2018 KIA STONIC brake light

(Continued)
GINE START/STOP button while
turning the steering wheel right and
left to release the tension.
•If difficulty is experienced turning
the engine start/stop button to
the ACC position, turn the steering
wheel right and left to release the
tension while pressing the engine
start/stop button.
•When you turn off the engine, the
vehicle should be stopped.
CAUTION
You are able to turn off the engine(START/RUN) or vehicle power (ON),only when the vehicle is not in mo‐tion. In an emergency situation whilethe vehicle is in motion, you are ableto turn the engine off and to theACC position by pressing the enginestart/stop button for more than 2seconds or 3 times successivelywithin 3 seconds. If the vehicle is stillmoving, you can restart the engine
(Continued)
(Continued)
without depressing the brake pedalby pressing the engine start/stopbutton with the shift lever in the N(Neutral) position.
ACC (Accessory)
With manual transaxle
Press the engine start/stop button when the button is
in the OFF position without depressing the clutch pedal.
With automatic transaxle
Press the ENGINE START/STOP button
while it is in the OFF position without depressing the brake pedal.
The steering wheel unlocks and electri‐
cal accessories are operational.
If the ENGINE START/STOP button is in
the ACC position for more than 1 hour, the button is turned off automatically
to prevent battery discharge.
0SBOHF
ON
With manual transaxle
Press the engine start/stop button when the button is
in the ACC position without depressing the clutch pedal.
3FE
With automatic transaxle
Press the ENGINE START/STOP button
while it is in the ACC position without depressing the brake pedal.
The warning lights can be checked be‐
fore the engine is started. Do not leave
the ENGINE START/STOP button in the ON position for a long time. The bat‐
tery may discharge, because the engineis not running.
START/RUN
With manual transaxle
To start the engine, depress the clutch pedal and brake
pedal, then press the engine start/stop button with theshift lever in the N (Neutral) position.
With automatic transaxle
To start the engine, depress the brake
pedal and press the engine start/stop
button with the shift lever in the P (Park) or the N (Neutral) position. For
your safety, start the engine with the
shift lever in the P (Park) position.
/PU
JMMVNJOBUFE

6-11
6
Driving your vehicle

ISG (IDLE STOP AND GO) SYSTEM (IF EQUIPPED)
Your vehicle may be equipped with the
ISG system, which reduces fuel con‐ sumption by automatically shutting
down the engine, when the vehicle is at
a standstill. (For example : red light, stop sign and traffic jam)
The engine starts automatically as
soon as the starting conditions are
met.
The ISG system is ON whenever the en‐ gine is running.
NOTICE
When the engine automatically
starts by the ISG system, some
warning lights (ABS, ESC, ESC OFF,
EPS or Parking brake warning light)
may turn on for a few seconds.
This happens because of low battery
voltage. It does not mean the sys‐
tem is malfunctioning.
Auto stop
To stop the engine in idle stop
mode
• Manual transaxle 1. Decrease the vehicle speed to less than 5 km/h.
2. Shift into N (Neutral) position.
3. Release the clutch pedal.
• Automatic transaxle 1. Decrease the vehicle speed to less than 5 km/h.
2. Press the brake pedal. The engine will stop and the green AU‐
TO STOP indicator (
) on the instru‐
ment cluster will illuminate. If your ve‐ hicle is equipped with a supervision
cluster, the notice will illuminate on the
LCD display.
Driving your vehicle
6-16

NOTICE
•You must reach a speed of at least
10 km/h since last idle stop.
•If you unfasten the seat belt or
open the driver’s door (engine
hood) in auto stop mode, the light
on the ISG OFF button will illumi‐
nate and ISG system is deactiva‐
ted. If your vehicle is equipped
with a supervision cluster, the no‐
tice will illuminate on the LCD dis‐
play. Turn the ignition switch to
the START position to start the
engine manually.
Auto start
To restart the engine from idle stop
mode
• Manual transaxle- Press the clutch pedal when theshift lever is in the N (Neutral) po‐
sition.
• Automatic transaxle - Release the brake pedal.
The engine will start and the green AU‐
TO STOP indicator (
) on the instru‐
ment cluster will go out. If your vehicle is equipped with a supervision cluster,
the notice will illuminate on the LCD
display.

