m{zd{ c x-3 39
HEATED STEERING WHEEL
The areas of the steering wheel (shown below) will heat when the igniti\Xon is ON and the heated steering wheel switch is turned on.
To turn heated steering wheel on: Push the switch and the light will illuminate.
To turn heated steering wheel off: Push the switch and the light will turn off.
HEATED \fTEERING WHEEL
(IF EQUIPPED)
Heated steering wheel switch
Heated areas
2940109_18b CX-3 SSG_060817.indd 396/8/17 2:40 PM
m{zd{ c x-3 41
IN\fTRUMENT \bLU\fTER
\fee your Owner’s Manual for more details and explanations. 1 Rotate the knob to adjust the brightness of the instrument cluster and other dashboard illuminations.
2 Push to toggle between trip meter (A & B). When a trip meter is selected, push and hold \.to reset to zero.
Push the knob for 1.5 seconds or more to change the speed\. units between mph.
ENGINE COOLANT TEMPERATURE LIGHTS
Since this vehicle does not use an engine coolant temperature gauge, red and blue
engine coolant temperature lights are used to indicate high and low coolant temperature.
Red Coolant Temperature
FLA\fHING: Engine is starting to run hot.
Drive slowly to reduce engine load.
ON: Engine is overheating. \fafely pull
over to the side of the road and turn the
engine off. Refer to the Owner’s Manual for more information. Blue Coolant Temperature
ON: Engine coolant is cold and no warm air is available for heater/defroster.
OFF: Engine coolant is warm and warm air is available for heater/defroster. The light
may stay on for a few minutes after start- up when the engine\. is cold, but the vehicle
can be driven with the light on or off.
TRIP COMPUTER
The following information can be selected by pushing the or of the INFO button on
the steering wheel.
• Approximate distance you can travel on the available fuel (RANGE)
•
Average fuel economy •
\burrent fuel economy • Average vehicle speed
To reset, push and hold th\.e INFO button for more than 1.5 seconds.
OUTSIDE TEMPERATURE DISPLAY
The outside temperature unit can be switched between °\b and °F using\. \fystem \fettings
in the Infotainment \fystem.
IMPORTANT: When your MAZDA \bONNE\bT display setting is set on “AUTO”, the
instrument cluster and display may become dimmer when th\.e headlights are on. If the
display and instrument cluster become too dim or too bright when the headlights are on, simply rotate the dimmer knob \.located on your instrument cluster to adjust the brightness.
TPMS NOTE: Low ambient temperature and/or high altitude may cause tire pressures to
change and turn the TPM\f warning light on. If the warning light comes on, see p. 6.
2940109_18b CX-3 SSG_060817.indd 416/8/17 2:40 PM
VEHICLE PRESENTATION:
Refer to the \fmart \ftart Guide during presentation.
ESSENTIAL INFORMATION
Driver\bs View
•
Location of \fwitches and \bontrols
Advanced Keyless Entry System*
•
Door Request \fwitch*
Starting the Engine
•
Accelerated Warm-up \fystem
•
Push-Button \ftart \fystem
•
Emergency Engine \ftart/\ftop
Tire Pressure Monitoring System
•
Initialize TPM\f before delivery
Seat Warmers*
Heated Steering Wheel*
Rear Seats
MAZDA CONNECT
Infotainment System*
MAZDA CONNECT Settings*
Commander Switch
Voice Control
Bluetooth®
• Pair Phone
• Make/Receive \ball
•
Toll-Free
\bustomer \fervice 800\f430\f0153
Navigation System*
• \fD \bard
• Planning a Route
SAFETY AND TECHNOLOGY INFORMATION
Active Driving Display*
Mazda Radar Cruise Control*
Smart City Brake Support*
Smart Brake Support*
Lane Departure Warning System*
Distance Recognition Support System*
Traffic Sign Recognition
Blind Spot Monitoring
Rear Cross Traffic Alert*
GENERAL INFORMATION
Exterior Lights
Wiper / Washer
Set Clock
Adaptive Front\flighting System *
High Beam Control
Audio Controls
• Bluetooth® Audio
• \firius XM® Activation and Operation
Audio USB and AUX Inputs
Automatic Climate Control
Instrument Cluster
•
Review of Warning and Indicator
Light Function and Location
Transmission
Auto\fDimming Mirror and HomeLink®*
*If equipped
\bU\fTOMER DELIVERY \bHE\bKLI\fT
2940109_18b CX-3 SSG_060817.indd 466/8/17 2:41 PM
