2019 MAZDA MODEL CX-30 Headlight

Signal Indicator Refer to
Wrench Indication/Indicator Light*14-37
Glow Indicator Light
(SKYACTIV-D 1.8) 4-38
*Shift Position Indication4-46
Lights-On Indicator Light 4-54
Headlight High-Beam Indicator LightHeadlight
High-Low
Beam
4-57
Flashing the
Headlights
4-57
*Rear Fog Light Indicator Light4-59
Direction Indicator/Hazard Warning Indicator LightsTurn and
Lane-Change
Signals
4-60
Hazard Warn-
ing Flasher
4-68
Electric Parking Brake (EPB) Indication/Indicator Light*1*27-52
AUTOHOLD Active Indicator Light*14-76
*Mazda Radar Cruise Control with Stop & Go function (MRCC with
Stop & Go function) indicator Light4-147
*Cruising &
Tra ffi c Support (CTS) Indicator Light4-161
When Driving
Instrument Cluster and Display
*Some models.4-35

Signal Indicator Refer to
TCS/DSC Indication/Indicator Light*1
Tra c t i o n C o n -
trol System
(TCS)
4-81
Dynamic Sta-
bility Control
(DSC)
4-83
Tu r n s o n
7-55
*TCS OFF Indicator Light*14-82
*Off-Road Traction Assist Indicator Light (AWD) *14-84
*Select Mode Indicator Light4-91
(White)
i-ACTIVSENSE Status Symbol (Warning/Risk Avoidance Support Sys-
tem)4-96
(Green)
(Amber)
i-ACTIVSENSE OFF Symbol (Warning/Risk Avoidance Support Sys-
tem)4-96
(Green)
*High Beam Control System (HBC) Indicator Light4-100
*Adaptive LED Headlights (ALH) Indicator Light4-102
(White)
*Mazda Radar Cruise Control (MRCC) Standby Indication4-134
*Mazda Radar Cruise Control with Stop & Go function (MRCC with
Stop & Go function) Standby Indication4-143
*Cruising &
Tra ffi c Support (CTS) Standby Indication4-154
When Driving
Instrument Cluster and Display
4-36*Some models.

Lighting Control
▼Headlights
Turn the headlight switch to turn the headlights and other exterior lights on or off.
When the tail lights, position lights, and the number plate lights are turned on, the
lights-on indicator light in the instrument cluster turns on.

NOTE
xTo prevent discharging the battery, do not leave the lights on while the engine is
off unless safety requires them.
xHeadlights do not blind drivers approaching in the opposite direction no matter
what side of the road you must drive your vehicle (left-hand or right-hand traffic).
Therefore, it is not necessary to adjust the optical axis of the headlights when
switching temporarily to driving on the opposite side of the road (left-hand or
right-hand traffic).
Without auto-light control
Ignition Position ACC or OFF ON
Switch Position OFF
OFF
Headlights Off Off Off Off Off On
Running lights
*Off Off Off
On*1On*1*2Off
Tail lights
Position lights
Number plate
lightsOffOn
Off OffOn On
When Driving
Switches and Controls
4-54*Some models.

*1 When the light switch is switched to a
different position from the OFF, position while the
vehicle is stopped, the running lights turn off. When starting to drive the vehicle, the running lights
turn on again.
*2 When the light switch is switched to the OFF position, and then to the position again, the
running lights turn off directly after starting the engine. The running lights turn on when you begin
driving the vehicle.
With auto-light control
Ignition Position ACC or OFF ON
Switch Position
OFF
*1AUTOOFF*1AUTO
Headlights Off Off Off Off
Auto
*2*4Auto*3*4
On
Running lights
*Off Off Off Off Off
Ta i l l i g h t s
Po s i t i o n l i g h t s
Number plate
lightsOff Off On Off On
*1 The light switch returns to the AUTO position automatically.*2 During the daytime, the running lights turn on automatically. During the nighttime, the headlights,
position lights, tail lights, and the number plate lights turn on automatically.
*3 During the daytime, the running lights, position lights, tail lights, and the number plate lights turn on
automatically. During the nighttime, the headlights, position lights, tail lights, and the number plate
lights turn on automatically.
*4 When the light switch is switched to the OFF position while the vehicle is stopped, all of the lights
that are turned on turn off. When the light switch is switched from a position other than
to the
position while the vehicle is stopped, the running lights or the headlights turn off. When
starting to drive the vehicle, the lights that are turned
off turn on again.
NOTE
The running lights can be disabled using the personalisation features (page 4-58).
When Driving
Switches and Controls
*Some models.4-55

