2018 KIA OPTIMA stop start

Downloaded from www.Manualslib.com manuals search engine Satellite Radio Reception
Satellite radio reception requires direct line of sight with the satellite transmitting the radio signal.
Tunnels, bridges, covered parking, mountainous terrain, tall buildings, heavy foliage, and other obstacles
may momentarily interrupt the signal. This is normal operation, and reception will be restored within a
few seconds in an open, unobstructed area.
The signal can become weak in some areas that are not covered by the satellite repeater network.
Accessory Mode with Smart Key*
With standard key vehicles, you can turn the key to the accessory mode and utilize the elec\
tronic
accessories without starting the vehicle. This is still possible with Smart Key-equipped vehicles. To do
this, enter the vehicle with the Smart Key and push the ENGINE START/STOP button one time without
depressing the brake pedal. This will put the vehicle in Accessory mode and ACC will illuminate in yellow.
If the ENGINE START/STOP button is in the ACC position for more than 1 hour, the button is turned off
automatically to help prevent battery discharge.
Tilt/Telescoping Steering Wheel
A
B
C
To adjust the Steering Wheel:
• Push the Lock-Release Lever (A) down.
• Adjust the Steering Wheel to desired distance (B).
• Adjust the Steering Wheel angle (C).
• Pull the Lock-Release Lever (A) up to lock the Steering Wheel in place.
It may be helpful to lift the Steering Wheel up while moving it towards/\
away from you to adjust desired
distance prior to adjusting the angle.
Wind Buffeting
In many vehicles, when a rear window is lowered and the front window(s) are in the closed position, air flowing past the open
window(s) induces pressure oscillations, or pulsations, which may be uncomfortable. When opening the rear window(s), always
remember to also open the front window(s), slightly, to relieve the pressure oscillations inside the vehicle.
Rear Trunk Operation*
HOLD
For vehicles equipped with a Smart Key, when the Smart Key fob is in your pos\
session and you are near
the back of the vehicle, within close proximity, the hazard warning lights will blink and\
a chime will sound
for about 3 seconds as an alert that the Smart Trunk* is about to open.
Then the alert system will blink and chime two additional times before opening the Smart Trunk*.
The Smart Trunk feature is OFF by default. To enable the Smart Trunk, go to User Settings in the LCD
Instrument Cluster modes.
If you unlocked your vehicle or opened the rear trunk by pressing the unlock button on your Smart Key
(even though it is not necessary to do so), be sure to press the lock button on the Smart Key before
walking away, to ensure your entire vehicle is locked again.
The Smart Trunk function can be deactivated by pressing any button of the smart key during the Detect
and Alert stage.
Power Folding Mirrors*
To both fold and unfold the outside rearview mirror, press the folding mirror button as pictured.
Please do not attempt to fold the mirrors manually, as this may cause th\
e mirror to not be
synchronized with the electric motor.
Should the power folding mirrors be folded in or out manually, they should be re-synched with the
motors, or they may not remain in the desired position or appear loose.
To sync the mirror, use the folding mirror button to cycle the power mirror. The mirror should then
operate properly when using the power folding feature. Cycle the mirror up to three times to ensure
proper operation.
Raising the Windshield Wiper Arms
A
To inspect or replace the windshield wiper blades and to prevent damaging the hood, move the
windshield wiper blades to the service position as follows:
After turning off the engine, move the wiper switch to the single wiping (MIST) position within 20
seconds and hold the switch more than 2 seconds until the wiper blade is in the fully up position.
Power Window Lock Button
The driver can disable the power window switches on the rear passengers’ doors by pressing the power
window lock switch to the lock position (pressed).
When the power window lock switch is pressed:
• The driver’s master control can operate all the power windows.
• The front passenger’s control can operate the front passenger’s power window.
• The rear passenger’s control cannot operate the rear passenger’s power window.

Downloaded from www.Manualslib.com manuals search engine Condensation Inside Exterior Vehicle Lights
Your vehicle’s exterior lights with clear lenses are vented to the atmosphere to release pressure as the air inside heats and cools.
