2017 VOLVO XC90 TWIN ENGINE HYBRID ECO mode

WHEELS AND TIRES
487
of the factory-mounted tires on your vehicle, aswell as load limits and inflation pressure.

NOTE
•The placard shown indicates inflationpressure for the tires installed on thevehicle at the factory only.
•A certain amount of air seepage from thetires occurs naturally and tire pressurefluctuates with seasonal changes in tem-perature. Always check tire pressure reg-ularly.
•Use a tire gauge to check the tire inflation
pressure, including the spare4, at least oncea month and before long trips. You arestrongly urged to buy a reliable tire pressuregauge, as automatic service station gaugesmay be inaccurate.
•Use the recommended cold inflation pres-sure for optimum tire performance and wear.
•Under-inflation or over-inflation may causeuneven treadwear patterns.

Checking tire pressure
1. Remove the cap from the valve on one tire,then firmly press the tire gauge onto thevalve.
2. Add air to reach the recommended air pres-sure.
3. Replace the valve cap.
CAUTION
•After inflating the tires, always reinstall thevalve cap to help avoid damage to thevalve from dirt, gravel, etc.
•Use plastic valve caps only. Metal capscould corrode and become difficult toremove.
4. Visually inspect the tires to make sure thereare no nails or other objects embedded thatcould puncture the tire and cause an air leak.
5.Check the sidewalls to make sure there areno gouges, cuts, bulges or other irregulari-ties.
6. Repeat this procedure for each tire, includingthe spare.

NOTE
If you overfill the tire, release air by pushingon the metal stem in the center of the valve.Then recheck the pressure with your tiregauge.
Changing tires
When changing wheels to another dimension,always follow Volvo's instructions.
When changing to tires of another
dimension
If you mount tires with a dimension other thanthe factory-installed tires, contact an authorizedVolvo retailer to update the vehicle's software.This may also be necessary when changing fromsummer to winter tires, or vice versa.

Related information
•Snow tires and chains (p. 485)
•Installing a wheel (p. 491)
•Removing a wheel (p. 489)
4Not available in all models.

WHEELS AND TIRES
* Option/accessory, for more information, see Introduction.488
Tools
Tools for e.g., changing wheels, etc. are locatedunder the cargo compartment floor.
The foam block under the cargo compartmentfloor contains the towing eyelet, the tool forremoving plastic wheel bolt covers, the jack* andthe lug wrench*. There is also a storage space forthe tool used to remove locking wheel bolts.

Related information
•Jack (p. 488)
•Changing tires (p. 487)
Jack
The jack is used to raise the vehicle, for examplewhen mounting winter wheels, etc.
WARNING
•The jack must correctly engage the jackattachment.
•Be sure the jack is on a firm, level, non-slippery surface.
•Never allow any part of your body to beextended under a vehicle supported by ajack.
•Use the jack intended for the vehiclewhen changing a tire. For any other job,use stands to support the vehicle.
•Apply the parking brake and put the gearselector in the Park (P) position.
•Block the wheels standing on the ground,use rigid wooden blocks or large stones.
•The jack should be kept well-greased andclean, and should not be damaged.
•No objects should be placed between thebase of jack and the ground, or betweenthe jack and the attachment bar on thevehicle.
CAUTION
•When not in use, the jack* should be keptin its storage compartment under thecargo compartment floor.
•The jack provided with your vehicle isintended to be used only in temporary sit-uations such as changing wheels in theevent of a flat tire. Only the jack thatcame with your particular model shouldbe used to lift the vehicle. If the vehicleneeds to be lifted more frequently or for aprolonged period, using a garage jack orhoist is recommended. Always follow thisdevice

||
WHEELS AND TIRES
490

NOTE
The jack provided with your vehicle isintended to be used only in temporary situa-tions such as changing wheels in the event ofa flat tire. Only the jack that came with yourparticular model should be used to lift thevehicle. If the vehicle needs to be lifted morefrequently or for a prolonged period, using agarage jack or hoist is recommended. Alwaysfollow this device

||
WHEELS AND TIRES
492
the inflation pressure recommended by the vehi-cle manufacturer on the vehicle placard or tireinflation pressure label. (If your vehicle has tiresof a different size than the size indicated on thevehicle placard or tire inflation pressure label, youshould determine the proper tire inflation pres-sure for those tires.)
As an added safety feature, your vehicle hasbeen equipped with a tire pressure monitoringsystem (TPMS) that illuminates a low tire pres-sure telltale when one or more of your tires issignificantly under-inflated. Accordingly, when thelow tire pressure telltale illuminates, you shouldstop and check your tires as soon as possible,and inflate them to the proper pressure.
Driving on a significantly under-inflated tire cau-ses the tire to overheat and can lead to tire fail-ure. Under-inflation also reduces fuel efficiencyand tire tread life, and may affect the vehicle'shandling and stopping ability. Please note thatthe TPMS is not a substitute for proper tire main-tenance, and it is the driver's responsibility tomaintain correct tire pressure, even if under-infla-tion has not reached the level to trigger illumina-tion of the TPMS low tire pressure telltale.
Your vehicle has also been equipped with aTPMS malfunction indicator to indicate when thesystem is not operating properly. The TPMS mal-function indicator is combined with the low tirepressure telltale.
When the system detects a malfunction, the tell-tale will flash for approximately one minute andthen remain continuously illuminated. Thissequence will continue upon subsequent vehiclestart-ups as long as the malfunction exists. Whenthe malfunction indicator is illuminated, the sys-tem may not be able to detect or signal low tirepressure as intended.
TPMS malfunctions may occur for a variety ofreasons, including the installation of replacementor alternate tires or wheels on the vehicle thatprevent the TPMS from functioning properly.Always check the TPMS malfunction telltale afterreplacing one or more tires or wheels on yourvehicle to ensure that the replacement or alter-nate tires and wheels allow the TPMS to con-tinue to function properly.

