Page 5 of 33

3
Seating
Getting  
Started
10-Way Power Driver’s Seat (if equipped)
1. Forward/Backward,   
Angle and Height  
 
Move the switch toward the front 
or rear to move the seat forward 
or backward. Pull the switch up 
or push down on the front of the 
switch to adjust the angle of the 
seat cushion. Pulling the switch 
straight up or pushing the switch 
straight down will adjust the height 
of the entire seat cushion. 2. Seatback
 
  Move the switch in the 
corresponding direction to adjust 
the angle of the seatback.
3. Lumbar Support  
  Press the front part of the switch 
to increase lumbar support; 
press the rear part of the switch 
to decrease lumbar support.
3
2
1
Memory Driver’s Seat (if equipped)
While pressing the “SET” button, press and hold the desired button “1” or “2”. 
A beep sounds when the seat position is registered. Press button “1” or “2” to 
retrieve the seat positions.
2926965_18a_Subaru_Legacy_QRG_050417.indd   35/4/17   3:12 PM
Getting  
StartedInstrument  
Panel Gauges
Personalize ControlsWhile  
Operating Safety/In Case 
of Emergency Additional  
Information  
         
        
        
     
        
        Page 6 of 33
4
Heated Seats (if equipped)
Press the front seat heater switch. Each time you press the switch, the mode will change as 
follows: High, Mid, Low, Off.
Seat Controls 
1.  Forward/Backward 
Pull up on the lever below the front 
of the driver’s seat to move the seat 
forward or backward.
2.   Raise/Lower  Seat Cushion 
To adjust the height of the driver’s seat, 
pull up or push down the seat height 
adjustment lever, located on the lower 
left front of the seat.
3. Recline Seatback  To adjust the seatback to the desired position, pull up on the recline lever, located on the 
lower left rear of the driver’s seat or lower right rear of the passenger’s seat. Do not adjust 
seats while driving.
Seating
1
23
2926965_18a_Subaru_Legacy_QRG_050417.indd   45/4/17   3:12 PM 
         
        
        
     
        
        Page 14 of 33
12
Personalize
Heated Steering Wheel (if equipped)
To activate, pull the Heated Steering Wheel switch while the ignition is \
in the ON position. 
The indicator light on the switch will illuminate.
To deactivate, pull the Heated Steering Wheel switch again.
Tilt and Telescopic Steering Column
Push the lever down firmly to adjust the height and lengthwise positio\
n of the column; firmly 
push the lever back up to lock the column in place. Do not adjust while \
driving.
2926965_18a_Subaru_Legacy_QRG_050417.indd   125/4/17   3:13 PM