2018 AUDI Q7 wiper fluid

Cl a:, ......
Audi Service Faci lity immediately to have the
malfunction corrected.
f Engine warm-up request
n Plea se drive to warm up eng in e
Fu el has en tered the eng ine oi l, ei ther from low
outside temperat ures or freq uent short drives.
Drive unti l the engine is warm so that t he fue l in
the eng ine oi l will evaporate. Avoid high engine
speeds, fu ll acce lerating and heavy eng ine loads
when doing this.
Bu Tank system
11D Plea se r efuel
If the indicator lig ht turns on for the first time
and the message appea rs, there are about 2.6
gallons (10 liters) of fue l left in the tank .
liJl Please refuel immediately
If t he in dicator lig ht tu rns on the message ap ­
pears, t he f ue l tank is almost empty. Re fuel t he
veh icle immediate ly.
11D Tank sy ste m : malfun ction! Please conta ct
Service
There is a malfunction in the fue l tank system .
Drive to an authori zed Aud i de aler or aut hori zed
Aud i Service Faci lity immediately to have the
malfunct ion corrected .
(D Tips
For more information on fueling, see
¢page 312.
~ Washer fluid level
1:2 Plea se add washer fluid
F ill the washer f luid for the w indshield washer
system and the headlight washer system* when
the ign ition is switched off¢
page 328 .
,s;::>, Windshield wipers
~ f·-P Windshield wipers: malfunc tion! Please con -,.....
g tact Service
::r ' Cockpit o ver view
The re is a ma lfunction w ith the windshield wip­
ers.
Dr ive to an author ized A udi dealer or au tho riz ed
A udi Se rvice Faci lity immed iate ly to have the
malfunction corrected.
d Driver 's door
II Dri ver 's door : malfunction! Shift to P before
leaving vehicle. See owner's manual
T he re is a ma lfunction in the driver 's doo r. Se lect
the "P " selector lever pos ition to secure the vehi ­
cle.
Drive to an au thor ized A udi dealer or au tho riz ed
A udi Service Facility immed iate ly to have the
malfunction corrected.
· ;<;X · Bulb failure indicator
If the II ind icator light turns on, a bulb has
failed. The message indicates the location of the
bulb. Replace the bulb immediately .
Vehicle lights: malfunction! Please contact
Service
The re is a m alfu nct ion in the headlights o r the
li ght sw itch . Drive to an authorized Audi dealer or
a uthorized Audi Service Facility immediately to
have the malfunction corrected.
A WARNING "---
- Light bulbs a re under p ressure and can ex­
p lode when bulbs are replaced, wh ich in­
creases the risk of injury .
- W ith HID headlights (xenon headlights), the
h igh-vo ltage component must be handled
correct ly . Otherwise, there is a risk of fatal
in ju ry .
§.0 Dynamic headlight range control
II Headlight range control : malfunction! S ee
owner' s manual
There is a ma lfunction in the headlight range
contro l system, which may cause glare for other
drive rs . .,.
27

Cl a:, ...... N
" N ...... 0
0
::r ' from switching on unintentionally and caus­
ing damage to the windshie ld wiper system .
(D Tips
-The windshield wipers switch off when the
ignition is switched off . You can activate the
windshield wipers after the ignition is switched back on by moving the windsh ield
wiper lever to any posit ion.
- Worn or dirty windshield wiper blades result
in streaking. This can affect the rain sensor
funct ion. Check your windshield wiper
blades regularly.
- The washer fluid nozzles for the windshie ld
washer system are heated at low tempera­
tures when the ignition is on .
- When stopping temporarily, such as at a
traffic light, the speed of the windshield
wipers automatically reduces by one level.
Cleaning the wiper blades
Clean the wiper blades when you see wiper
strea ks. Use a soft clot h and a glass cleane r.
Windshield wiper
.. Place the windshield wiper arms in the service
pos ition
¢ page 51 .
.. Fold the w indshield wiper arms away from the
windshield .
Rear window wiper
.. Fold the w iper arm away from the rear window .
A WARNING
Dirty windshield wiper blades can impair v i­
sion, which increases the risk of an accident .
-
Lights and Vision
Replacing wiper blades
Fig. 46 Removing windshield wiper blades
Windshield wiper service position/blade
replacement position
.. To br ing the windsh ield w ipers into the serv ice
position , turn the ign ition off and move the
w indshie ld w iper lever into position@
¢ page 50, fig. 44.
.. To bring the windshie ld wip ers back to the nor­
mal position, switch the ignition on and hold
the windshield wiper lever in position @ until
the windshield wipers go back to the normal
position, or drive faster than 8 mph (12 km/h).
You can also turn the service position on or off in
the Infotainment system:
.. Switch the windshie ld wipers off (position @
¢page 50, fig. 44) .
.. Select: the I MENU I button >V ehicle > left con­
trol button
> Service & checks > Wiper change
position .
Removing the wiper blade
.. Fold the windshie ld wiper arm away from the
w indshield.
.. Press the locking knob
(D ¢ fig. 46 on the wiper
blade . Hold the wiper blade firmly.
.. Remove the w iper blade in the direction of the
arrow.
Installing the wiper blade
.. Insert the new wiper blade into the mount on
the wiper arm @until it clicks into place .
.. Place the wiper arm back on the windshield .
.. Turn the service position off.
51

