2019 JEEP GRAND CHEROKEE LIMITED height

7. Store sensor and bracket in a safe place.
NOTE:All cruise control functions will be disabled when
the radar sensor is disconnected.
Radar Sensor Installation Procedure (If Equipped With
Adaptive Cruise Control [ACC]):
1. Disconnect the wiring harness connector from the pro- tective connector on the bumper beam.
2. Remove plug from radar sensor and install in protective connector.
3. Using the previously scribed marks, reinstall the radar sensor and bracket using the two fasteners.
NOTE: Some alignment may be required upon fascia
installation to align sensor with fascia.
4. Install the wiring harness connector into the radar sensor.
NOTE: If you receive a fault, see your authorized dealer
they may need to perform a sensor alignment.
Lower Front Fascia Installation
NOTE: This will only work if you have a helper. 1. Starting at the center of the vehicle, engage a sufficient
number of tabs to support the weight of the lower fascia
(typically one or two tabs) into the upper fascia.
2. Working your way outward, engage the tabs into the slots on one side of the vehicle.
3. Return to the center of the vehicle and repeat Step 2 to the opposite side of the vehicle.
NOTE: •It may be necessary to apply additional force to
individual tabs to make sure they are fully engaged.
• Do not use any tools to apply additional force to the
tabs as damage to the upper and lower fascias may
result.
4. Reinstall the seven quarter turn fasteners.
Quadra-Lift — If Equipped
When off-roading, it is recommended that the lowest
useable vehicle height that will clear the current obstacle or
terrain be selected. The vehicle height should then be
raised as required by the changes in terrain.
6
STARTING AND OPERATING 385

The Selec-Terrain switch will automatically change the
vehicle to the optimized height based on the Selec-Terrain
switch position. The vehicle height can be changed from
the default height for each Selec-Terrain mode by normal
use of the air suspension switches. Refer to “Four Wheel
Drive Operation” in “Starting And Operating” for further
information.
When To Use 4WD LOW Range — If Equipped
When off-road driving, shift to 4WD LOW for additional
traction. This range should be limited to extreme situations
such as deep snow, mud, or sand where additional low
speed pulling power is needed. Vehicle speeds in excess of
25 mph (40 km/h) should be avoided when in 4WD LOW
range.

Setting NameSelectable Options
Headlight Off Delay 0 sec30 sec 60 sec 90 sec
NOTE:
When the “Headlight Off Delay” feature is selected, it allows the adjustment of the amount of time the headlights
remain on after the engine is shut OFF. Easy Exit Seat — If Equipped On
Off
NOTE:
When the “Easy Exit Seat” feature is selected, it provides automatic driver seat positioning to enhance driver mobility
when entering and exiting the vehicle. Auto Entry/Exit — If Equipped On
Off
NOTE:
The “Auto Entry/Exit” feature automatically lowers the vehicle ride height position when shifted into PARK, when it
is selected.
10
MULTIMEDIA 527

OFF ROAD PAGES — IF EQUIPPED
Your vehicle is equipped with Off Road Pages, which
provides the vehicle status while operating on off road
conditions. It supplies information relating to the vehicle
ride height, the status of the transfer case, the pitch and roll
of the vehicle (if equipped), and the active Selec-Terrain
mode.
To access Off Road Pages, press the “Apps” button on the
touchscreen, and then select “Off Road Pages”.Off Road Pages has the following selectable pages:
•Vehicle Dynamics
• Suspension
• Pitch and Roll — If Equipped

Suspension
The Suspension page displays information concerning the
vehicle’s suspension.
The following information is displayed:
•Suspension Articulation Indicator
• Current Ride Height Status — If Equipped
• Normal
• Off Road 1
• Off Road 2
• Entry/Exit
• Aero
NOTE: The wheel articulation will be represented by a
yellow color in the Suspension Articulation Indicator. If
Ride Height is adjusted, the Ride Height indicator on the
screen will switch to the appropriate height and the
Suspension Articulation Indicator will show the movement
and change in height.