In
order tosignal achange ofdirection when
towing thevehicle withthehazard warning
lamps switched on,use thecombinat ion
switch asusual. Inthis case, onlytheindicator
lamps forthe direction oftravel flash.After
resett ingthe combinat ionswitch, thehazard
warning lampstartsflashing again. 286
Towing
andtow-sta rtingBr eakdown assistance
