
(Continued)
•When the charging system warn‐
ing light comes on or the voltage is
low (When the alternator (or bat‐
tery) does not operate normally or
it malfunctions), the steering
wheel may get heavy and become
difficult to control operate abnor‐
mally.
Tilt & telescopic steering (if
equipped)
A tilt and telescopic steering wheel al‐
lows you to adjust the steering wheel before you drive.
You can also raise it to give your legs
more room when you exit and enter
the vehicle.
The steering wheel should be posi‐ tioned so that it is comfortable for you
to drive, while permitting you to see
the instrument panel warning lights and gauges.
WARNING
•Never adjust the angle of thesteering wheel while driving. Youmay lose steering control andcause severe personal injury,death or accidents.
•After adjusting, push the steeringwheel both up and down to be cer‐tain it is locked in position.
To change the steering wheel angle,
pull down the lock release lever (1), ad‐ just the steering wheel to the desired
angle (2) and height (3, if equipped),
then pull up the lock-release lever to lock the steering wheel in place. Be sure
to adjust the steering wheel to the de‐
sired position before driving.
Features of your vehicle
4-38

Charging System
Warning Light
This warning light illumi‐nates:
• Once you set the ignition switch or Engine Start/Stop Button to the ON
position. - It remains on until the engine is started.
• When there is a malfunction with ei‐ ther the alternator or electrical
charging system.
If there is a malfunction with either thealternator or electrical charging sys‐tem:
1. Drive carefully to the nearest safe location and stop your vehicle.
2. Turn the engine off and check the alternator drive belt for looseness
or breakage.
In this case, have the vehicle in‐
spected by a professional workshopas soon as possible.
Kia recommends to visit an author‐
ized Kia dealer/service partner.
Engine Oil Pressure
Warning Light
This warning light illumi‐nates:
• Once you set the ignition switch or Engine Start/Stop Button to the ON
position. - It remains on until the engine is started.
• When the engine oil pressure is low.
If the engine oil pressure is low:
1. Drive carefully to the nearest safe location and stop your vehicle.
2. Turn the engine off and check the engine oil level (For more details,
refer to L

NOTICE
The DOOR mode and ROOM mode
can not be selected at a time.
Front Map Lamp:
• Type A(3): Press this switch to turn the
front map lamps on.
(4): Press this switch to turn the
front map lamps off.
• Type B
(3): Press this switch to turn the
front map lamps on and off.
Room lamp
•: The light stays on at all times.
Luggage room lamp (if
equipped)
The luggage room lamp comes on when
the trunk (tailgate) is opened.
CAUTION
The luggage room lamp comes on aslong as the trunk (tailgate) opens. Toprevent unnecessary charging sys‐tem drain, close the trunk (tailgate)
(Continued)
(Continued)
securely after using the luggageroom.
Vanity mirror lamp (if equipped)
Push the switch to turn the light on or
off.
: The lamp will turn on if this but‐
ton is pressed.
: The lamp will turn off if this button
is pressed.
Features of your vehicle
4-96

CAUTION
nVanity mirror lamp
Always have the switch in the offposition when the vanity mirrorlamp is not in use. If the sunvisor isclosed without the lamp off, it maydischarge the battery or damage thesunvisor.
Glove box lamp (if equipped)
The glove box lamp comes on when the
glove box is opened.
CAUTION
To prevent unnecessary chargingsystem drain, close the glove box se‐curely after using the glove box.
4-97
4
Features of your vehicle

CAUTION
•Use the power outlet only whenthe engine is running and removethe accessory plug after use. Usingthe accessory plug for prolongedperiods of time with the engine offcould cause the battery to dis‐charge.
•Only use 12V electric accessorieswhich are less than 10A in electriccapacity.
•Adjust the air-conditioner or heat‐er to the lowest operating levelwhen using the power outlet.
•Close the cover when not in use.
•Some electronic devices can causeelectronic interference when plug‐ged into a vehicle’s power outlet.These devices may cause exces‐sive audio static and malfunctionsin other electronic systems or de‐vices used in your vehicle.
•Using electrical products which ex‐ceed the limited capacity mightcause heating to the power outletand wiring that could lead to anelectrical breakdown.
(Continued)
(Continued)
•Always make sure the electricalpart is firmly plugged into thepower outlet. Incomplete pluggingmay cause electrical breakdown.
•Electrical products with a built-inbattery might cause current flow,which could lead to malfunction ofthe electric/ electronic device inyour vehicle. Only use electricalproducts which include reversecurrent prevention.
WARNING
Do not put a finger or a foreign ele‐ment (pin, etc.) into a power outletand do not touch with a wet hand.You may get an electric shock.
USB charger (if equipped)
The USB charger is designed to re‐
charge batteries of small size electrical devices using a USB cable. The electrical
devices can be recharged when the En‐
gine Start/Stop button is in ACC/ON/ START position.
The battery charging state may be
monitored on the electrical device.
Disconnect the USB cable from the USB
port after use. • Some devices are not supported for fast charging but will be charged withnormal speed.
• Use the USB charger when the engine is running to prevent battery dis‐
charge.
Features of your vehicle
4-130

