2018 YAMAHA WOLVERINE low beam

Parking brake ..................................... 8-42
Brake light switch adjustment ............ 8-42
Cable inspection and lubrication........ 8-43
Brake pedal and accelerator pedal lubrication ......................................... 8-43
Checking the stabilizer bushes .......... 8-44
Rear knuckle upper and lower pivot lubrication (left and right) .................. 8-45
Steering shaft lubrication ................... 8-45
Wheel removal.................................... 8-45
Tire replacement ................................ 8-46
Wheel installation ............................... 8-47
Battery ................................................ 8-47
Jump-starting ..................................... 8-51
Fuse replacement............................... 8-52
Replacing a headlight bulb................. 8-54
Headlight beam adjustment ............... 8-56
Tail/brake light bulb replacement ....... 8-57
Troubleshooting ................................. 8-57
Troubleshooting charts ...................... 8-59
CLEANING AND STORAGE .................... 9-1 Cleaning ............................................... 9-1 Storage .................................................9-2
SPECIFICATIONS..................................10-1
CONSUMER INFORMATION ................11-1 Identification number records.............11-1
INDEX ....................................................12-1
UB3D7AE0.book Page 3 Tuesday, November 7, 2017 9:38 AM

4-11
4
EBU31391Light switch “ / / ”Set the switch to “ ” to turn on the low
beam and the taillights.
Set the switch to “ ” to turn on the high
beam and the taillights.
Set the switch to “ ” to turn off the head-
lights and taillights.NOTICEECB02061Do not use the headlights with the engine
turned off for an extended period of time.
The battery may discharge to the pointthat the electric starter will not have
enough power to crank the engine. If this
should happen, remove the battery and re-
charge it.
EBU31402On–Command drive knob
“2WD/4WD/DIFF LOCK”Stop the vehicle and move the On–Command
drive knob to change the drive mode to two–
wheel drive, four–wheel drive, or four–wheel
1. Light switch “ / / ”
L
H
1
L
HLH
1. On-Command drive knob “2WD/4WD/DIFF LOCK”
1
UB3D7AE0.book Page 11 Tuesday, November 7, 2017 9:38 AM

8-56
8
clean off any dirt and fingerprints us-
ing a cloth moistened with alcohol or
thinner.
[ECB00653]
7. Connect the headlight coupler.
8. Install the bulb cover and the cover at therear of the headlight. NOTICE: Make
sure the headlight bulb cover is se-
curely fitted over the bulb holder and
seated properly.
[ECB02210]
9. Adjust the headlight beam if necessary.
EBU32681Headlight beam adjustmentNOTICEECB00691It is advisable to have a Yamaha dealer
make this adjustment. To raise the beam, tu rn the headlight beam
adjusting screw in direction (a).
To lower the beam, turn the headlight beam
adjusting screw in direction (b).
1. Do not touch the glass part of the bulb.
1
1. Headlight beam adjusting screw
1
(a)
(b)
UB3D7AE0.book Page 56 Tuesday, November 7, 2017 9:38 AM