2018 BMW 5 SERIES Owners Manual

Tow
fitting
General
information
The screw-in tow fitting should always be carried
in the vehicle.
The tow fitting can be screwed in at the front or
rear of the vehicle.
The tow fitting is found in the onboard vehicle tool kit, refer to page 340.
'xUse only the tow fitting provided with the vej
hicle and screw it all the way in.'xUse the tow fitting for towing on paved roadsonly.'xAvoid lateral loading of the tow fitting, for inj
stance do not lift the vehicle by the tow fitj ting.
Safety
information
NOTE
If the tow fitting is not used as intended, there
may be damage to the vehicle or to the tow fitj ting. There is a risk of damage to property. Folj
low the notes on using the tow fitting.
Screw
thread
for
tow
fitting
Press on the mark on the edge of the cover to
push it out.
Tow-starting
Do not tow-start the vehicle.
Start the engine by jump-starting, refer to
page 350, if possible.
Have the reasons for the starting difficulties corj
rected by a dealerss service center or another qualified service center or repair shop.
Seite 353Breakdown
assistanceMOBILITY353
Online Edition for Part no. 01402989478 - II/18

CareVehicle
features
andoptions
This chapter describes all standard, country-spejcific and optional features offered with the series. It also describes features that are not necessarilyavailable in your vehicle, e. g., due to the selectedoptions or country versions. This also applies to
safety-related functions and systems. When usj
ing these functions and systems, the applicable laws and regulations must be observed.
Washing
the
vehicle
General
information
Regularly remove foreign objects such as leaves
in the area below the windshield when the hood
is raised.
Wash your vehicle frequently, particularly in winj
ter. Intense soiling and road salt can damage the
vehicle.
Steam
blaster
and
high-pressure
washer
Safety
information
NOTE
When cleaning with high-pressure washers,
components can be damaged due to the presj sure or temperatures being too high. There is a
risk of damage to property. Maintain sufficient
distance and do not spray too long continuj
ously. Follow the operating instructions for the
high-pressure washer.
Distances
and
temperature'xMaximum temperature: 140 

Driving
into
a
vehicle
wash
with
a
Steptronic
transmission
Safety
information
NOTE
Selector lever position P is automatically enj
gaged when standby state is switched off.
There is a risk of damage to property. Do not switch standby state off in vehicle washes.
General
information
In a vehicle wash, the vehicle must be able to roll freely.
Roll or push the vehicle, refer to page 136.
Some vehicle washes do not permit persons in
the vehicle. The vehicle cannot be locked from the outside when in selector lever position N. A
signal sounds when an attempt is made to lock the vehicle.
Driving
out
of
a
vehicle
wash Make sure that the remote control is in the vehijcle.
Switch on drive-ready state, refer to page 123.
Headlights Do not rub wet headlights dry and do not use
abrasive or acidic cleaning agents.
Soak areas that have been dirtied, for instance
from insects, with shampoo and wash off with
water.
Thaw ice with de-icing spray; do not use an ice
scraper.
After
washing
the
vehicle
After washing the vehicle, apply the brakes
briefly to dry them; otherwise, braking action can
be reduced. The heat generated during braking
dries brake discs and brake pads and protects
them against corrosion.
Completely remove all residues on the windows,
to minimize loss of visibility due to smearing and
to reduce wiper noises and wiper blade wear.
Vehicle
care
Vehicle
care
products
General
information
BMW recommends using vehicle care and
cleaning products from BMW. Suitable care products are available from a dealerss service
center or another qualified service center or rej
pair shop.
Safety
information
WARNING
Cleansers can contain substances that are danj gerous and harmful to your health. There is a
risk of injury. When cleaning the interior, open
the doors or windows. Only use products inj tended for cleaning vehicles. Follow the inj
structions on the container.
Vehicle
paint
General
information Regular care contributes to driving safety and
value retention. Environmental influences in
areas with elevated air pollution or natural conj
taminants, such as tree resin or pollen can affect the vehicle's paintwork. Tailor the frequency and
extent of your vehicle care to these influences.
Aggressive substances such as spilled fuel, oil,
grease or bird droppings, must be removed imj
mediately to prevent the finish from being altered
or discolored.
Matte
finish Only use cleaning and care products suitable forvehicles with matte finish.
Seite 355CareMOBILITY355
Online Edition for Part no. 01402989478 - II/18