Auto-light control*
When the headlight switch is in a position other than and the ignition is
switched ON, the light sensor senses the surrounding lightness or darkness and
automatically turns the headlights and other exterior lights on or off.
CAUTION
¾Do not shade the light sensor by adhering a sticker or a label on the windscreen.
Otherwise the light sensor will not operate correctly.
¾The light sensor also works as a rain sensor for the auto-wiper control. Keep hands
and scrapers clear of the windscreen when the wiper lever is in the AUTO position
and the ignition is switched ON as fingers could be pinched or the wipers and
wiper blades could be damaged when the wipers activate automatically. If you are
going to clean the windscreen, be sure the wipers are turned
off completely when
it is particularly tempting to leave the engine running. This is particularly important
when clearing ice and snow.
NOTE
xThe headlights and other exterior lights may not turn off immediately even if the
surrounding area becomes well-lit because the light sensor determines that it is
night time if the surrounding area is continuously dark for several minutes such as
inside long tunnels, traffic jams inside tunnels, or in indoor parking lots.
xThe sensitivity of the auto-light control may be changed.
Refer to the Settings section in the Mazda Connect Owner's Manual.
When Driving
Switches and Controls
4-56*Some models.

▼Headlight High-Low Beam
The headlights switch between high
and low beams by moving the lever
forward or backward.

1. High beam
2. Low beam

When the headlight high-beams are
on, the headlight high-beam indicator
light is turned on.

▼Flashing the Headlights
The headlights can be flashed with the
ignition switched to ON.
To flash the headlights, pull the lever
fully towards you (the headlight switch
does not need to be on).

1. OFF
2. Headlight flashing

The headlight high-beam indicator
light in the instrument cluster
illuminates simultaneously. The lever
will return to the normal position when
released.

▼Coming Home Light
The coming home light turns on the
headlights (low beams) when the lever
is operated.
To turn on the lights
When the lever is pulled with the
ignition switched to ACC or OFF, the
low beam headlights turn on.
The headlights turn off after a certain
period of time has elapsed after all of
the doors are closed.
NOTE
xThe time until the headlights turn off
after all of the doors are closed can
be changed.
Refer to the Settings section in the
Mazda Connect Owner's Manual.
xIf no operations are done for 3
minutes after the lever is pulled, the
headlights turn off.
xThe headlights turn off if the lever is
pulled again while the headlights are
illuminated.
▼Leaving Home Light
The leaving home light turns on the
lights when the transmitter unlock
button is pressed while away from the
vehicle.
When Driving
Switches and Controls
4-57

The following lights turn on when the
leaving home light is operated.
Low beams, Position lights, Tail lights,
Number plate lights.
To turn on the lights
When the ignition switch and the
headlight switch are in the following
conditions, the headlights will
illuminate when the transmitter unlock
button is pressed and the vehicle
receives the transmitter signal. The
headlights turn off after a certain
period of time has elapsed (30
seconds).
xIgnition switch: off
xHeadlight switch: AUTO, , or
1. Lock button
2. Unlock button
NOTE
xOperation of the leaving home light
can be turned on or
off.
Refer to the Settings section in the
Mazda Connect Owner's Manual.
xWhen the transmitter lock button is
pressed and the vehicle receives the
transmitter signal, the headlights turn
off.
xWhen the headlight switch is turned
to the OFF position, the headlights
turn off.
▼Headlight Levelling
The number of passengers and weight
of cargo in the luggage Compartment
change the angle of the headlights.
The angle of the headlights will be
automatically adjusted when turning
on the headlights.
A system malfunction or operation
conditions are indicated by a warning.
Refer to Exterior Light Warning
Indication/Warning Light on page
7-58.
▼Running Lights*
Some countries require moving
vehicles to have their lights on (running
lights) during the daytime.

The running lights turn on or off
automatically.

NOTE
(Except countries prohibited by law)
The running lights can be deactivated.
Refer to the Settings section in the
Mazda Connect Owner's Manual.
When Driving
Switches and Controls
4-58*Some models.

Rear Fog Light*
▼Rear Fog Light
The rear fog light can be used when
the ignition is switched ON.
The rear fog light helps your vehicle to
be seen.
The headlights must be turned on to
turn on the rear fog light.

To turn the rear fog light on, rotate the
fog light switch to the
position (the
fog light switch returns to its original
position automatically).

1. Fog light switch
The rear fog light indicator light in the
instrument cluster illuminates while the
rear fog light is on.

To turn the rear fog light
off, do any of
the following:
xRotate the fog light switch to the
position again (the fog light switch
returns to its original position
automatically).
xTurn the headlight switch to the OFF
position.
The rear fog light indicator light in the
instrument cluster goes off when the
rear fog light is turned off.
NOTE
While the position lights are turned on,
the rear fog light remains on even if the
headlights are turned off. The rear fog
light turns off when the position lights
turn off.
When Driving
Switches and Controls
*Some models.4-59