2019 HONDA ACCORD HYBRID sensor

214 uu Adjusting the Seats u Rear Seats
Controls Rear Seats 1. Remove the center shoulder belt from the
guide.
2. Pull the release lever in the trunk to release
the lock.
3. Fold the seat-back down.■ Folding Down the Rear Seat(s) 1 Folding Down the Rear Seat(s)
The rear seat-back(s *
) can be folded down to
accommodate bulkier items in the trunk.
Never drive with the seat-back folded down and the
trunk lid open.
2 Exhaust Gas Hazard P. 75
To lock a seat-back upright, push it backwards until it
locks.
When returning the seat-back to its original position,
push it firmly back. Also, m ake sure all rear shoulder
belts are positioned in front of the seat-back, and the
center shoulder belt is re -positioned in the guide.
Make sure that the folded seat-back does not press
against the front passenger se at, as this can cause the
weight sensors in the front passenger seat to work
improperly.
2 Passenger Front Airbag Off Indicator P. 59
Make sure all items in the trunk or items
extending through the opening into the rear
seat is properly secured. Loose items can fly
forward if you have to brake hard.
The front seat(s) must be far enough forward so they
do not interfere with the rear seats as they fold
down.Guide
Center
Shoulder Belt
Release
Lever
Release
Lever *
* Not available on all models

241uu Climate Control System u Using Automatic Climate Control
Controls
You can set the temperature synchronously for the driver side and the passenger
side in synchronization mode.
1. Press the SYNC button.
u The system will switch to the synchronization mode.
2. Adjust the temperature using driver ’s side temperat ure control dial.
Press the SYNC button or adjust the interior temp erature using the passenger’s side
control dial to return to dual mode.■ Synchronization Mode 1 Synchronization Mode
When you press the button, the system changes
to synchronization mode.
When the system is in dua l mode, the driver side
temperature and the passenger side temperature can
be set separately.
The system adjusts each temperature based on the
information of the sunli ght sensor and the sun
position updated by the navigation system.Models with navigation system

242 uu Climate Control System u Automatic Climate Control Sensors
Controls Automatic Climate Control Sensors The automatic climate control system is
equipped with sensors. Do not cover or spill
any liquid on them.Sensor
Sensor

453Driving This chapter discusses driving and refueling.
Before Driving ................................... 454
Towing a Trailer ................................ 459
When Driving
Starting the Engine .......................... 465
Precautions While Driving................. 473
Automatic Transmission *
/Continuously
Variable Transmission *
................... 474
Shifting .................... 475, 482, 484, 488
SPORT Mode *
.................................. 491
ECON Button ................................... 492
Adaptive Damper System *
............... 493
Vehicle Stability Assist ® (VSA ® ), aka
Electronic Stability Control (ESC),
System.......................................... 494 Agile Handling Assist ............................. 496 Tire Pressure Monitoring System (TPMS)..... 497
Tire Pressure Monitoring System (TPMS) -
Required Federal Explanation ......... 500
Blind spot information System *
........... 502
LaneWatch TM
*
.................................. 505
Honda Sensing ® ................................ 507
Collision Mitigati on Braking System TM

(CMBS TM
) ....................................... 510
Adaptive Cruise Control (ACC) with Low
Speed Follow (LSF) *
....................... 519
Adaptive Cruise Control (ACC) *
....... 535
Lane Keeping Assist System (LKAS).... 550 Road Departure Mi tigation (RDM)
System ........................................ 558
Traffic Sign Recognition System ....... 562
Front Sensor Camera ....................... 568
Radar Sensor ................................... 570
Braking
Brake System ................................... 571
Anti-lock Brake System (ABS) ........... 581
Brake Assist System ......................... 582
Parking Your Vehicle ........................ 583
Multi-View Rear Camera .................. 594
Refueling ........................................... 597
Fuel Economy and CO 2
Emissions .... 600
Turbo Engine Vehicle ....................... 601
* Not available on all models

456 uu Before Driving u Driving Preparation
Driving • Be sure items placed on the floor behind the front seats cannot roll under the
seats.
u They can interfere with the driver’s ability to operate the pedals, the operation
of the seats, or the operation of the sensors under the seats.
• Everyone in the vehicle must fasten their seat belt.2 Fastening a Seat Belt P. 41
• Make sure that the indicators in the ins trument panel come on when you start the
vehicle, and go off soon after.
u Always have a dealer check the ve hicle if a problem is indicated.2 Indicators P. 78

