2018 FIAT 500 wiper blades

SERVICING AND CARE
154
REGULAR
INSPECTIONS
39) 22) 4)
Every 1,000 km or before long
journeys, check and, if necessary, top
up the following:
❒ engine coolant fluid level;
❒ brake fluid level;
❒ windscreen washer fluid level;
❒ tyre inflation pressure and condition;
❒ operation of lighting system
(headlights, direction indicators,
hazard warning lights, etc.);
❒ operation of the windscreen
wiper/washer system, position and
wear of the windscreen and rear
window wiper blades.
Every 3,000 km check and top up if
required: engine oil level.
You are advised to use PETRONAS
LUBRICANTS products, which have
been designed and produced
specifically for Fiat cars (see table
“Capacities” in the “Technical
specifications” section).
DEMANDING USE
OF THE CAR
If the vehicle is mainly used in one of
the following particularly harsh
conditions:
❒ trailer or caravan towing;
❒ dusty roads;
❒ short repeated distances (less than
7-8 km) and with external
temperatures below zero;
❒ engine often idling or driving long
distances at low speeds or long
periods of inactivity;
perform the following inspections more
frequently than shown on the
Scheduled Servicing Plan:
❒ check front disk brake pad
conditions and wear;
❒ Check cleanliness of bonnet and
luggage compartment locks,
cleanliness and lubrication of
linkage;❒ sight inspect the conditions of:
engine, gearbox, transmission,
pipes and hoses (exhaust -
fuel - brakes), rubber parts
(boots, sleeves, bushes, etc.);
❒ check battery charge and battery
fluid level (electrolyte);
❒ visually check the various drive belt
conditions;
❒ check and, if necessary, change
engine oil and replace oil filter;
❒ check pollen filter and replace it, if
required;
❒ check air cleaner and replace it, if
required.

161
BRAKES
Depending on the version/market, the
vehicle may be equipped with
mechanical wear detectors for the
brake pads: one for each wheel
assembly.
When the brake linings are close to
wearing out, pressing the brake pedal
will generate a slight squeal: this lasts
for about 100 km (the mileage varies
with the driving style and route).
In this case, it is still possible to
continue driving, with caution.
However, contact a Fiat Dealership as
soon as possible to have the worn
brake pads changed.
WINDSCREEN
WIPER REAR
WINDOW WIPER 41)
Replace the blades if the rubber edge is
deformed or worn. In any case, it is
advisable to replace them
approximately once a year.
LIFTING THE BLADES
WINDSCREEN WIPER
Lift the windscreen wiper arm and
position the blade so that it forms a 90°
angle with the arm;
REPLACING THE
WINDSCREEN WIPER
BLADES
Proceed as follows:
❒ lift the windscreen wiper arm;
❒ press the button A-fig. 144 and
extract the blade C from the arm B;
❒ insert the new blade making sure it
is locked.
REPLACING THE REAR
WINDOW WIPER BLADE
Proceed as follows:
❒ raise the cover A-fig. 145 and
remove the arm from the vehicle by
loosening nut B that fastens it to the
pivot pin;
❒ position the new arm correct and
tighten the nut;
144DVDF0S0129c

200
PERSONAL SAFETY
(CONTINUED)
42) INTERIORS
•Never use flammable products, such as petrol ether or rectified
petrol to clean the inside of the car. The electrostatic charges which
are generated by rubbing during the cleaning operation may cause
a fire.
•Do not keep aerosol cans in the vehicle: they might explode.
Aerosol cans must not be exposed to a temperature exceeding
50°C. When the vehicle is exposed to sunlight, the internal
temperature can greatly exceed this value.
43) TECHNICAL SPECIFICATIONS – FUEL SUPPLY
Modifications or repairs to the supply system that are not carried
out correctly or do not take the system technical specifications
into account can cause malfunctions leading to the risk of fire.
44) TECHNICAL SPECIFICATIONS – RIM PROTECTOR
TYRES
DO NOT fit wheel hub caps when using integral hub caps fixed
(with springs) to the steel rim and after sale tyres provided with
Rim Protector. Use of unsuitable tyres and wheel caps may cause
sudden decrease of tyre pressure.
45) LPG
•Note that in some countries (including Italy) there are legal
restrictions in force for parking/garaging motor vehicles fuelled by
gas that is denser than air; LPG comes under this category.
•Do not switch between the two operating modes (petrol/LPG)
whilst starting the engine.
•The LPG supply system is equipped with a “consumption”
function linked to the LED display of LPG level on the switch; this
function activates only after a consistent variation in fuel level has
been detected. •Running the battery with an excessively low liquid level will
damage the battery beyond repair and could even cause its
explosion.
•If the vehicle must remain unused for a long time at a very low
temperature, remove the battery and take it to a warm place, to
avoid freezing.
•When performing any operation on the battery or near it,
always protect your eyes with special goggles.
40) TYRES AND WHEELS
•Remember that the road holding qualities of your car also
depend on correct tyre pressures.
•If tyre pressure is too low, the tyre may overheat and be
severely damaged as a result.
•Do not switch tyres from the right hand side of the vehicle to the
left hand side, and vice versa.
•Never submit alloy rims to repainting treatments requiring the
use of temperatures exceeding 150°C.
The mechanical properties of the wheels could be impaired.
41) WINDSCREEN AND –REAR WINDOW WIPER
•Driving with worn windscreen/rear window wiper blades is a
serious hazard, because visibility is reduced in bad weather.
•If the window needs to be cleaned, make sure the device is
deactivated or the key is on STOP.
IMPORTANT INFORMATION AND RECOMMENDATIONS
(CONTINUES)

IMPORTANT INFORMATION AND RECOMMENDATIONS
202
1) KEYS AND CODE CARD
•The electronic components inside the key may be damaged if
the key is subjected to strong shocks. In order to ensure
complete efficiency of the electronic devices inside the keys,
they should never be exposed to direct sunlight.
•All the keys and the CODE card must be handed over to the
new owner when selling the car.
2) SEATS
•The fabric upholstery of the seats has been designed to
withstand long-term wear deriving from normal use of the car.
Some precautions are however required. Avoid prolonged and/or
excessive rubbing against clothing accessories such as metal
buckles and Velcro strips which, by applying a high pressure on
the fabric in a small area, could cause it to break, thereby
damaging the upholstery.
•Before tilting the backrest, remove any objects on the seat
cushion.
3) CLIMATE CONTROL SYSTEM
Never use R12 coolant, which is not compatible with climate
control system components.
4) WINDSCREEN AND REAR WINDOW WIPER
•Do not use the windscreen or rear window wiper to remove
layers of snow or ice from the windscreen. In such conditions,
the windscreen and rear window wiper may be subjected to
excessive stress and the motor cut-out switch, which prevents
operation for a few seconds, may intervene. If operation is not restored, contact a Fiat Dealership.
•Do not operate the windscreen wiper with the blades lifted from
the windscreen:
• Do not activate the rain sensor or the rearscreen wiper when
washing the car in an automatic car wash.
• Make sure that the device is turned off if there is ice on the
windscreen.
5) SUNROOF
•Use the sunroof only at “spoiler” position if a transverse roof
rack is fitted.
•Do not open the sunroof if there is snow or ice on it: you may
damage it.
•Be careful not to hit objects on the storage shelf when you
open the tailgate.
6) SOFT TOP
•Never open the top in presence of snow or ice to prevent
damage.
•Do not place objects on the rear window shelf to prevent
damage while the top is closing.
•Loads may not be secured on the roof.
•Bird droppings must be washed off immediately and thoroughly
as the acid they contain is particularly aggressive.
•Never use high-pressure washing systems.
•When using steam washers or high-pressure water washers,
maintain a suitable distance and do not exceed a maximum
temperature of 60°C.
Damage, alterations and water infiltrations may occur if the
distance is too small.
•If a water jet is used, direct away from the edges of the fabric
and the rear window frame to prevent water infiltrations.
VEHICLE SAFETY
(CONTINUES)

CONTENTS
218
Heavy-duty use of the car .............................................154
Engine compartments............................................155-157
Checking fluid levels .....................................................158
– Engine oil ...................................................................158
– Engine coolant ...........................................................158
– Washer fluid for windscreen/rear window ...................159
– Brake fluid .................................................................159
Battery..........................................................................159
– Inspecting the charge ................................................159
– Replacing the battery..................................................159
– Car inactivity .............................................................159
Wheels and tyres ..........................................................160
Brakes .........................................................................161
Windscreen wiper–Rear wiper ......................................161
– Replacing the windscreen wiper blades .....................161
– Replacing the rear window wiper blade ......................161
– Windscreen washer nozzles........................................162
– Rear window washer nozzles......................................162
Bodywork.....................................................................162
– Advice for preserving the
bodywork...................................................................162
Interiors.........................................................................164
Fabric seats and parts...................................................164
Plastic and coated parts................................................164
Genuine leather parts....................................................164TECHNICAL DATA
Identification data .........................................................165
– Identification data plate ............................................. 165
– Bodywork paint identification plate .............................165
– Chassis marking .......................................................166
– Engine marking .........................................................166
Engine...........................................................................167
Dimensions ..................................................................171
Wheels .........................................................................172
Tyre inflation pressures ................................................174
Snow chains ................................................................174
Snow tyres ...................................................................175
Steering .......................................................................175
Performance ................................................................176
Weights.........................................................................177
Refuelling .....................................................................180
Fluids and lubricants .....................................................182
– Product specifications.............................................. 182
Fuel consumption– CO
2emissions................................184
Prescriptions for handling the vehicle at the
end of its life................................................................. 185
IMPORTANT INFORMATION
AND RECOMMENDATIONS
Personal safety....................................................187-201
Vehicle safety ......................................................202-207
Environmental protection...............................................208