Leather
care
Remove dust from the leather regularly, using a cloth or vacuum cleaner.
Otherwise, particles of dust and road grime chafe
in pores and folds, and lead to increased wear and premature degradation of the leather surj
face.
To guard against discoloration, such as from
clothing, clean leather and provide leather care
roughly every two months.
Clean light-colored leather more frequently bej
cause soiling on such surfaces is substantially more visible.
Use leather care products; otherwise, dirt and
grease will gradually break down the protective
layer of the leather surface.
Upholstery
material
care
General
information Vacuum the upholstery regularly with a vacuum
cleaner.
If upholstery is very dirty, for instance with beverj age stains, use a soft sponge or microfiber clothwith a suitable interior cleaner.
Clean the upholstery down to the seams using
large sweeping motions. Avoid rubbing the maj terial vigorously.
Safety
information
NOTE
Open Velcron fasteners on articles of clothing can damage the seat covers. There is a risk of
damage to property. Ensure that any Velcron
fasteners are closed.
Caring
for
special
components
Light-alloy
wheels When cleaning the vehicle, use only neutral
wheel cleaners having a pH value from 5 to 9. Do
not use abrasive cleaning agents or steam jets
above 140 

with a microfiber cloth. Dampen cloth lightly
with water.
Plastic components are e.g.:'xImitation leather surfaces.'xRoofliner.'xLight lenses.'xMatt black spray-coated components.'xPainted parts in the car's interior.
Clean with a microfiber cloth.
Dampen cloth lightly with water.
Do not soak the roofliner.
Safety
belts
WARNING
Chemical cleansers can destroy the safety belt webbing. Missing protective effect of the safety
belts. There is a risk of injuries or danger to life. Use only a mild soapy solution for cleaning thesafety belts.
Dirty belt straps impede the reeling action andthus have a negative impact on safety.
Use only a mild soapy solution for cleaning the installed belt straps.
Safety belts should only be allowed to retract if
they are dry.
Carpets
and
floor
mats
WARNING
Objects in the driver's floor area can limit the pedal distance or block a depressed pedal.
There is a risk of an accident. Stow objects in
the vehicle such that they are secured and canj not enter into the driver's floor area. Use floor
mats that are suitable for the vehicle and can
be safely attached to the floor. Do not use
loose floor mats and do not layer several floor
mats. Make sure that there is sufficient clearj ance for the pedals. Ensure that the floor mats
are securely fastened again after they were rejmoved, for instance for cleaning.
The floor mats can be removed from the car's inj
terior for cleaning.
If the floor carpets are very dirty, clean with a mij crofiber cloth and water or a textile cleaner. To prevent matting of the carpet, rub back and forth
in the direction of travel only.
Sensor/camera
lenses To clean sensors and camera lenses, use a clothmoistened with a small amount of glass deterj
gent.
Displays,
screens,
and
protective
glass
of
the
Head-up
Display
NOTE
Chemical cleansers, moisture or fluids of any kind can damage the surface of displays and screens. There is a risk of damage to property.Clean with a clean, antistatic microfiber cloth.
NOTE
The surface of displays can be damaged with
improper cleaning. There is a risk of damage to
property. Avoid pressure that is too high and do
not use any scratching materials.
Clean with a clean, antistatic microfiber cloth.
Clean the protective glass of the Head-up Disj play, refer to page 157, using a microfiber cloth
and commercially available dish-washing soap.
Long-term
vehicle
storage When the vehicle is shut down for longer thanthree months, special measures must be taken.
Further information is available from a dealerss
service center or another qualified service center
or repair shop.
Seite 357CareMOBILITY357
Online Edition for Part no. 01402989478 - II/18

358
Online Edition for Part no. 01402989478 - II/18

REFERENCE
Technical
data
..........................................................................................
360 Appendix
...................................................................................................
363
Everything
from
A
to
Z
............................................................................
370359
Online Edition for Part no. 01402989478 - II/18

Technical
dataVehicle
features
andoptions
This chapter describes all standard, country-spejcific and optional features offered with the series.
It also describes features that are not necessarily available in your vehicle, e. g., due to the selectedoptions or country versions. This also applies to
safety-related functions and systems. When usj
ing these functions and systems, the applicable laws and regulations must be observed.
General
information
The technical data and specifications in this
Owner's Manual are used as guidance values.
The vehicle-specific data can deviate from this,
for instance due to the selected special equipj
ment, country version or country-specific measjurement method. Detailed values can be found in
the approval documents, on labels on the vehicle
or can be obtained from a dealerss service center
or another qualified service center or repair shop.
Dimensions
The dimensions can vary depending on the model version, equipment or country-specificmeasurement method.
The specified heights do not take into account
attached parts, for instance a roof antenna, roofracks or spoiler. The heights can deviate, for inj
stance due to the selected special equipment,
tires, load and chassis version. BMW
5
Series
SedanWidth with mirrorsinches/mm83.7/2,126Width without mirrorsinches/mm73.5/1,868Heightinches/mm57.8-58.2/1,467-1,479Lengthinches/mm194.6-195.4/4,943-4,962Wheelbaseinches/mm117.1/2,975Smallest turning radius diam.ft/m39.6-40.2/12.1-12.2Seite 360REFERENCETechnical
data360
Online Edition for Part no. 01402989478 - II/18