Messages in the instrument panel
When the TPMS symbol illuminates, the followingtext messages may also be displayed:
•Tire pressure low
•Tire pressure system Temporarilyunavailable
•Tire pressure system Service required
If TPMS cannot determine which tire(s) have lowinflation pressure:
•All four tires will be shown as affected in thecenter display
After changing wheels, always calibrate the sys-tem to avoid false warnings.
TPMS does not replace the need for regular tireinspection and maintenance.
NOTE
If you change to tires with a different dimen-sion than the factory-installed ones, theTPMS system must be calibrated for thesetires.
TPMS cannot be turned off.

WARNING
Incorrect inflation pressure could lead to tirefailure, resulting in a loss of control of thevehicle.

Related information
•Checking tire inflation pressure (p. 493)
•Reinflating tires equipped with the TirePressure Monitoring System (TPMS)(p. 494)
•Ignition modes (p. 400)

WHEELS AND TIRES
493
Checking tire inflation pressure
The Tire Pressure Monitoring System (TPMS)makes it possible to view the current inflationpressure status of all four tires.

Checking inflation pressure
Open the Car status app inthe center display's Applicationview. Tap Status to see thecurrent inflation pressure sta-tus of all four tires.
The on-screen graphic displays the inflation pres-sure status.
Status view. The illustration is generic and may vary frommodel to model or after a software update
Color indications:
Green: tire pressure is above the threshold for alow inflation pressure warning.
Yellow: low tire pressure.
•One yellow wheel: the tire indicated is under-inflated.
•All wheels yellow: two or more tires areunder-inflated.
Stop safely and check/reinflate the tire(s) assoon as possible. Calibrate TPMS after reinflatingthe tire(s).
All wheels gray:
•Calibration is underway
•Inflation pressure status is not known
It might be necessary to drive at a speed of atleast 20 mph (30 km/h) for several minutes forthe system to become operational.
All wheels gray combined with the messageTire pressure system Temporarilyunavailable and the TPMS symbol in the
instrument panel () remains illuminatedafter flashing for 1 minute: the system is tem-porarily unavailable. It should become operationalagain shortly.
All wheels gray combined with the messageTire pressure system Service required andthe TPMS symbol in the instrument panel
() remains illuminated after flashing for1 minute: the system is not functioning correctly.Have it checked by a trained and qualified Volvoservice technician.
Related information
•Calibrating the Tire Pressure MonitoringSystem (TPMS) (p. 495)
•Reinflating tires equipped with the TirePressure Monitoring System (TPMS)(p. 494)
•Tire Pressure Monitoring System (TPMS)(p. 491)

MAINTENANCE AND SERVICING
530
Replacing bulbs
The halogen headlight bulbs3 can be replacedby the owner.
Before the halogen headlight bulbs can bereplaced, that plastic covering over the headlighthousing has to be removed.

NOTE
Halogen headlights are not available on allmodels or in all markets.
Consult your Volvo retailer if you are uncertainabout the type of headlights in your vehicle.
To do so:
Lift the rubber strip by pressing in toward theengine compartment.
Release the pins in the plastic covering'sfour clips by pressing them down with ascrewdriver or similar object and remove thecovering.
The turn signal, high/low beam, Daytime RunningLight and parking light bulbs will be accessiblewhen the plastic covering has been removed.
Put the covering back in place in the reverseorder.
NOTE
The pins in the clips have to be pressed backcompletely before the clips are placed in theplastic covering.
When the covering is put back in place, thepins must be pressed so that their upper sur-face is flush with the surface of the clip.
3Halogen headlights are not available on all models.

||
MAINTENANCE AND SERVICING
538
Location of the jack attachment points (triangles)/lifting points (red areas)

NOTE
The jack provided with your vehicle isintended to be used only in temporary situa-tions such as changing wheels in the event ofa flat tire. Only the jack that came with yourparticular model should be used to lift thevehicle. If the vehicle needs to be lifted morefrequently or for a prolonged period, using agarage jack or hoist is recommended. Alwaysfollow this device

MAINTENANCE AND SERVICING
}}
541
cautions must be followed to preventinjury. Always turn the ignition off whenreplacing distributor ignition componentse.g. plugs, coil, etc.
•Do not touch any part of the distributorignition system while the engine is run-ning. This may result in unintended move-ments and body injury.
The layout of the engine compartment may differ slightlyfrom model to model
Coolant expansion tank
Brake fluid reservoir
Washer fluid reservoir
Relay/fuse box
Air cleaner
Engine oil filler cap

Related information
•Ignition modes (p. 400)
•Opening and closing the hood (p. 539)
•Refilling the windshield washer fluid reservoir(p. 547)
Engine oil
The correct oil must be used for the stated oilchange (service) intervals to apply.
Volvo recommends: