2018 BMW X4 Owners Manual

Safety
informationWARNING
Active front-seat passenger airbags can
injure a child in a child restraint system when
the airbags are activated. There is a risk of inj
jury. Make sure that the front-seat passenger
airbags are deactivated and that the PASSENj GER AIRBAG OFF indicator lamp lights up.'

til the best possible belt guide position isreached.
Backrest
width Adjustable backrest width: before installing a
child restraint system in the front passenger
seat, open the backrest width completely. Do
not change the backrest width again and do
not call up a memory position.
Child
seat
security
The rear safety belts and the front passenger safety belt can be permanently locked to fasj
ten child restraint systems.
Locking
the
safety
belt1.Pull out the belt strap completely.2.Secure the child restraint system with the
safety belt.3.Allow the belt strap to be pulled in and pull it tight against the child restraint system.
The safety belt is locked.
Unlocking
the
safety
belt
1.Unbuckle the belt buckle.2.Remove the child restraint system.3.Allow the belt strap to be pulled in comj
pletely.
LATCH
child
restraint
fixing
system
General
information
LATCH: Lower Anchors and Tether for Chilj
dren.
Pay attention to the operating and safety inforj mation of the child restraint system manufacjturer when installing and using LATCH child
restraint fixing systems.
Mounts
for
the
lower
LATCH
anchors The lower anchors may be used to attach the
CRS to the vehicle seat up to a combined child and CRS weight of 65 lb/30 kg when the child
is restrained by the internal harnesses.Safety
information
WARNING
If the LATCH child restraint fixing sysj
tems are not correctly engaged, the protective
effect of the LATCH child restraint fixing sysj
tem can be limited. There is a risk of injuries or
danger to life. Make sure that the lower anj
chors are securely engaged and that the
LATCH child restraint fixing system fits sej curely against the backrest.'

For vehicles equipped with a middle seat:It is not recommended to use the inner loweranchors of standard outer LATCH positions tofasten a child restraint system on the middle
seat. Use the vehicle safety belt instead for the
middle seat.
Before
installing
LATCH
child
restraint
fixing
systems
Pull the safety belt away from the area of the child restraint system.
Assembly
of
LATCH
child
restraint
fixing
systems1.Install child restraint system, see manufacj
turer's information.2.Ensure that both LATCH anchors are propj erly connected.
Child
restraint
systems
with
tether
strap
Mounting
points The respective symbol shows the anjchor for the upper retaining strap.
Seats with an upper top tether are
marked with this symbol. It can be found on
the rear seat backrest or the rear window shelf.
Safety
information NOTE
The mounting points for the upper rej
taining straps of child restraint systems are only provided for these retaining straps. Whenother objects are mounted, the anchors can bedamaged. There is a risk of property damage.
Only mount child restraint systems to the upj per retaining straps.'

Locking
the
doors
and
windows
in
the
rear
Rear
doors
Push the locking lever on the rear doors down.
The door can now be opened from the outside only.
Safety
switch
for
the
rear Press button on the driver's door.
The LED lights up if the safety funcj
tion is switched on.
This locks various functions so that they canj
not be operated from the rear.
Seite 68ControlsTransporting
children
safely68
Online Edition for Part no. 01402977904 - II/17

DrivingVehicle
features
and
options
This chapter describes all standard, country- specific and optional features offered with theseries. It also describes features that are notnecessarily available in your vehicle, e. g., due
to the selected options or country versions.
This also applies to safety-related functions
and systems. When using these functions and systems, the applicable laws and regulations
must be observed.
Start/Stop
buttonConcept Pressing the Start/Stop button
switches the ignition on or off
and starts the engine.
Steptronic transmission: the enj gine starts with the brake pedal
pressed when you press the Start/Stop button.
Ignition
on Steptronic transmission: press the Start/Stopbutton, and do not press on the brake pedal atthe same time.
All vehicle systems are ready for operation.
Most of the indicator/warning lights in the inj
strument cluster light up for a varied length of
time.
To save battery power when the engine is off,
switch off the ignition and any unnecessary
electronic systems/power consumers.
Ignition
offSteptronic transmission: press the Start/Stopbutton again without stepping on the brake.
All indicator lights in the instrument cluster go
out.To save battery power when the engine is off,
switch off the ignition and any unnecessary
electronic systems/power consumers.
Safety
measures
When switching off the ignition, the selector
lever position P is selected automatically if the
selector lever position D or R is selected.
The ignition is switched off automatically in the
following situations while the vehicle is stationj
ary and the engine is off:'yWhen locking the vehicle, and when the
low beams are switched on.'yShortly before the battery is discharged completely, so that the engine can still be
started.'yWhen opening or closing the driver door, if
the driver's safety belt is unbuckled and
the low beams are switched off.'yWhile the driver's safety belt is unbuckled with driver's door open and low beams off.
The low beams switch to parking lights after
some minutes of no use.
Radio-ready
state
General
information
In the radio-ready state, certain power conj sumers remain ready for operation.
ActivatingWith the engine running, press the Start/Stop
button.
If the engine is not running and the ignition is switched on: the system automatically actijvates radio-ready state when the door is
opened if the lights are switched off or the dayj
time running lights are switched on.
Seite 69DrivingControls69
Online Edition for Part no. 01402977904 - II/17