When humid/moist air enters the headlight/tail light, the moisture may condense on the lens surface and appear as fogging or water
droplets. This is a normal condition and the moisture will evaporate when the lights are turned ON or when the temperature increases.
USB Ports and Use of Cables
12V12V180W
A UX USB180WVehicle may contain USB port(s) for playing music from a compatible media device as well as USB port(s)
for charging. Note: devices will only be recharged when the vehicle is in ACC/ON/Start position. If you
encounter difficulty plugging in a USB device, change the orientation of the device (may be upside
down). Always use the USB charging cable that has been certified by the device manufacturer. Use
of aftermarket cables is NOT recommended as they may impact functionality.
Windshield Defogging
FRONTREAR
MODECLIMATEOFF
AUTO
SYNCAB
Windshield fogging is caused by moisture in the air condensing on the cold glass. The following practices
can help reduce window fogging:
• Keeping the inside of the glass as clean as possible.
• Utilizing the Defrost Mode activates the A/C and opens Fresh Air Vent (A).
• Adjusting the Temperature Control to the desired temperature (B).
Seat Warmers / Ventilated Seats*
Yellow Color:
Warming
Blue Color:
Ventilating
• Press top/bottom of button once for high setting (3 LEDs lit).
• Press button twice for medium setting (2 LEDs lit).
• Press a third time for low setting (1 LED lit) and again to turn OFF.
With the seat warmer switch in the ON position, the heating system in the seat turns OFF or ON
automatically depending on the seat temperature.
Driver Position Memory System*
SET
1
2A
B
To store a seating position into memory, first place the shifter into P (Park) while the ignition switch is
ON. Then:
1. Adjust the driver’s seat.
2. Press the SET button (A) on the control panel. The system will beep once.
3. Press one of the memory buttons (B) within 5 seconds. The system will beep twice when memory
has been stored.
4. ‟Driver (1 or 2) set is memorized” will appear on the instrument cluster\
LCD display.
Blind-Spot Detection (BSD) System*
(Located left of Steering Wheel)
The BSD system uses radar sensors to help alert the driver before changing lanes. The light on the
BSD button will illuminate when turned ON. The outside rearview mirror warning lights will also
illuminate for 3 seconds.
The system will become active when the vehicle is traveling more than 18 mph and will alert the driver
if another vehicle is detected by the radar sensor.
Blind Spot Detection is not a substitute for safe driving, and may not detect all objects around vehicle.
Always drive safely and use caution.
Images or graphics for illustration only. *If equipped. 1. The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by \
Kia is
under license. A Bluetooth® enabled cell phone is required to use Bluetooth® Wireless Technology. 2. iPhone, CarPlay and Siri are registered trademarks of Apple Inc. Android and Android
Auto are trademarks of Google LLC.
Distracted driving can result in a loss of vehicle control. When operating a vehicle, never use a handheld device or vehicle system that takes your focus away from safe vehicle operation.
Always drive safely and use caution.
Check Engine Light from Fuel Cap
Tighten the cap until it clicks once, to prevent Malfunction Indicator from illuminating.
The Fuel Filler Door Release button is located on the lower part of the driver’s door panel.
Heated Steering Wheel Button*
A
( L ocated belo w gear sh if t ) (Located below gear shift)
Press button to turn ON/OFF steering wheel heater, while the ignition or ENGINE START/STOP button is
in the ON position.
Steering wheel heater will turn off automatically in 30 minutes, or when\
button is pressed again to deactivate.
If ignition is turned OFF, then ON again, within 30 minutes of steering wheel heater being turned on,
system will automatically be set ON again.
Rear Parking Assist System*
The Rear Parking Assist System is not a safety device. The Rear Parking Assist System is a
supplemental system that assists the driver by chiming if any object is detected within the sensing area
to the rear and side of the vehicle when backing up.
When the ignition is ON, the system is activated.
If the vehicle is moving at speeds over 3 mph, the system may not activate correctly.
When more than two objects are sensed at the same time, the closest one will be recognized first.
The Rear Parking Assist System is not a substitute for safe driving, and may not d\
etect every object
behind vehicle. Always drive safely and use caution.