Page 19 of 33

17
122
3
457
89106
Dual Zone Automatic Climate Control System (if equipped)
1. Automatic On and Off This system automatically controls 
outlet air temperature, fan speed, air 
flow distribution, air inlet control, and 
air conditioner compressor operation. 
Press “AUTO” to activate. Press 
“OFF” to turn off the system.
2. Temperature Control Dial  Rotate the dial clockwise to increase 
the temperature or rotate the dial 
counterclockwise to decrease the 
temperature. The temperature is 
displayed digitally on the screen. 
  Separate temperature settings can 
be adjusted for the driver’s side and 
passenger’s side.
3. SYNC Button  Press the button to synchronize both 
the driver’s side and passenger’s side 
temperatures using the driver’s side 
temperature control.
Operation in Manual Mode
4. Air Conditioner Button Press the “A/C” button to activate 
the air conditioning. Press it again to 
turn off the air conditioning.
5. MAX Air Conditioner Button  For quicker cooling, press the MAX 
A/C button.  6.  
Air Flow Mode Selection Button 
Press the button to select the 
desired air flow mode. The selected 
air flow mode – either ventilation, 
bi-level, heat, heat-defrost or  
defrost – is shown on the display.
 7.   Fan Speed Control Buttons 
Press the fan speed control buttons 
to select the desired fan speed.
 8.    Recirculated/Outside Air Button 
Press the air inlet selection button to 
prevent outside air from being drawn 
into the passenger compartment. 
Press the button again to allow 
outside air into the compartment. 
TO PREVENT WINDSHIELD 
FOGGING, DO NOT REMAIN IN 
THE RECIRCULATED MODE FOR 
AN EXTENDED PERIOD OF TIME. 
 9.    Defroster Button 
Press the button to defrost or 
dehumidify the windshield and front 
door windows.
10.    Rear Window Defogger Button 
Press the button to turn on the 
defogger. It will automatically shut 
off after about 15 minutes. If the 
window clears before that time, you 
can press the button again to turn 
it off. 
Controls
2926965_18a_Subaru_Legacy_QRG_050417.indd   175/4/17   3:13 PM
Getting  
StartedInstrument  
Panel Gauges
Personalize ControlsWhile  
Operating Safety/In Case 
of Emergency Additional  
Information   
         
        
        
     
        
        Page 20 of 33
18
Controls
Power Moonroof (if equipped)
With the moonroof in the fully closed position, press the switch 2 to tilt the rear of the 
moonroof up. Press the switch 
1 to lower the moonroof. Press the switch 4 to open the 
moonroof most of the way; press it again to fully open it. Press the switch 
3 to close the 
moonroof. To stop the moonroof in a midway position while opening or closing, momentarily 
press the switch to the 
4 side or 3 side.
1
2
3
4
HomeLink® 5 Accessory Mirror (if equipped)
The HomeLink 5 accessory mirror provides 
three buttons to replace up to three 
hand-held radio frequency remotes used 
to activate devices such as garage door 
openers, gate openers, entry door locks, 
security systems and home lighting. Please 
see your Owner’s Manual for  
programming instructions or visit  
www.subaru.com/homelink to  
view a how-to video.
2926965_18a_Subaru_Legacy_QRG_050417.indd   185/4/17   3:14 PM 
         
        
        
     
        
        Page 22 of 33

20
Auxiliary Input Jack
The 3.5 mm auxiliary input jack is located in the 
front of the center console. You can connect a 
portable music player to the auxiliary jack and 
hear the music stored on it through the vehicle 
speakers. Press the “SOURCE” button located  
on the audio system to select the auxiliary mode.
USB Port
The USB port(s) is/are located in the front of the center console. You can connect a  
USB-equipped portable music player to the USB port and hear the music st\
ored on it  
through the vehicle speakers. Press the “SOURCE” button located on the audio system 
repeatedly until the USB mode is selected.
Controls
Steering Wheel Audio Controls (if equipped)
Talk switch; please refer to 
the “Bluetooth audio” section 
in your Owner’s Manual.
Press the button to select  
the desired audio mode –  
FM, AM, SAT, CD, AUX, MEDIA. With any of the radio modes 
selected, press the left or 
right arrow button to skip 
through your presets. In CD 
mode, press the buttons to 
skip forward or back a track.
Push the switch 
up (+) to increase 
volume or down (–) 
to decrease volume.
2926965_18a_Subaru_Legacy_QRG_050417.indd   205/4/17   3:14 PM