2017 SUBARU LEGACY lock

2
Remote keyless entry system
Remote
transmitter key
(if equipped) Access key
(if equipped)
Lock/Unlock doors
PANIC
basic ope
Ration
* Grip the driver’s door handle to unlock the
driver’s door. Grip the front passenger’s door
handle to unlock all doors.
All doors will be locked/unlocked by the following procedures carrying the access key on
your person. (The driver should always carry the access key.)
For detailed operating and safety information, please refer to
your o
wner’s Manual.
Keyless access function (if equipped)
Opening trunk:
Side door (front door handles only):
1
All doors will be locked.
2
The driver’s door will be unlocked.
(To unlock all doors, briefly press the button
a second time within 5 seconds.)
3
Press and hold to open the trunk.
4
The horn will sound and the hazard warning
flashes will flash.
23
4
1
1
2
3
4
Lock Unlock*
Door lock sensor
Grip
To u c h
Press
u Some functions are available on certain models.
u For detailed operating and safety information, please refer to your Own\
er’s Manual.

3
Ignition switch must be in ACC or ON position.
1
Select side to adjust
2
To adjust the mirror, move the switch in the
direction of your desired position.
a djust each component
1
Forward and backward adjustment
2
Seat cushion angle adjustment
3
Seat height adjustment
4
Seatback angle (reclining) adjustment
5
Lumber support adjustment (if equipped)
1
Forward and backward adjustment
2
Seat cushion height adjustment
(Driver's seat only)
3
Seatback reclining adjustment
Power seat (Driver’s seat-if equipped):
Manual seat (if equipped):

Front seat
Tilt/telescopic steering wheel
Remote control mirror switch
1
Adjust the seat position and pull the tilt/
telescopic lock lever down.
2
Move the steering wheel to the desired level.
3
Pull the lever up to lock the steering wheel in
place.
Make sure that the steering wheel is securely
locked by moving it up and down, and forward and
backward.
1
2
3
2
1
2
3
2
12
1
2
4
3
5

4
start/stop engine
To start engine:
STEP1: Carry the access key, and sit in the driver’s seat.
STEP2: Apply the parking brake.
STEP3: Shift the select lever in the P position.
STEP4: Depress the brake pedal until the indicator on
the push-button ignition switch turns green.
STEP5: While depressing the brake pedal, press the
push-button ignition switch.
To stop engine:
STEP1: Stop the vehicle completely.
STEP2: Move the select lever to the P position .
STEP3: Press the push-button ignition switch.
Every time the button is pressed without depressing the brake pedal, the\
power is switched
in the sequence of OFF
➞ACC
➞ON
➞OFF
.
OFF ( Tu r n e d o f f ) ACC (Orange) ON (Orange)
Change of the power supply (Without starting engine)
The key can be turned from ACC to LOCK
only when the key is pushed in while turning
it (all models) and the select lever is in the P
position (CVT models).
Push-button ignition switch (if equipped)
Electronic parking brake switch Ignition switch (if equipped)
*The design may be slightly different from the illustration
depending on the models.
Operation indicator
Apply
Release
X Some functions are available on certain models.
X For detailed operating and safety information, please refer to your Own\
er’s Manual.

8
1
Defroster button:
Press the button to defrost the windshield.
2
Rear window defogger button:
Press the button to turn on rear window defogger,
outside mirror defogger and windshield wiper deicer
(if equipped). The function will automatically shut off
after approximately 15 minutes.
*The illustration of the print is Type A.
Defroster button/Rear window defogger buttonE
Hood release knobG
1
Lock switch
2
For driver’s window
3
For front passenger’s window
4
For rear left passenger’s window
5
For rear right passenger’s window
Power window switchesH
Trunk lid opener switchF
12
124
53
Pull
Press and hold the
switch for more than
1 second.
0058 Some functions are available on certain models.
00030058 For detailed operating and safety information, please refer to your Own\
er’s Manual.

9
To unlock all doors To lock all doors
Power door locking switchI
Seat heater (if equipped)J
Front seat heater switch
1
HIGH mode indicator
2
MID mode indicator
3
LOW mode indicator
Audio control buttonsL
These buttons allow the driver to control audio functions
without taking his/her hands off the steering wheel.
Fuel filler lid release leverK
This indicates that the fuel filler door (lid) is
located on the right side of the vehicle.
Pull
Right side
11
22
33
Driver’s side Front passenger’s
side

10
Located on the edge of each rear door.
When the lever is in the LOCK position, the rear door
cannot be opened from the inside. Deactivate the Hill Holder function when:
• Towing a trailer
• Carrying a heavy load
• When you do not frequently stop your vehicle on an
uphill slope using the parking brake.
1
To lower:
Push the upper part of the anchor and slide it down.
2
To raise:
Slide the anchor up.
Tilting
Sliding
Moonroof switch (if equipped)
1
Raise
2
Lower
1
Open
2
Close
Child safety locks
Hill Holder switch
Front seat shoulder belt anchor height
*The design may be slightly different from the
illustration depending on the models.
21
2
1
2
1
Activate/
Deactivate
u Some functions are available on certain models.
u For detailed operating and safety information, please refer to your Own\
er’s Manual.

12
1
Cruise control main button: To activate and
deactivate
2
RES/SET switch:
▲RES/+ side : To increase the speed/To resume
▼SET/- side : To set speed/To decrease the speed
3
CANCEL button: To temporarily cancel
1
(Lane Keep Assist) switch
2
(Following distance setting) switch
3
RES/+ switch
4
SET/- switch
5
(CRUISE) switch
Cruise control enables you to maintain a constant vehicle speed without holding your foot on
the accelerator pedal and it is operative when the vehicle speed is 40 km/h (25 mph) or more.
EyeSight is a driving support system that uses a range of functions to assist the driver in
making decisions in order to provide for more safe and comfortable driving and to reduce
driver fatigue.

Cruise control buttons (if equipped)B
Information displayC
1
Clock
2
Climate control mode indicators
3
Outside temperature indicator
Control switch: To adjust the time shown by the clock,
press the + button or the - button.
OUT TEMP
PMMAX
A/C
Models without EyeSight system
Models with EyeSight system
1
1
23
4
5
2
3
123
Control
switch
u Some functions are available on certain models.
u For detailed operating and safety information, please refer to your Own\
er’s Manual.

17
Some warning/indicator lights illuminate for a few seconds in order to check themselves
when the ignition switch is turned ON.
Main W aR ninG an D inDicato R LiGH ts
Warning lights
Refer to your Owner’s Manual for countermeasures when each warning light comes on.
If necessary, consult your authorized SUBARU dealer.
Seatbelt warning
Remind the driver to fasten
seatbelt.
Front passenger’s seatbelt warning
Remind the front passenger to
fasten seatbelt. Location: next to
overhead console.
Oil pressure warning
The engine oil pressure is too
low.
Engine low oil level warning
The engine oil level decreases to
the lower limit.
All-wheel drive warning (CVT models)
Tires of different diameter fitted/
air pressure excessively low.
SRS airbag system warning
SRS airbag system and/
or seatbelt pretensioners
malfunction.
Power steering warning
The electric power steering
system malfunction.
AT OIL TEMP warning (CVT models)
Transmission fluid temperature
is too hot./Transmission control
system malfunction.
Brake system warning
Electronic parking brake system malfunction/Brake fluid level/EBD System
malfunction (Anti-lock brake system warning light illuminates simultaneously).
Malfunction indicator (Check Engine)
Engine/Emission control system
malfunction.
Charge warning
Charging system malfunction.
Low fuel warning
Fuel tank is nearly empty. Refill
fuel immediately.
High beam assist warning
The high beam assist function
malfunction.