The radio-ready state remains active if, for inj
stance the ignition is automatically switched
off for the following reasons:'yOpening or closing the driver's door.'yUnfastening of the driver's safety belt.'yWhen automatically switching from low
beams to parking lights.
Switching
off
automatically
The radio-ready state is switched off automatijcally in the following situations:
'yIf the ignition is switched off manually with
the Start/Stop button.'yAfter approx. 8 minutes.'yWhen the vehicle is locked using the cenj
tral locking system.'yShortly before the battery is discharged completely, so that the engine can still be
started.
Starting
the
engine
Safety
information DANGER
If the exhaust pipe is blocked or ventilaj
tion is insufficient, harmful exhaust gases can enter into the vehicle. The exhaust gases conjtain pollutants which are colorless and odorj
less. In enclosed areas, exhaust gases can also
accumulate outside of the vehicle. There is
danger to life. Keep the exhaust pipe free and ensure sufficient ventilation.'

WARNING
An unsecured vehicle can begin to move
and possibly roll away. There is a risk of an acj
cident. Before exiting, secure the vehicle
against rolling.
In order to ensure that the vehicle is secured against rolling away, observe the following:'ySet the parking brake.'yOn uphill grades or on a downhill slope,
turn the front wheels in the direction of the
curb.'yOn uphill grades or on a downhill slope,
also secure the vehicle, e.g., with a wheel chock.'

'yThe engine is not yet at operating temperjature.'yThe wheels are at a sharp angle or the
steering wheel is being turned.'yAfter driving in reverse.'yFogging of the windows when the autoj matic climate control is switched on.'yVehicle battery is heavily discharged.'yAt higher elevations.'yThe hood is unlocked.'yHDC Hill Descent Control is activated.'yThe parking assistant is activated.'yStop-and-go traffic.'ySelector lever in selector lever position N,
M/S or R.'yUse of fuel with high ethanol content.
Starting
the
engine
The engine starts automatically under the foljlowing conditions:
'ySteptronic transmission: by releasing the
brake pedal.
When Automatic Hold is activated: press the accelerator pedal.
After the engine starts, accelerate as usual.
Safety
mode
After the engine switches off automatically, it will not start again automatically if any one of the following conditions are met:
'yThe driver's safety belt is unbuckled and
the driver's door is open.'yThe hood was unlocked.
Some indicator lights light up for a varied length of time.
The engine can only be started via the Start/
Stop button.
Functional
limitations
Even if driving off was not intended, the deactij
vated engine starts up automatically in the folj lowing situations:'yExcessive warming of the car's interiorwhen the air conditioning is switched on.'yThe steering wheel is turned.'ySteptronic transmission: change from sejlector lever position D to R, N or M/S.'ySteptronic transmission: change from sejlector lever position P to N, D, R or M/S.'yFogging of the windows when the autojmatic climate control is switched on.'yVehicle battery is heavily discharged.'yExcessive cooling of the car's interior when
the heating is switched on.
Activating/deactivating
the
system
manually
Using
the
button
Press button.
'yLED comes on: auto Start/Stop function is deactivated.
The engine is started during an automatic engine stop.
The engine can only be stopped or started
via the Start/Stop button.'yLED goes out: auto Start/Stop function is activated.Seite 72ControlsDriving72
Online Edition for Part no. 01402977904 - II/17