Page 302 of 668
302 
2-5. Using other driving systems
VERSO_EE_OM64517E
Display 
When the sensors detect an obstacle, the Toyota parking assist-sen- 
sor indicator is illuminated by an LED depending on position and dis- 
tance to the obstacle. 
Front center sensor operation 
Front corner sensor operation
Rear corner sensor operation 
Rear center sensor operation 
The light comes on to indicate 
that the system is operating
The distance display and buzzer 
When a sensor detects an obstacle, the direction of and the approxi- 
mate distance to the obstacle are displayed and the buzzer sounds. 
■ Sensor operation and distance to an obstacle 
The system operates when the vehicle approaches an obstacle, as 
shown by the following table. 
         
        
        
     
        
        Page 314 of 668
314 
2-5. Using other driving systems
VERSO_EE_OM64517E
■ If the Stop & Start cancel indicator continues to flash 
The Stop & Start system may be malfunctioning. Contact any authorized 
Toyota dealer or repairer, or another duly qualified and equipped profes-
sional. 
■ If the windshield is fogged up while the engine is stopped by the Stop 
& Start system 
● Vehicles with a manual air conditioning system: Restart the engine by 
depressing the clutch pedal ( P. 309) or by pressing the Stop & Start 
cancel switch, and then set the air outlet selection dial to  . ( P. 341) 
● Vehicles with an automatic air conditioning system: Turn the windshield 
defogger on. (The engine will start due to the automatic engine start func-
tion.) ( P. 350) 
If the windshield fogs up frequently, press the Stop & Start cancel switch to 
deactivate the system. 
■ The Stop & Start system operation time and Stop & Start system total 
operation time display 
 P. 224 
■ Replacing the battery 
 P.  6 1 1 
         
        
        
     
        
        Page 317 of 668
317 
2-5. Using other driving systems
2
When driving
VERSO_EE_OM64517E
When the TRC and VSC+ are operating 
If the vehicle is in danger of slip- 
ping or if the front wheels spin,
the slip indicator light flashes to 
indicate that the TRC/VSC+ sys- 
tems are operating.
To disable TRC and/or VSC+ 
If the vehicle gets stuck in fresh snow or mud, the TRC and VSC+ 
systems may reduce power from the engine to the wheels. You may
need to turn the system off to enable you to rock the vehicle in order 
to free it. 
■ Turning off TRC 
Quickly push and release the 
button to turn off TRC.
A message will be shown on the 
multi-information display. 
Push the button again to turn the 
system back on. 
         
        
        
     
        
        Page 318 of 668

318 
2-5. Using other driving systems
VERSO_EE_OM64517E 
■ Turning off TRC and VSC+ 
Push and hold the button for 
more than 3 seconds while the
vehicle is stopped to turn off 
TRC and VSC+.
A message will be shown on the 
multi-information display and the
VSC OFF indicator will come on. 
Push the button again to turn the 
system back on. 
On vehicles with pre-collision sys- 
tem, pre-collision brake assist
and pre-collision braking will also
be disabled. The PCS warning
light will come on. ( P. 282)
■Automatic reactivation of TRC and VSC+ 
Vehicles without smart entry & start system 
Turning the engine switch off after turning off the TRC and VSC+ systems 
will automatically re-enable them. 
Vehicles with smart entry & start system 
Turning the “ENGINE START STOP” switch off after turning off the TRC 
and VSC+ systems will automatically re-enable them. 
■ Automatic TRC reactivation 
If only the TRC system is turned off, the TRC system will turn on when vehi- 
cle speed increases. 
■ Automatic TRC and VSC+ reactivation 
If the TRC and VSC+ systems are turned off, the systems will not turn on 
even when vehicle speed increases. 
         
        
        
     
        
        Page 346 of 668
346
3-1. Using the air conditioning system and defogger
VERSO_EE_OM64517E
Automatic air conditioning system
Using the automatic mode 
Press .
The air conditioning system will begin to operate. Air outlets and fan 
speed are automatically adjusted according to the temperature set- 
ting.
Press “ ” to increase the temperature and “” to decrease the 
temperature on   (left-hand drive vehicles) or   (right- 
hand drive vehicles) on the driver side.
The temperature for the driver and front passenger seats can be set 
separately. ( P. 347)
: If equipped
Airflow and outlets are automatically adjusted according to the tem- 
perature setting.
Outside recirculated  air mode button 
Temperature display 
Temperature  control  button 
Air outlet display 
Dual mode button 
Air conditioning  on/off button Air outlet selection button 
Automatic mode button 
Fan speed display 
Temperature  controlbutton 
Temperature  display 
Fan speed control button “OFF” button 
Windshield defogger button 
         
        
        
     
        
        Page 347 of 668

347 
3-1. Using the air conditioning system and defogger
3
Interior features
VERSO_EE_OM64517E 
■ Automatic mode indicator 
If the fan speed setting or air flow modes are operated, the auto- 
matic mode indicator goes off. However, automatic mode for func- 
tions other than that operated are maintained.
Adjusting the settings 
■ Adjusting the temperature setting 
Press “ ” to increase the temperature and “” to decrease the tem- 
perature on   (left-hand drive vehicles) or   (right-hand 
drive vehicles) on the driver side.
Press “ ” (increase) or “” (decrease) on  (left-hand drive vehicles) 
or   (right-hand drive vehicles) on the passenger side to separately 
adjust the temperature for the passenger and driver sides (individual 
mode). Press  to return the driver and passenger side tempera- 
tures to the same setting (simultaneous mode). 
The air conditioning system switches between individual and simultane- 
ous modes each time  is pressed. 
■ Adjusting the fan speed 
Press “ ” (decrease) or “” (increase) on  .
The fan speed is shown on the display. (7 levels) 
Press   to turn the fan off. 
         
        
        
     
        
        Page 359 of 668
359
3-2. Using the audio system
3
Interior features
VERSO_EE_OM64517E
Using the radio
Setting station presets 
In AF-ON mode the radio changes frequency to the strongest signal 
of the selected station. 
Search for desired stations by turning   or pressing “”or
“ ” on  . 
Press and hold the button (from   to  ) the station is to be 
set to until you hear a beep.
: If equipped 
Power Volume 
Station selector 
Back button 
Adjusting the  frequency or  selecting items 
AM mode button 
AF/region code/ TA mode setup 
Seeking the  frequency
Displays station list
FM mode button 
         
        
        
     
        
        Page 360 of 668
360 
3-2. Using the audio system
VERSO_EE_OM64517E
Using the station list 
■ Updating the station list 
Press .
The station list will be displayed.
Press   (Update) to update the list.
“Updating” is displayed while the searching is in process, and then 
available stations will be listed on the display. 
To cancel the updating process, press  .
■ Selecting a station from the station list 
Press .
The station list will be displayed.
Turn   to select a station. 
Press   to tune in the station.
To return to the previous display, press  .
RDS (Radio Data System) 
This feature allows your radio to receive station. 
■ Listening to stations of the same network 
Press . 
Turn   to “RADIO” and press  . 
Turn   as corresponds to the desired mode: “FM AF” or 
“Region code”.