2019 MAZDA MODEL CX-30 change wheel

Adjustable Speed Limiter
(ASL)
*
▼Adjustable Speed Limiter (ASL)
The ASL is a function to prevent the
vehicle from being driven at a vehicle
speed faster than a set speed. The
vehicle speed is controlled to kept it
below the set speed even if the
accelerator pedal is depressed.
The ASL can be set between 30 km/h
(19 mph) and 200 km/h (125 mph).
The vehicle speed may exceed the set
speed when the vehicle is driven on a
down slope, however, the system
notifies the driver by flashing the
display and operating a warning
sound.
WARNING
Always turn off the system when
changing drivers:
If the driver is changed and the new
driver is unaware of the ASL function,
the vehicle may not accelerate when
the driver depresses the accelerator
pedal, leading to an accident.
The system consists of the ASL display
and the speed limiter switch on the
steering wheel.
Multi-information display (Basic
display)
1. ASL set vehicle speed

Multi-information display
(i-ACTIVSENSE display)
1. ASL set vehicle speed

Active driving display
1. ASL set vehicle speed

When Driving
i-ACTIVSENSE
4-166*Some models.

Intelligent Speed
Assistance (ISA)
*
▼Intelligent Speed Assistance (ISA)
The ISA is a function which keeps the
vehicle speed below the speed limit
set from a speed limit sign or an
optionally set speed limit. The speed
limit can be set between 30 and 200
km/h (19-125 mph), and if the vehicle
speed exceeds the set speed limit
while driving on steep slopes, the
system notifies the driver using the
display and a warning sound.
The ISA recognises a speed limit sign
based on the
Tra ffi c Sign Recognition
System (TSR) or the navigation system
information.
Refer to
Tra ffi c Sign Recognition
System (TSR) on page 4-111.
WARNING
Always turn
off the system when
changing drivers:
If the driver is changed and the new
driver is unaware of the ISA function,
the vehicle may not accelerate when
the driver depresses the accelerator
pedal, leading to an accident.
Depending on the weather conditions
or problems with traffic signs, a traffic
sign may not be recognised or a traffic
sign
different from the actual
traffic
sign may be displayed. Always make it
your responsibility as a driver to check
the actual traffic signs. Otherwise, it
could result in an accident.
NOTE
The ISA operates only when the
navigation system's SD card (Mazda
genuine) is inserted. In addition, the
Adjustable Speed Limiter (ASL)
operates only when the navigation
system's SD card (Mazda genuine) is
not inserted. Refer to Adjustable
Speed Limiter (ASL) on page 4-166.
The system consists of the ISA display
and the speed limiter switch on the
steering wheel.

Multi-information display (Basic
display)
1. set vehicle speed

When Driving
i-ACTIVSENSE
4-170*Some models.

¾Do not apply a sticker to a rear
ultrasonic sensor and rear camera.
Otherwise, the rear ultrasonic
sensor and rear camera may not be
able to detect vehicles or
obstructions which could result in
an accident.
¾Do not disassemble a rear
ultrasonic sensor and rear camera.
¾If cracks or damage caused by
flying gravel or debris is visible
around a rear ultrasonic sensor and
rear camera, stop using the SBS-R
system immediately and have your
vehicle inspected by an expert
repairer (we recommend an
Authorised Mazda Repairer). If the
vehicle continues to be driven with
cracks or scratch marks left around
an ultrasonic sensor, the system
may operate unnecessarily and
cause an unexpected accident.
Refer to Stopping the Smart Brake
Support [Rear] (SBS-R) System
Operation on page 4-180.
¾Consult an expert repairer (we
recommend an Authorised Mazda
Repairer) for rear bumper
replacement.
Do not modify the suspension:
If the vehicle height or inclination is
changed, the SBS-R system may not
operate correctly because it cannot
detect obstructions correctly.
Do not apply a strong force to a rear
ultrasonic sensor and rear camera:When washing the vehicle, do not
spray highly pressurised water against a
rear ultrasonic sensor and rear camera,
or rub it strongly. In addition, do not
hit the rear bumper forcefully when
loading and unloading cargo.
Otherwise, the sensors may not detect
obstructions correctly which could
cause the SBS-R system to not operate
normally, or it could operate
unnecessarily.
CAUTION
¾When driving off-road in areas where
there is grass or foliage, it is
recommended that the SBS-R system
be turned off.
¾Always use tyres of the specified size
and the same manufacturer, brand,
and tread pattern on all 4 wheels. In
addition, do not use tyres with
significantly different wear patterns
on the same vehicle. Otherwise, the
SBS-R system may not operate
normally.
¾If ice or snow is stuck on the rear
ultrasonic sensor and rear camera
they may not be able to detect
obstructions correctly depending on
the conditions. In such cases, the
system may not be able to perform
controls correctly. Always drive
carefully and pay attention to the
rear of the vehicle.
NOTE
xThe vehicle posture changes
depending on the accelerator pedal,
brake pedal and steering wheel
operations, which could make it
difficult for the system to recognise
an obstruction, or it could facilitate
unnecessary detection. In such cases,
the
SBS-R may or may not operate.
When Driving
i-ACTIVSENSE
4-178