6-17
6
Driving your vehicle

The engine will also restart
automatically without the driver's
any actions if the following occurs:
-The fan speed of manual climate con‐
trol system is set above the 3rd posi‐
tion when the air conditioning is on.
- The fan speed of automatic climate
control system is set above the 6th
position when the air conditioning is on.
- When a certain amount of time has
passed with the climate control sys‐
tem on.
- When the defroster is on.
- The brake vacuum pressure is low.
- The battery charging status is low.
- The vehicle speed exceeds 5 km/h.
The green AUTO STOP indicator (
) on
the instrument cluster will blink for 5
seconds.
Condition of ISG system
operation
The ISG system will operate under
the following condition:
- The driver’s seat belt is fastened. -
The driver’s door and hood are closed.
- The brake vacuum pressure is ade‐
quate.
- The battery is sufficiently charged.
- The outside temperature is more
than -2°C (28.4°F).
- The outside temperature is under
32°C (89.6°F).
- The engine coolant temperature is
not too low.
NOTICE
•If the ISG system does not meet
that operation condition, the ISG
system is deactivated. The light on
the ISG OFF button will illuminate.
•If the light comes on continuously,
please check the operation condi‐
tion.
ISG system deactivation
• If you want to deactivate the ISG system, press the ISG OFF button.
The light on the ISG OFF button will il‐ luminate.
Driving your vehicle
6-18

BRAKE SYSTEM
Power brakes
Your vehicle has power-assisted brakesthat adjust automatically through nor‐
mal usage.
In the event that the power-assisted
brakes lose power because of a stalled engine or some other reason, you can
still stop your vehicle by applying
greater force to the brake pedal than you normally would. The stopping dis‐
tance, however, will be longer.
When the engine is not running, the re‐
serve brake power is partially depleted each time the brake pedal is applied. Do
not pump the brake pedal when the
power assist has been interrupted.
Pump the brake pedal only when nec‐ essary to maintain steering control on
slippery surfaces.
WARNING
nBrakes
(Continued)
(Continued)
•Do not drive with your foot restingon the brake pedal. This will createabnormal high brake tempera‐tures, excessive brake lining andpad wear, and increased stoppingdistances.
•When descending a long or steephill, shift to a lower gear and avoidcontinuous application of thebrakes. Continuous brake applica‐tion will cause the brakes to over‐heat and could result in a tempo‐rary loss of braking performance.
•Wet brakes may impair the vehi‐cle’s ability to safely slow down;the vehicle may also pull to oneside when the brakes are applied.Applying the brakes lightly will in‐dicate whether they have been af‐fected in this way. Always testyour brakes in this fashion afterdriving through deep water. To drythe brakes, apply them lightlywhile maintaining a safe forwardspeed until brake performance re‐turns to normal.
(Continued)
(Continued)
•Always, confirm the position ofthe brake and accelerator pedalbefore driving. If you don't checkthe position of the accelerator andbrake pedal before driving, youmay depress the accelerator in‐stead of the brake pedal. It maycause a serious accident.
In the event of brake failure
If service brakes fail to operate while
the vehicle is in motion, you can make an emergency stop with the parking
brake. The stopping distance, however,
will be much greater than normal.
WARNING
nParking brake
Applying the parking brake while thevehicle is moving at normal speedscan cause a sudden loss of control ofthe vehicle. If you must use theparking brake to stop the vehicle,use great caution in applying thebrake.
Driving your vehicle
6-30