• Only devices that fits the USB portcan be used.
• The USB charger can be used only for battery charging purposes.
• Battery chargers cannot be charged.
Floor mat anchor(s) (if
equipped)
0 : #
When using a floor mat on the front
floor carpet, make sure it attaches to the floor mat anchor(s) in your vehicle.
This keeps the floor mat from sliding
forward.
WARNING
The following must be observedwhen installing ANY floor mat to thevehicle.•Ensure that the floor mats are se‐curely attached to the vehicle'sfloor mat anchor(s) before drivingthe vehicle.
•Do not use ANY floor mat thatcannot be firmly attached to thevehicle's floor mat anchors.
•Do not stack floor mats on top ofone another (e.g. all-weather rub‐ber mat on top of a carpeted floormat). Only a single floor matshould be installed in each position.
IMPORTANT - Your vehicle was man‐ufactured with driver's side floormat anchors that are designed tosecurely hold the floor mat in place.To avoid any interference with pedaloperation, Kia recommends that onlythe Kia floor mat designed for use inyour vehicle be installed.
Shopping bag holder
CAUTION
•Do not hang a bag weighing morethan 3 kg (7 lbs.). It may causedamage to the shopping bag hold‐er.
•Do not hang the frail objects whenyou drive rough road, the objectsmay be damaged.
4-131
4
Features of your vehicle

The engine will also restart
automatically without the driver's
any actions if the following occurs:
-The fan speed of manual climate con‐
trol system is set above the 3rd posi‐
tion when the air conditioning is on.
- The fan speed of automatic climate
control system is set above the 6th
position when the air conditioning is on.
- When a certain amount of time has
passed with the climate control sys‐
tem on.
- When the defroster is on.
- The brake vacuum pressure is low.
- The battery charging status is low.
- The vehicle speed exceeds 5 km/h.
The green AUTO STOP indicator (
) on
the instrument cluster will blink for 5
seconds.
Condition of ISG system
operation
The ISG system will operate under
the following condition:
- The driver’s seat belt is fastened. -
The driver’s door and hood are closed.
- The brake vacuum pressure is ade‐
quate.
- The battery is sufficiently charged.
- The outside temperature is more
than -2°C (28.4°F).
- The outside temperature is under
32°C (89.6°F).
- The engine coolant temperature is
not too low.
NOTICE
•If the ISG system does not meet
that operation condition, the ISG
system is deactivated. The light on
the ISG OFF button will illuminate.
•If the light comes on continuously,
please check the operation condi‐
tion.
ISG system deactivation
• If you want to deactivate the ISG system, press the ISG OFF button.
The light on the ISG OFF button will il‐ luminate.
Driving your vehicle
6-18

Jump starting procedure
1. Make sure the booster battery is12-volt and that its negative termi‐ nal is grounded.
2. If the booster battery is in another vehicle, do not allow the vehicles to
come in contact.
3. Turn off all unnecessary electrical loads.
4. Connect the jumper cables in the exact sequence shown in the illus‐
tration. First connect one end of a
jumper cable to the positive termi‐
nal of the discharged battery (1),
then connect the other end to the
positive terminal on the booster
battery (2).
Proceed to connect one end of the other jumper cable to the negative
terminal of the booster battery (3),
then the other end to a solid, sta‐
tionary, metallic point (for example,
the engine lifting bracket) away
from the battery (4). Do not con‐
nect it to or near any part that
moves when the engine is cranked.
Do not allow the jumper cables to
contact anything except the correct
battery terminals or the correct
ground. Do not lean over the bat‐ tery when making connections.CAUTION
nBattery cables
Do not connect the jumper cablefrom the negative terminal of thebooster battery to the negative ter‐minal of the discharged battery. Thiscan cause the discharged battery tooverheat and crack, releasing bat‐tery acid.Make sure to connect one end of thejumper cable to the negative termi‐nal of the booster battery, and theother end to a metallic point, faraway from the battery.
5. Start the engine of the vehicle with the booster battery and let it run
at 2,000 rpm, then start the engine
of the vehicle with the discharged
battery.
If the cause of your battery discharging
is not apparent, have the systemchecked by a professional workshop.Kia recommends to visit an authorized Kia dealer/service partner.
Push-starting
Your manual transaxle-equipped vehi‐
cle should not be push-started because it might damage the emission control
system.
Vehicles equipped with automatic
transaxle cannot be push-started.
Follow the directions in this section for L