2018 LINCOLN CONTINENTAL parking brake

[x] Cancel search: parking brake

Page 217 of 615

LINCOLN CONTINENTAL 2018  Owners Manual WARNING: You must remain in yourvehicle when the system turns on. At alltimes, you are responsible for controllingyour vehicle, supervising the system andintervening, if required. Failure to take care

Page 222 of 615

LINCOLN CONTINENTAL 2018  Owners Manual PRINCIPLE OF OPERATION
WARNING: To help avoid personalinjury, always use caution when in reverse(R) and when using the sensing system.
WARNING: The system may not detectobjects with surfaces that abso

Page 226 of 615

LINCOLN CONTINENTAL 2018  Owners Manual If the transmission is in neutral (N), the sidesensing system provides visual distanceindication only when your vehicle is movingbelow a speed of 5 mph (8 km/h) and thereis a front or rear parking aid

Page 227 of 615

LINCOLN CONTINENTAL 2018  Owners Manual Note:Keep the sensors free from snow, iceand large accumulations of dirt.
Note:Do not cover up the sensors.
Note:Do not clean the sensors with sharpobjects.
Note:The sensors may not detect objectswith

Page 228 of 615

LINCOLN CONTINENTAL 2018  Owners Manual To toggle through the modes, use thebuttons on the information display to selectthe following:
•Parallel parking.
•Perpendicular parking.
•Parallel park out assist.
•Switch the system off.
Not

Page 229 of 615

LINCOLN CONTINENTAL 2018  Owners Manual Automatically Steering into a ParallelParking Space
When you shift into reverse (R), with yourhands off the steering wheel and nothingobstructing its movement, your vehicle steersitself into the space

Page 231 of 615

LINCOLN CONTINENTAL 2018  Owners Manual When you believe your vehicle is correctlyparked, or a solid tone sounds and aninformation message appears, bring yourvehicle to a complete stop.
When the active park assist maneuver iscomplete, a ton

Page 245 of 615

LINCOLN CONTINENTAL 2018  Owners Manual Changing the Set Speed
•Press RES+ or SET- to change the setspeed in small increments.
•Press the accelerator or brake pedal untilyou reach the desired speed. Press RES+or SET-.
•Press and hold