2018 KIA STONIC light

If you do not have a spare, use a fuse
of the same rating from a circuit you may not need for operating the vehicle,
such as the cigarette lighter fuse.
If the headlights or taillights, stoplights,
courtesy lamp, day time running lights (D.R.L) do not work and the fuses are
OK, check the fuse panel in the engine
compartment. If a fuse is blown, it must be replaced.
Memory fuse
0:#
Your vehicle is equipped with a memory
fuse to prevent battery discharge if your vehicle is parked without being op‐
erated for prolonged periods. Use the
following procedures before parking the
vehicle for prolonged periods. 1. Turn off the engine.
2. Turn off the headlights and tail
lights.
3. Open the driver’s side panel cover and pull up the memory fuse.
NOTICE
•If the memory fuse is pulled up
from the fuse panel, the warning
chime, audio, clock and interior
lamps, etc., will not operate. Some
items must be reset after replace‐
ment. Refer to L

Instrument panel (Driver’s side fuse panel)
SymbolFuse rat‐ingCircuit Protected
20A Tail Gate Unlock Relay, Dead Lock Relay, Door Lock/Unlock Relay
20A Power Outlet
25A Driver Safety Power Window Module
STOP
LAMP15A Stop Signal Electronic Module
15A BCM (Body Control Module), SLM Unit
20A Cigarette Lighter
10A Driver Power Outside Mirror, Passenger Power Outside Mirror, Air Conditioner Control Module, ECM
(Engine Control Module)/PCM (Power train Control Module)
10A Outside Mirror Folding
RH25A Power Window Main Switch, Passenger Power Window Switch(LHD)
20A Front Seat Warmer Control Module
10A DRL (Daytime Running Light) Relay
7.5A With Immobilizer & Smart Key : ECM (Engine Control Module)/PCM (Power train Control Module), En‐ gine Room Junction Block(Start Relay)
Without Immobilizer & Smart Key : Burglar Alarm Relay
7.5A Head Lamp RH, License Lamp RH(Sedan), Rear Combination Lamp (IN) RH(Wagon), ILL (+)
Maintenance

8-84

SymbolFuse rat‐ingCircuit Protected
7.5A MDPS Unit
AUDIO20A DC-DC Converter, Audio, Audio / Video & Navigation Head Unit
10ARoom Lamp Relay, Power Outside Mirror Switch, Air Conditioner Control Module, SLM Unit, BCM
(Body Control Module), Auto Light & Photo Sensor, Instrument Cluster, Data Link Connector, Rain
Sensor, Trunk Room Lamp, Glove Box Lamp



8-87
8
Maintenance

LIGHT BULBS
Bulb replacement precaution
Please prepare bulbs with appropriate
standards in case of emergencies. Re‐
fer to L

•Lamp part malfunction due to electri‐cal control system stabilization
A normally functioning lamp may
flicker momentarily. This momentary occurrence is due to stabilization unc‐
tion of the vehicle's electrical on con‐
trol system. If the lamp soon returns
to normal, the vehicle does not re‐
quire service.
However, if the lamp goes out after he momentary flickering, or the flick‐
ering continues, have the system
serviced by a professional workshop.
Kia recommends to visit an author‐
ized Kia dealer/service partner.
NOTICE
•If the light bulb or lamp connector
is removed from an operating
lamp activated by electricity, the
fuse box’s electronic device may
scan it as a malfunction. There‐
fore, a lamp malfunction history
may be recorded in Diagnostic
Trouble Code (DTC) in the fuse
box.
(Continued)
(Continued)
•It is normal for an operating lamp
may blink temporarily. Since this
occurrence is due stabilization
function of the vehicle’s electronic
control device, if the lamp lights up
normally after temporary blinking,
there is no problem in the vehicle.
However, if the lamp continues to
blink several times or turn off
completely, there may be an error
in the vehicle’s electronic control
device. In this case, have the vehi‐
cle checked by a professional
workshop immediately. Kia recom‐
mends to visit an authorized Kia
dealer/service partner.
NOTICE
After an accident or after the head‐
light assembly is reinstalled, have
the headlight aiming adjusted by a
professional workshop. Kia recom‐
mends to visit an authorized Kia
dealer/service partner.
NOTICE
After driving in heavy rain or wash‐
ing, headlamp and taillamp lenses
could appear frosty. This condition is
caused by the temperature differ‐
ence between the lamp inside and
outside. This is similar to the con‐
densation on your windows inside
your vehicle during the rain and
doesn’t indicate a problem with your
vehicle. If the water leaks into the
lamp bulb circuitry, have the vehicle
checked by a professional workshop.
Kia recommends to visit an author‐
ized Kia dealer/service partner.
NOTICE
nTraffic Change (For Europe)
The low beam light distribution is
asymmetric. If you go abroad to a
country with opposite traffic direc‐
tion, this asymmetric part will dazzle
oncoming car driver. To prevent daz‐
(Continued)

8-105
8
Maintenance

(Continued)
zle, ECE regulation demand several
technical solutions (ex. automatic
change system, adhesive sheet,
down aiming). This headlamps are
designed not to dazzle opposite driv‐
ers. So, you need not change your
headlamps in a country with oppo‐
site traffic direction.
Light bulb position (Front)
0:##
)FBE
MBNQ

5ZQF
"
0:##
)FBE
MBNQ

5ZQF
#
0:##
'PH
MBNQ
1. Headlamp (Low/High)
2. Front turn signal lamp
3. Position lamp / Day time runninglamp (Bulb type)
4. Position lamp / Day time running lamp (LED type)
5. Static bending light
6. Fog lamp
Maintenance
8-106

Light bulb position (Rear)
0:##
3FBS
DPNCJOBUJPO
MBNQ

5ZQF
"
0:##
3FBS
DPNCJOBUJPO
MBNQ

5ZQF
#
0:##
#BDL
VQ
MBNQ
0:##
3FBS
GPH
MBNQ
0:##
-JDFOTF
QMBUF
MBNQ
0:##
)JHI
NPVOUFE
TUPQ
MBNQ
1. Tail lamp (Bulb type)
2. Stop and tail lamp (Bulb type)
3. Rear turn signal lamp (Bulb type)
4. Tail lamp (LED type)
5. Tail lamp (LED type)
6. Stop and tail lamp (LED type)

8-107
8
Maintenance

7. Stop and tail lamp (LED type)
8. Back up lamp
9. Rear fog lamp
10. License plate lamp
11. High mounted stop lampLight bulb position (Side)
¥
5ZQF
"
¥
5ZQF
#
1. Side repeater lamp (LED type)
2. Side repeater lamp (bulb type)
Side repeater lamp (LED type)
bulb Replacement
If the side repeater lamp (LED) (1) does
not operate, have your vehicle checked by a professional workshop.
Kia recommends to visit an authorized
Kia dealer/service partner.
The LED lamps cannot be replaced as a
single unit because it is an integrated unit. The LED lamps has to be replaced
with the unit.
A skilled technician should check or re‐
pair side repeater lamp (LED), for it may damage related parts of the vehi‐
cle.
Maintenance
8-108