Cl a:, ...... N
" N ...... 0
0
::r ' in the city and on curves or with a sporty driving
style.
Operating noise
Noises may occur when braking depending on the
speed , braking force and outside conditions such
as temperature and humidity.
Wet conditions or road salt
In certain situations, for example after driving
through water, in heavy ra in or after washing
your car, the braking effect may be reduced due
to moisture or ice on the brake rotors and brake
pads . The brakes must be "dried" first with a few
careful brake applications.
At higher speeds and with the windsh ie ld wipers
turned on, the brake pads press against the brake
rotors for a short amount of time. This action,
which is not felt by the driver, happens at regular
intervals and ensures a better reaction time for
the brakes in wet weather.
The braking effect can also be reduced if you are
driving on salted roads and you do not apply the
brakes for long periods of time . The layer of sa lt
on the brake rotors and pads must be worn off
first when the brakes are applied.
Corrosion
Leaving the vehicle parked for long periods of
time, low mi leage and avoiding heavy braking
can contribute to corrosion on the brake rotors
and to dirty brake pads.
If you usually avoid heavy braking or if there is
corrosion present, occasional heavy braking at
high speeds is recommended to clean the brake
rotors and pads¢
A.
Brake system malfunction
If you notice that the brake pedal travel has sud­
denly increased, then a brake circuit in the dual­
circuit brake system may have malfunctioned.
Drive to an authorized Audi dea ler or authorized
Audi Service Facility immediately to have the
problem corrected. On the way there, drive with
reduced speed and keep in mind that you will
need a longer distance to stop and you w ill need
to press the brake pedal harder .
Intelligent Technology
Low brake fluid level
When the brake fluid level is low, malfunctions in
the brake system may occur. The brake fluid level
is e lectronica lly monitored.
Brake booster
T he brake booster amplifies the pressure you ap­
ply to the brake pedal.
Ceramic brakes
Applies to: vehicles with ceramic brakes
Ceramic brakes provide excellent deceleration
rates .
The break-in period for new ceramic brakes may
be significantly longer than for standard brake
rotors. Due to the properties of the material,
they may cause noises at lower speeds. Ceramic
brakes also absorb more moisture in wet condi­
tions. Therefore, there will temporarily be less
braking force than when the brakes are dry. You
can compensate for this by pressing the brake
peda l harder.
& WARNING ~ -
- On ly app ly the brakes for the purpose of
cleaning the brake system when road and
traffic cond itions permit. You must not en­
danger other road users. This increases the
risk of an accident .
- Never let the vehicle roll while the engine is
stopped because this increases the risk of an
accident.
- Never place objects in the dr iver's footwell.
An object could end up in the area around
the pedals and prevent you from using
them. You would not be able to use the ped­
als if sudden driv in g or braking maneuvers
were needed, which increases the ris k of an
accident.
- Only use floor mats that do not obstruct the
area around the pedals and that can be se­
curely fastened in the footwells.
- To reduce the risk of injury, do not place
your foot under the brake pedal.
145

Checking and Filling
- Engine exhaust, some of its constituents,
and certain vehicle components contain or
emit chemicals known to the State of Cali­
forn ia to cause cancer and birth defects and
reproduct ive harm . In addition, certain flu­
ids contained in veh icles and certain prod­
ucts of compo nent wear contain or emit
chemicals known to the State of California
to cause cancer and birth defects or other reproductive harm .
- Battery posts, termina ls and related acces­
sories contain lead and lead compounds, chemicals known to the State of California
to cause cancer and reproductive harms.
Wash hands after handling .
(D Note
When filling flu ids, be sure not to mix the flu ­
ids up . Otherwise severe ma lfunctions and en­
gine damage w ill occur .
@ For the sake of the environment
You shou ld regularly check the ground under
your vehicle in order to detect leaks quickly. If
there are visible spots from oil or other fluids,
bring your vehicle to an authorized Audi deal­
er or author ized Audi Service Facility to be
checked .
Opening/closing the hood
The hood is released from inside the vehicle.
Fig . 261 D river footwell : release leve r
320
Fig. 262 Unlocked hood : lev er
Make sure the wiper arms are not raised up from
the windshie ld. Otherw ise the paint could be
damaged .
Opening the hood
"'With the driver's door open, pull the lever be ­
low the instrument panel in the direction of the
arrow ~
fig. 261 .
"' Raise the hood slightly~ &-
"' Press the lever~ fig. 262 in the direction of the
arrow. This releases the hooks .
"' Open the hood.
Closing the hood
"' Push the hood down until you over ride the
force of the struts .
"' Let the hood fall lightly into the latch .
Do not
press it in.
~ .&_ .
A WARNING
-Never open the hood when there is steam or
coo lant escaping from the engine compart­
ment, because there is a risk that you could
be burned. Wait until no steam or coolant is
escaping.
- For safety reasons, the hood must always be
closed securely while driving . Because of
this, always check the hood after closing it
to make sure it is latched correctly . The
hood is latched if the front corners canno t
be lifted .
- If you notice that the hood is not latched
while you are driving, stop immed iate ly and
close it, because driving when the hood is
not latched increases the r isk of an accident . ..,.