2017 TESLA MODEL S Owner's Manual (UK) 

Seating Larger Children
If a child is too large to
fit into a child safety
seat, but too small to safely fit into the
standard seat belts, use a booster seat
appropriate for the child

Installing ISOFIX Child Seats
Lower ISOFIX anchors are provided in the second row outboard seats. The anchors are
located between the seat

Once installed, test the security of theinstallation before seating a child. Attempt to twist the child safety seat from side to side
and try to pull it away from the seat, then
check that the anchors are still securely in
place.
Attaching Upper Tether Straps
If an upper tether strap is provided, attach its
hook to the anchor point located on the back
of the rear seats.
Always position single-strap tethers to run
over the top of the head support. For dual- strap tethers, position a strap on each side of
the head support.
Tighten upper tether straps according to the instructions provided by the manufacturer of
the child safety seat.
Note: To prevent the single-strap tether from
moving side to side, the top of the head
support deforms.
Note: The location of anchor points may not
be readily visible but can be found by
identifying a slice in the seat

integrated 5-point harness for as long as
possible.Warning: Do not use seat belt extenders
on a seat belt that is being used to install
a child safety seat or booster seat.Warning: When seating larger children,
make sure the child

Usage RestrictionsThe optional Tesla built-in rear facing childseats are child restraint systems and are
approved to United Nations ECE Regulation
R44.04 standards for use by children in Mass
Groups II and III, weighing 15 to 36 kg. These
seats must only be used for children who are
between 3 and 12 years old, and
98 to 135 cm tall.
Always ensure the top of the child

5. Raise the seat back to the upright positionand push until it locks into position.Visually check to ensure that the retaining
catches are engaged.
6. Check that the seat back and seat base are securely retained in the upright
position by trying to pull the seat back
toward you.
Folding
Caution: Before folding the seats, fasten
the seat belts to prevent them from
getting trapped in the seat mechanism
and being damaged.
1. Pull the handle to release the seat back and pull the seat back fully forward.
2. Push the lever to release the head
supports from the seat back, then fold
back onto the seat.
3. Secure the Velcro strap.
4. Pull the strap at the rear of the seat to fold the seat assembly into the trunk floor.
5. Replace the cover on the trunk floor.
Seating a Child
The Tesla built-in rear facing child seats are
child restraint systems and are approved to
United Nations ECE Regulation R44.04
standards for use by children in Mass Groups II
and III, weighing 15 - 36 kg. These seats must
only be used for children who are between 3
and 12 years old, and 98 - 135 cm tall.
Tesla Built-In Rear Facing Child Seats
30Model S Owner

Always ensure the top of the child

Warnings - Tesla Child SeatsWarning: The Tesla built-in rear facing
seats are child restraint systems and are
approved to United Nations ECE
Regulation R44.04 standards for use by
children in Mass Groups II and III,
weighing 15 to 36 kg. These seats must
only be used for children who are
between 3 and 12 years old, and
98 to 135 cm tall, provided the top of the
child