Disc brakes wear indicator
Your vehicle has disc brakes.
When your brake pads are worn andnew pads are required, you will hear a
high-pitched warning sound from your
front brakes or rear brakes. You may hear this sound come and go or it may
occur whenever you depress the brake
pedal.
Please remember that some driving conditions or climates may cause a
brake squeal when you first apply (or
lightly apply) the brakes. This is normal and does not indicate a problem with
your brakes.
CAUTION
•To avoid costly brake repairs, donot continue to drive with wornbrake pads.
•Always replace the front or rearbrake pads as pairs.
WARNING
nBrake wear
(Continued)
(Continued)
This brake wear warning soundmeans your vehicle needs service. Ifyou ignore this audible warning, youwill eventually lose braking perform‐ance, which could lead to a seriousaccident.
Rear drum brakes (if equipped)
Your rear drum brakes do not have
wear indicators. Therefore, have the rear brake linings inspected if you hear
a rear brake rubbing noise. Also have
your rear brakes inspected each time you change or rotate your tires and
when you have the front brakes re‐
placed.
Parking brake
Applying the parking brake
To engage the parking brake, first apply
the foot brake and then pull up the
parking brake lever as far as possible.
In addition it is recommended that when parking the vehicle on a incline,
the shift lever should be in a low gear
on manual transaxle vehicles or in the P (Park) position on automatic transaxle
vehicles.

6-31
6
Driving your vehicle

CAUTION
•Driving with the parking brake ap‐plied will cause excessive brakepad and brake rotor wear.
•Do not operate the parking brakewhile the vehicle is moving exceptin an emergency situation. It coulddamage the vehicle system andmake endanger driving safety.
Releasing the parking brake
To release the parking brake, first apply
the foot brake and pull up the parking brake lever slightly. Secondly depress
the release button (1) and lower the
parking brake lever (2) while holding the button.
If the parking brake does not release or
does not release all the way, have the
system checked by a professional workshop. Kia recommends to visit an
authorized Kia dealer/service partner. • If your vehicle is equipped with an au‐
tomatic transaxle, don't let your vehi‐
cle creep forward. To avoid creeping
forward, keep your foot firmly on the brake pedal when the vehicle is stop‐
ped.
• Be cautious when parking on a hill. Firmly engage the parking brake and
place the shift lever in P (automatic
transaxle). or in first or reverse gear (manual transaxle). If your vehicle is
facing downhill, turn the front wheels
into the curb to help keep the vehicle
from rolling. If your vehicle is facing
uphill, turn the front wheels away from the curb to help keep the vehi‐
cle from rolling. If there is no curb or
if it is required by other conditions to
keep the vehicle from rolling, block the wheels.
Driving your vehicle
6-32

• Under some conditions your parkingbrake can freeze in the engaged posi‐
tion. This is most likely to happen when there is an accumulation of
snow or ice around or near the rear
brakes or if the brakes are wet. If
there is a risk that the parking brake
may freeze, apply it only temporarily while you put the shift lever in P (au‐
tomatic transaxle) or in first or re‐
verse gear (manual transaxle) and
block the rear wheels so the vehicle
cannot roll. Then release the parking brake.
• Do not hold the vehicle on the up‐ grade with the accelerator pedal. This
can cause the transaxle to overheat.
Always use the brake pedal or park‐ ing brake.WARNING
•To prevent unintentional move‐ment when stopped and leavingthe vehicle, do not use the gear‐shift lever in place of the parkingbrake. Set the parking brake ANDmake sure the gearshift lever issecurely positioned in P (Park) forautomatic transaxle equipped ve‐hicles.
•Never allow anyone who is unfa‐miliar with the vehicle to touch theparking brake. If the parking brakeis released unintentionally, seriousinjury may occur.
•All vehicles should always have theparking brake fully engaged whenparking to avoid inadvertentmovement of the vehicle whichcan injure occupants or pedes‐trians.
8,5'
Check the brake warning light by turn‐
ing the ignition switch ON (do not start the engine). This light will be illumina‐
ted when the parking brake is applied
with the ignition switch in the START or ON position.
Before driving, be sure the parking
brake is fully released and the brake
warning light is off.
If the brake warning light remains on after the parking brake is released
while engine is running, there may be a
malfunction in the brake system. Im‐ mediate attention is necessary.

6-33
6
Driving your vehicle