Downloaded from www.Manualslib.com manuals search engine Satellite Radio Reception
Satellite radio reception requires direct line of sight with the satellite transmitting the radio signal.
Tunnels, bridges, covered parking, mountainous terrain, tall buildings, heavy foliage, and other obstacles
may momentarily interrupt the signal. This is normal operation, and reception will be restored within a
few seconds in an open, unobstructed area.
The signal can become weak in some areas that are not covered by the satellite repeater network.
Accessory Mode with Smart Key*
With standard key vehicles, you can turn the key to the accessory mode and utilize the elec\
tronic
accessories without starting the vehicle. This is still possible with Smart Key-equipped vehicles. To do
this, enter the vehicle with the Smart Key and push the ENGINE START/STOP button one time without
depressing the brake pedal. This will put the vehicle in Accessory mode and ACC will illuminate in yellow.
If the ENGINE START/STOP button is in the ACC position for more than 1 hour, the button is turned off
automatically to help prevent battery discharge.
Tilt/Telescoping Steering Wheel
A
B
C
To adjust the Steering Wheel:
• Push the Lock-Release Lever (A) down.
• Adjust the Steering Wheel to desired distance (B).
• Adjust the Steering Wheel angle (C).
• Pull the Lock-Release Lever (A) up to lock the Steering Wheel in place.
It may be helpful to lift the Steering Wheel up while moving it towards/\
away from you to adjust desired
distance prior to adjusting the angle.
Wind Buffeting
In many vehicles, when a rear window is lowered and the front window(s) are in the closed position, air flowing past the open
window(s) induces pressure oscillations, or pulsations, which may be uncomfortable. When opening the rear window(s), always
remember to also open the front window(s), slightly, to relieve the pressure oscillations inside the vehicle.
Rear Trunk Operation*
HOLD
For vehicles equipped with a Smart Key, when the Smart Key fob is in your pos\
session and you are near
the back of the vehicle, within close proximity, the hazard warning lights will blink and\
a chime will sound
for about 3 seconds as an alert that the Smart Trunk* is about to open.
Then the alert system will blink and chime two additional times before opening the Smart Trunk*.
The Smart Trunk feature is OFF by default. To enable the Smart Trunk, go to User Settings in the LCD
Instrument Cluster modes.
If you unlocked your vehicle or opened the rear trunk by pressing the unlock button on your Smart Key
(even though it is not necessary to do so), be sure to press the lock button on the Smart Key before
walking away, to ensure your entire vehicle is locked again.
The Smart Trunk function can be deactivated by pressing any button of the smart key during the Detect
and Alert stage.
Power Folding Mirrors*
To both fold and unfold the outside rearview mirror, press the folding mirror button as pictured.
Please do not attempt to fold the mirrors manually, as this may cause th\
e mirror to not be
synchronized with the electric motor.
Should the power folding mirrors be folded in or out manually, they should be re-synched with the
motors, or they may not remain in the desired position or appear loose.
To sync the mirror, use the folding mirror button to cycle the power mirror. The mirror should then
operate properly when using the power folding feature. Cycle the mirror up to three times to ensure
proper operation.
Raising the Windshield Wiper Arms
A
To inspect or replace the windshield wiper blades and to prevent damaging the hood, move the
windshield wiper blades to the service position as follows:
After turning off the engine, move the wiper switch to the single wiping (MIST) position within 20
seconds and hold the switch more than 2 seconds until the wiper blade is in the fully up position.
Power Window Lock Button
The driver can disable the power window switches on the rear passengers’ doors by pressing the power
window lock switch to the lock position (pressed).
When the power window lock switch is pressed:
• The driver’s master control can operate all the power windows.
• The front passenger’s control can operate the front passenger’s power window.
• The rear passenger’s control cannot operate the rear passenger’s power window.