¾Consult an expert repairer (we
recommend an Authorised Mazda
Repairer) for repair, painting , or
replacement of the front/rear
camera, front bumper, liftgate and
door mirrors.
¾Heed the following cautions to
assure that the 360°View Monitor
operates normally.
¾Do not modify the vehicle
suspensions or lower/raise the
vehicle body, or both.
¾Always use tyres of the
specified
type and size for the front and rear
wheels. Consult an expert repairer
(we recommend an Authorised
Mazda Repairer) for tyre
replacement.
¾When the display is cold, images
may leave trails or the screen might
be darker than usual, making it
difficult to check the vehicle
surroundings. Always
confirm the
safety at the front and around the
vehicle visually when driving.
¾The method for parking/stopping
the vehicle using the 360°View
Monitor
differs depending on the
road circumstances/conditions and
the vehicle conditions. When and
how much you turn the steering
wheel will differ depending on the
situation, , therefore always check
the vehicle surroundings directly with
your eyes while using the system.
Also, before using the system, always
make sure that the vehicle can be
parked/stopped in the parking/
stopping space.NOTE
xIf there are water droplets, snow, or
mud on the camera lens, wipe it off
using a soft cloth. If the camera lens
is especially dirty, wash it off with
mild detergent.
xIf the camera lens is touched or there
is any dirt on it, it could affect the
screen image. Wipe the lens using a
soft cloth.
xIf the area where the camera is
installed, such as the front bumper,
liftgate or door mirrors, has been
damaged in a vehicle accident, the
camera (position, installation angle)
may have shifted. Always consult an
expert repairer (we recommend an
Authorised Mazda Repairer) to have
the vehicle inspected.
xIf the camera is subjected to
excessive changes in temperature
such as by pouring hot water on the
camera during cold weather, the
360°View Monitor may not operate
normally.
xIf the battery voltage is low, the
screen might be temporarily difficult
to view, however, this does not
indicate a problem.
xThe 360°View Monitor has
limitations. Objects under the
bumper or near both ends of the
bumper cannot be displayed.
xObstructions above the upper image
range of the camera are not
displayed.
xUnder the following conditions, the
screen might be difficult to view,
however this does not indicate a
problem.
xThe temperature near the lens is
high/low.
xRainy conditions, water droplets
on the camera, or high humidity.
xMud or foreign matter near the
camera.
When Driving
i-ACTIVSENSE
4-187

NOTE
The setting can be changed so that the projected vehicle path lines are not
displayed.
Refer to the Settings section in the Mazda Connect Owner's Manual.
How to use the projected vehicle path line function
1. (Screen display)
2. (Actual condition)

Make sure that there are no obstructions within the projected vehicle path lines.
Drive the vehicle forward while turning the steering wheel so that no obstructions
come within the projected vehicle path lines.
▼Top View/Front Wide View
Use the top view/front wide view to assist in checking the safety of the surrounding
area when accelerating from a stop or entering a
T- s h a p e d intersection and
intersection.
When Driving
i-ACTIVSENSE
4-198

Display/Icon Content
(3) Vehicle front end guide lines (blue) Indicates the point about 0.25 m (9.84 in) from the front
edge of the vehicle (front edge of the bumper).
NOTE
The setting can be changed so that the projected vehicle path lines are not
displayed.
Refer to the Settings section in the Mazda Connect Owner's Manual.
How to use the projected vehicle path line function
1. (Screen display)
2. (Actual condition)

Make sure that there are no obstructions within the projected vehicle path lines.
Turn the steering wheel so that the projected vehicle path lines travel inside of the
obstruction (A), and drive the vehicle forward until it passes the obstruction.
If the projected vehicle path lines are on an obstruction (B) or outside of the
obstruction (C), the vehicle may contact the obstruction when turning the vehicle
sharply.
CAUTION
¾The parking sensor detection range has limitations. For example, obstructions
closing in from the side and objects short in height may not be detected. Always
confirm the safety around the vehicle visually when driving.
When Driving
i-ACTIVSENSE
4-202

xBecause images displayed in the top view screen are processed from each camera,
the top view screen may display in the following ways.
xIf an image containing an object with a conspicuous colour is picked up by any
of the cameras, the screen area for each camera may be affected and it may
display in that colour.
xObstructions displayed in the rear view may not display on the top view screen.xIf the position or angle of each camera changes due to tilting of the vehicle, the
image may appear distorted.
xLines on the road may appear distorted at the seams where each of the camera
images merge.
xThe screen area for each camera may appear bright/dark depending on the
illumination level around any of the cameras.
Viewing the screen

Display/Icon Content
(1) Tyre icon Indicates the tyre direction. Moves in conjunction with
the steering wheel operation.
(2) Projected vehicle path lines (yellow
& red)Indicates the approximate projected path of the vehicle.
Moves in conjunction with the steering wheel operation.
a) Indicates the path where the edge of the rear bumper
is expected to travel.
b) Indicates the path where the outer side of the vehicle
is expected to travel.
(3) Extended vehicle width lines (blue) These guide lines indicate the approximate width of the
vehicle.
When Driving
i-ACTIVSENSE
4-204

Display/Icon Content
(4) Projected vehicle path distance
guide lines (yellow & red)These guide lines indicate the approximate distance to a
point measured from the rear of the vehicle (from the
end of the bumper).
xThe red line indicates the point about 0.5 m (19 in)
from the rear end of the bumper.
xThe yellow lines indicate the points about 1.0 m (39
in) and 2.0 m (78 in) from the rear end of the bumper.
NOTE
The setting can be changed so that the projected vehicle path lines are not
displayed.
Refer to the Settings section in the Mazda Connect Owner's Manual.
How to use the projected vehicle path line function
CAUTION
¾The front of the vehicle swings out wide when turning the steering wheel while
reversing. Maintain sufficient distance between the vehicle and an obstruction.
¾The parking sensor detection range has limitations. For example, obstructions
closing in from the side and objects short in height may not be detected. Always
confirm the safety around the vehicle visually when driving.
For details, refer to the parking sensor obstruction detection indication and
warning sound.
Refer to Parking Sensor System on page 4-252.
NOTE
xBecause there might be a difference between the image displayed on the screen,
such as indicated in the following , and the actual conditions when parking, always
check the safety at the rear of the vehicle and the surrounding area directly with
your eyes.
xEven though the back end of the parking space (or garage) displayed on the
screen and distance guide lines appear parallel, they may not actually be
parallel.
xWhen parking in a space with a division line on only one side of the parking
space, even though the division line and the vehicle width guide line appear
parallel, they may not actually be parallel.
xThe following shows an example of vehicle parking with the steering wheel turned
to the left while backing up the vehicle. When backing into a parking space from
the opposite direction, the steering operation is reversed.
When Driving
i-ACTIVSENSE
4-205