502 uu When Driving u Blind spot information System *
Driving Blind spot information System *Is designed to detect vehicles in specified alert zones adjacent to your vehicle,
particularly in harder to see area s commonly known as “blind spots.”
When the system detects vehi cles approaching from behind in adjacent lanes, the
appropriate indicator comes on for a few seconds, providing assistance when you
change lanes.
■ How the system works 1 Blind spot information System *
Important Safety Reminder
Like all assistance systems, the blind spot information
system has limitations. Over reliance on the blind spot
information system may result in a collision.
The blind spot information system alert indicator may
not come on under the following conditions:
• A vehicle does not stay in the alert zone for more
than two seconds.
• A vehicle is parked in a side lane.
• The speed difference betw een your vehicle and the
vehicle you are passing is greater than 6 mph (10
km/h).
• An object not detected by the radar sensors
approaches or passes your vehicle.
• A vehicle running in the adjacent lane is a
motorcycle or other small vehicle.3
WARNING Failure to visually confirm that it is safe to
change lanes before doing so may result in
a crash and serious injury or death.
Do not rely only on the blind spot
information system wh en changing lanes.
Always look in your mi rrors, to either side
of your vehicle, and behind you for other
vehicles before changing lanes.
Alert zone range
A: Approx. 1.6 ft. (0.5 m)
B: Approx. 10 ft. (3 m)
C: Approx. 10 ft. (3 m) Radar Sensors:
underneath the
rear bumper
corners Alert Zone
A
B
C●
Your vehicle speed is
between 20 mph (32 km/h)
and 100 mph (160 km/h). ●
The transmission is in ( D
.Automatic transmission/
Continuously variable
transmission models
* Not available on all models

Continued
503uu When Driving u Blind spot information System *
Driving
■ When the system detects a vehicle
Blind spot information System Alert Indicator:
Located on the outside rearview mirror on
both sides.
Comes on when:
• A vehicle enters the alert zone from behind
to overtake you with a speed difference of
no more than 31 mph (50 km/h) from your
vehicle.
• You pass a vehicle with a speed difference
of no more than 12 mph (20 km/h).
Blinks and a beeper sounds when:
You move the turn signal lever in the direction
of the detected vehicle. The beeper sounds
three times. 1 Blind spot information System *
The system is for your convenience only. Even if an
object is within the alert zone, the following
situations may occur.
• The blind spot informatio n system alert indicator
may not come on due to obstruction (splashes,
etc.) even without the Blind Spot Information
System Not Available driver information
interface appearing.
• The blind spot informatio n system alert indicator
may come on even with the message appearing.
You can change the setting for the blind spot
information system.
2 Customized Features P. 381
The system does not operate when in ( R
.
Turn the system off when towing a trailer.
The system may not work properly for the following
reasons:
• The added mass tilts the vehicle and changes the
radar coverage.
• The trailer itself can be detected by the radar
sensors, causing the blind spot information system
alert indicators to come on. Automatic transmission/Continuously variable
transmission models
2.0 L engine modelsComes On
Blinks
* Not available on all models

uu When Driving u Blind spot information System *
504
Driving ■ Blind spot information System On and Off
When you turn the blind spot information
system on and off, do the following.
1. Press the safety support switch.
2. Roll the left selector wheel to the
symbol and push it.
The blind spot information system is in the
previously selected ON or OFF setting each
time you start the engine. 1 Blind spot information System *
The blind spot information system may be adversely
affected when:
• Objects (guard rails, poles, trees, etc,.) are
detected.
• An object that does not re flect radio waves well,
such as a motorcycle, is in the alert zone.
• Driving on a curved road.
• A vehicle is moving from a far lane to the adjacent
lane.
• The system picks up external electrical interference.
• The rear bumper or the sensors have been
improperly repaired or the rear bumper has been
deformed.
• The orientation of the sensors has been changed.
• In bad weather (Heavy rain, snow, and fog).
• Making a turn at an intersection.
• Driving on a bumpy road.
• Making a short turn that slightly tilts the vehicle.
For proper the blind spot information system
operation:
• Always keep the rear bumper corner area clean.
• Do not cover the rear bumper corner area with
labels or sticke rs of any kind.
• Take your vehicle to a dealer if you need the rear
bumper corner area or th e radar sensors to be
repaired, or the rear bumper corner area is strongly
impacted.Left Selector Wheel
Safety Support Switch
* Not available on all models