2017 TOYOTA PROACE VERSO Owners Manual

105
Captain seat(s) on rails
The different equipment and adjustments described hereafter vary according to the version and configuration of your vehicle.
F To raise a head restraint, pull it up until it engages in its notch.F To remove it press the lug A and pull the head restraint up.F To refit it, engage the head restraint rods in the apertures keping them in line with the seat backrest.F To lower it, press on the lug A and on the head restraint at the same time.
Head restraints
The armrest has notches.F Pull the armrest fully up.F Lower it fully down.F Raise the armrest to the desired position.
Ar mrest(s)
It can be placed forward facing or rearward facing.
The captain seat is fitted with a three-point inertia reel seat belt.
For more information on the Seat belts, refer to the corresponding section.
3
Ease of use and comfort

106
Folding the seat backrest to
the table position
F Place the head restraints in the low position.
Moving forward or backward
Two controls are provided for moving the seat forward and backward:F From the front, raise the control and slide the seat for ward or back.F From the rear, pull the strap without going beyond the point of resistance and push the seat for ward or pull it back.
Reclining the backrest
The reclining backrest can be adjusted to several positions.
F To recline the backrest, raise the control (from the rear, lower the lever).F Release the control when the desired position is obtained.
F From the front, raise the handle to release the backrest.F From the rear, lower the handle to release the backrest.F Fold the backrest onto the cushion.
Ease of use and comfort

107
Removing a seat
F Move the seat for ward for access to the strap.F Fold the backrest to the table position.
Do not use the strap to lift seat.Do not use the strap to lift the seat.
Before refitting a seat to the vehicle, pull the strap fully to ensure that the latching mechanism has engaged.
F From the rear, pull the strap, going beyond the point of resistance, to free the anchorages and tip the seat for ward to the vertical position.F Take the seat out through the sliding door in row 2 or from the rear in row 3.
Refitting a seatIf removing and storing a seat out of the vehicle, ensure that it is placed in a clean area, so as to avoid introducing any foreign bodies into the mechanisms.
The seats are not designed for any use other than in the vehicle. They have mechanisms and functions that could be damaged if used incorrectly or are dropped.
3
Ease of use and comfort

108
Ensure that no object, or the feet of a passenger seated at the rear, could obstruct the anchorage points or prevent the correct latching of the assembly.
Check that seat engages correctly in the floor when it is returned to the seating position.
F Slide the seat for ward or back until it engages in the notches.F Straighten the backrest.
F Check that nothing is obstructing the rails.
F Place the front of the guides on the rails.F Tip the seat back to align the rear of the guides with the rails.
Ease of use and comfort

109
Precautions for the
seats and bench
seats
Following the various handling operations:- do not remove a head restraint without storing it and fixing it to a support,- check that the seat belts are always accessible to the passenger and easy to fasten,- a passenger must not take their seat without adjusting the seat's head restraint correctly and adjusting and fastening the seat belt.
Loading luggage or objects
behind the row 3 seat and
bench seat
If you want to load luggage onto the backrests in row 3 while in the table position, the backrests in row 2 must also be in the table position.
Labels
When driving, carrying a passenger is prohibited:- in row 3 if the backrest in front (row 2) is in the table position.
- in row 3 if the seat /bench in front (row 2) is in the fully folded position.- in rows 2 and 3, in the outer right seat, if the bench is in the fully folded position,- on the centre seat if the outer right seat is in the fully folded position.
3
Ease of use and comfort

110
Mats
When fitting the mats for the first time, on the driver's side use only the fixings provided in the wallet attached.
Fitting
Removal
To avoid any risk of jamming of the pedals:- only use mats which are suited to the fixings already present in the vehicle; these fixings must be used,- never fit one mat on top of another.The use of mats not approved by Toyota may inter fere with access to the pedals and hinder the operation of the cruise control / speed limiter.The mats approved by Toyota have two fixings located below the seat.
To remove the mat on the driver's side:F move the seat as far back as possible,F unclip the fixings,F remove the mat.
Interior fittings
In rows 2 and 3
Refitting
To refit the mat on the driver's side:F position the mat correctly,F refit the fixings by pressing,F check that the mat is secured correctly.
Use the Velcros to fit the transverse mats in row 2 with the longitudinal mats in rows 2 and 3.
Ease of use and comfort

111
Lower glove boxUpper glove box
It can hold a water bottle, the vehicle's handbook pack...It houses the passenger's front airbag deactivation switch and can hold a water bottle, the vehicle's handbook pack...
With air conditioning, it gives access to the ventilation nozzle, delivering the same air-conditioned air as the vents in the passenger compartment.
While driving, keep the glove boxes closed. Otherwise there is a risk of injury in the event of an accident or sudden braking.
Sun visor
The sun visors provide protection from the sun from the front or the side and have an illuminated vanity mirror (depending on ve r s i o n).A pocket is provided on the driver's sun visor to hold toll tickets, receipts, ...
F With the ignition on, raise the concealing flap; the mirror is illuminated automatically.
F To open the glove box, pull the handle towards you.
F To open the glove box, press the left hand end of the control and guide the lid to its open position notch.If is so equipped, it is illuminated when the lid is opened.
3
Ease of use and comfort

112
Fold-up tables
Fitted to the back of each front seat, these allow you to place objects.
On the passenger side, do not forget to fold the fold-up table before placing the seat in the table position.Do not place hard or heavy objects on the table. They could become dangerous projectiles in the event of emergency braking or impact.
For more information on the Front
seats and in particular the "table" position for the backrest, refer to the corresponding section.
Upper storage compartmentFront door pockets
Liquids carried in an open vessel (a cup or mug) could be spilt, presenting a risk of damage on contact with the controls in the dashboard and centre console. Ta k e c a r e .
This is located in the dashboard, behind the steering wheel.
Press the control to open the lid (depending on version) then guide it to its fully open position.To close, guide the lid then press the centre g e nt l y.Any liquid which could spill risks causing an electrical short circuit and therefore a potential fire.
F To use the table, lower it fully until it locks in the low position.F To stow the table, raise it, passing the point of resistance, to the high position.
Ease of use and comfort