2019 MAZDA MODEL CX-30 change time

Rear Window Defogger
▼Rear Window Defogger
The rear window defogger clears fog
from the rear window.

The ignition must be switched ON to
use the defogger.

Press the switch to turn on the rear
window defogger. The rear window
defogger operates for about 15
minutes and then turns
off
automatically.
The indicator light illuminates when
the defogger is operating.

To t u r n
off the rear window defogger
before the 15 minutes has elapsed,
press the switch again.
1. Indicator light
CAUTION
¾Do not use sharp instruments or
window cleaners with abrasives to
clean the inside of the rear window
surface. They may damage the
defogger grid inside the window.
NOTE
xThis defogger is not designed for
melting snow. If there is an
accumulation of snow on the rear
window, remove it before using the
defogger.
xThe rear window defogger operation
time can be changed from 15
minutes to continuous operation.
When the operation time has been
switched to continuous operation,
by pressing the switch, the rear
window defogger will continue to
operate until the ignition is switched
OFF.
Refer to the Settings section in the
Mazda Connect Owner's Manual.
▼Windscreen Wiper De-icer*
The thermal filaments at the following
positions heat up and facilitate the
removal of snow accumulated on the
windscreen.
Left-Hand Drive Model
Right-Hand Drive Model
When Driving
Switches and Controls
4-66*Some models.

NOTE
If the ignition is switched OFF while
you have cancelled the system using
the i-ACTIVSENSE switch, the system is
automatically enabled the next time
the ignition is switched ON. However,
if the system is cancelled using the
personalisation features, the system is
not automatically enabled.Blind Spot Monitoring
(BSM)
*
▼Blind Spot Monitoring (BSM)
The BSM is designed to assist the driver
in checking the area to the rear of the
vehicle on both sides during lane
changes by notifying the driver of the
presence of vehicles approaching from
the rear in an adjacent lane.
BSM operation
The BSM detects vehicles approaching
from the rear while travelling in the
forward direction at a speed of 30
km/h (19 mph) or faster and notifies
the driver by turning on the BSM
warning indicator light and displaying
the vehicle detection screen.
If the direction indicator lever is
operated to signal a turn in the
direction in which the BSM warning
indicator light is illuminated while the
approaching vehicle is detected, the
BSM notifies the driver of possible
danger
flashing on the BSM warning
indicator light, and by activating the
warning sound and the warning screen
indicator display.
The detection area on this system
covers the driving lanes on both sides
of the vehicle and from the rear part of
the front doors to about 50 m (164 ft)
behind the vehicle.
1. Your vehicle
When Driving
i-ACTIVSENSE
4-106*Some models.

xA vehicle is in the detection area at
the rear in an adjacent driving lane
but it does not approach. The BSM
determines the condition based on
radar detection data.
xA vehicle is travelling alongside
your vehicle at nearly the same
speed for an extended period of
time.
xVehicles approaching in the
opposite direction.
xA vehicle in an adjacent driving
lane is attempting to pass your
vehicle.
xA vehicle is in an adjacent lane on
a road with extremely wide driving
lanes. The detection area of the
rear side radar sensor is set at the
road width of expressways.
xIn the following case, the flashing of
the BSM warning indicator light, and
the activation of the warning sound
and the warning screen indicator
display may not occur or they may be
delayed.
xA vehicle makes a lane change
from a driving lane two lanes over
to an adjacent lane.
xDriving on steep slopes.xCrossing the summit of a hill or
mountain pass.
xWhen there is a difference in the
height between your driving lane
and the adjacent lane.
xDirectly after the BSM system
becomes operable by changing the
setting.
xIf the road width is extremely
narrow, vehicles two lanes over may
be detected. The detection area of
the rear side radar sensor is set
according to the road width of
expressways.
xThe BSM warning indicator light may
turn on and the vehicle detection
screen may be displayed in the
display in reaction to stationary
objects (guardrails, tunnels,
sidewalls, and parked vehicles) on
the road or the roadside.
1. Objects such as guardrails and
concrete walls running alongside
the vehicle.

1. Places where the width between
guardrails or walls on each side of
the vehicle narrows.

When Driving
i-ACTIVSENSE
4-108

BSM warning indicator lights when
they turn on.
Refer to Instrument Panel Illumination
on page 4-27.
Display indicator
The detected approaching vehicle and
warning are displayed in the
multi-information display and active
driving display (vehicles with active
driving display).
Multi-information Display
Active Driving Display (vehicles with
active driving display)
The detected direction is displayed
with a detection indicator (white)
when an approaching vehicle is
detected. In addition, if the direction
indicator lever is operated to signal a
lane change while the vehicle is
detected, the display changes the
colour (amber) of the warning
indicator.
BSM warning beep
The BSM warning beep is activated
simultaneously with the flashing of a
BSM warning indicator light.
▼Cancelling Operation of Blind Spot
Monitoring (BSM)
The BSM system can be set to
inoperable.
x(If only the BSM is turned off)
Refer to the Settings section in the
Mazda Connect Owner's Manual.
x(If the BSM is turned
off by
operating the i-ACTIVSENSE switch)
Refer to i-ACTIVSENSE Switch on
page 4-97.
NOTE
If the ignition is switched OFF while
you have cancelled the system using
the i-ACTIVSENSE switch, the system is
automatically enabled the next time
the ignition is switched ON. However,
if the system is cancelled using the
personalisation features, the system is
not automatically enabled.
When Driving
i-ACTIVSENSE
4-110

4. Instrument cluster
5. Basic display
6. i-ACTIVSENSE display
7. Recognized speed limit indication colour changes.
Stop sign
1. Sign recognised and displayed at same time
2. Active driving display indication
3. Instrument cluster
WARNING
Always check the traffic signs visually while driving.
The TSR helps prevent the driver from overlooking traffic signs and provides support
for safer driving. Depending on the weather conditions or problems with traffic
signs, a traffic sign may not be recognised or a traffic sign different from the actual
traffic sign may be displayed. Always make it your responsibility as a driver to check
the actual traffic signs. Otherwise, it could result in an accident.
NOTE
xThe TSR is not supported in some countries or regions. For information concerning
the supported countries or regions, consult an expert repairer (we recommend an
Authorised Mazda Repairer).
xThe TSR operates only if the navigation system SD card (Mazda genuine) is
inserted in the SD card slot. Consult an expert repairer (we recommend an
Authorised Mazda Repairer) for details.
*
When Driving
i-ACTIVSENSE
4-112*Some models.

If the Forward Sensing Camera (FSC)
cannot classify an auxiliary sign (such
as time restrictions, turning
restrictions, end of section) correctly,
the following screen is displayed.
Inclement weather speed limit sign*
Do not enter signs
Stop signs
Passing prohibited sign*
The TSR can display a passing
prohibited sign and a speed limit sign
at the same time.
NOTE
Speed limit signs (including auxiliary
signs)
xWhen the vehicle speed is about 1
km/h (0.6 mph) or faster, the speed
limit sign is displayed when any one
of the following conditions are met.
xThe Forward Sensing Camera (FSC)
recognises a speed limit sign as a
sign targeted for your vehicle and
the vehicle passes it.
xThe speed limit sign stored in the
navigation system is read.
xInclement weather speed limit signs
are displayed when all of the
following conditions are met.
xThe vehicle speed is about 1 km/h
(0.6 mph) or more.
xThe Forward Sensing Camera (FSC)
recognises an inclement weather
speed limit sign as a sign targeted
for your vehicle and the vehicle
passes it.
xThe inclement weather speed limit
sign is lower than the currently
displayed speed limit sign.
xThe windscreen wipers are
operated.
xIn the following cases, display of the
speed limit sign stops.
xEach sensor determines that the
vehicle has changed direction of
travel. (The display of a speed limit
sign does not stop even if the
vehicle changes lanes while a
"ZONE" auxiliary sign is
displayed.)
xThe Forward Sensing Camera (FSC)
recognises a new speed limit sign
which
differs from the previous
one (displays the new speed limit
sign).
xThe speed limit sign stored in the
navigation system is not read
within a certain period of time (if
the Forward Sensing Camera (FSC)
does not recognise a speed limit
sign, the speed limit sign stored in
the navigation system is displayed).
xThe vehicle speed exceeds the
displayed speed limit sign by 30
km/h (19 mph) or more after a
certain period of time has elapsed
since the speed limit sign was
displayed. (Except when there is
information for the speed limit sign
in the navigation system)
When Driving
i-ACTIVSENSE
4-114*Some models.

▼Excessive Speed Warning
If the vehicle speed exceeds the speed limit sign displayed in the active driving
display/instrument cluster, the area around the speed limit sign flashes in amber and
the warning sound is activated at the same time. If the vehicle speed continues to
exceed the displayed speed limit sign, the indication stops flashing and remains on.
Check the surrounding conditions and adjust the vehicle speed to the legal speed
using the appropriate operation such as depressing the brake pedal.
1. Vehicle is doing 90 km/h when 80 km/h speed limit sign is recognised.
2. Vehicle continues to do 90 km/h after 80 km/h speed limit sign is passed.
3. Active driving display indication
4. Instrument cluster

The excessive speed warning is initially set to visual only. If you want to activate the
excessive speed warning , change the setting in the personalisation features. In
addition, the warning pattern and the warning activation timing differ depending on
the setting contents.
Refer to the Settings section in the Mazda Connect Owner's Manual.
Speed Limit Sign Alert setting
xOff: The excessive speed warning is not activated.xVisual: The area around the speed limit sign displayed in the display
flashes in
amber, and if the vehicle speed continues to exceed the displayed speed limit
sign, the indication stops
flashing and remains on.
xVisual + Audible: The area around the speed limit sign displayed in the display
flashes in amber and the warning sound is activated at the same time. If the
vehicle speed continues to exceed the displayed speed limit sign, the indication
When Driving
i-ACTIVSENSE
4-116

stops flashing and remains on. The warning sound is activated continuously until
the vehicle speed decreases below the speed limit sign.
Speed Limit Sign Threshold setting
x+ 0: If the vehicle speed exceeds the speed limit sign displayed in the display, the
excessive speed warning is activated.
x+ 5: If the vehicle speed exceeds the speed limit sign displayed in the display by 5
km/h (3 mph), the excessive speed warning is activated.
x+ 10: If the vehicle speed exceeds the speed limit sign displayed in the display by
10 km/h (5 mph), the excessive speed warning is activated.
NOTE
xIn the following cases, the excessive speed warning stops operating.
xThe vehicle speed is less than the speed of the displayed speed limit sign. (If the
activation timing for the excessive speed warning is changed in the
personalisation features, the excessive speed warning stops operating when the
vehicle speed is less than the changed vehicle speed.
xA speed limit sign indication has been updated and the vehicle speed is lower
than the updated indication.
xDisplay of the speed limit sign stops.xThe warning indication is displayed at the same time the excessive speed warning
sound is activated if the vehicle speed exceeds the speed indicated on the speed
limit sign.
Refer to Excessive Speed Warning on page 7-72.
xIf the Forward Sensing Camera (FSC) or data recorded in the navigation system
incorrectly recognises the actual speed limit sign at a lower speed, the excessive
speed alarm is activated even if the vehicle is driven at the legal speed.
When Driving
i-ACTIVSENSE
4-117