66
3008-2_en_Chap02_ouvertures_ed01-2016
Changing the battery
A message appears in the instrument panel screen when replacement of the battery is needed.
Version without Keyless Entr y and Star ting
Batter y type: CR1620 / 3 volts.Version with Keyless Entr y and Star ting
Batter y type: CR2032 / 3 volts.
F
 
U
 nclip the cover using a small screwdriver 
at the cut-out.
F
 
L
 ift off the cover.
F
 
R
 emove the discharged battery from its 
housing.
F
 
F
 it the new battery into its housing 
observing the polarity.
F
 
C
 lip the cover onto the casing.
The remote control must be reinitialised after 
replacing the battery.
For more information on reinitialising the 
remote control, refer to the corresponding 
section. 
Access  
67
3008-2_en_Chap02_ouvertures_ed01-2016
Following replacement of the battery or in the event of a remote control fault, it may be necessary to reinitialise the remote control.
Version with Keyless Entry and 
Starting
Reinitialising the remote control
Version without Keyless Entry 
and Starting
F Place the electronic key against the back-up reader on the steering column and hold 
it there until the ignition is switched on. F
 
S
 witch on the ignition by pressing the 
"START/STOP"  button.
The electronic key is now fully operational 
again.
F
 
S
witch off the ignition.
F
 
T
urn the key to position 2 (ignition on)
.
F
 P
ress the closed padlock button for a few 
seconds.
F
 
S
witch off the ignition and remove the key 
from the switch.
The remote control is now fully operational 
again. F
 
I
 f your vehicle has a manual gearbox, place 
the gear lever in neutral then fully depress 
the clutch pedal.
F  
I
 f your vehicle has an automatic gearbox, 
select position P then press the brake 
pedal firmly.
If the fault persists after reinitialisation, contact 
a PEUGEOT dealer or a qualified workshop 
without delay.
2 
Access  
301
3008-2_en_Chap07_infos-pratiques_ed01-2016
Checks
Particle filter (Diesel)
illumination of this warning lamp accompanied 
by a message in the multifunction screen.
As soon as the traffic conditions permit, 
Versions equipped with Stop & Start are 
fitted with a 12 V lead-acid battery of 
specific technology and specification.
Its replacement should be carried 
out only by a PEUGEOT dealer or a 
qualified workshop. regenerate the filter by driving at a speed of at 
least 40 mph (60 km/h) until the warning lamp 
goes off.
If the warning lamp stays on, this indicates a 
low additive level.
For more information on Checking levels
, 
refer to the corresponding section.
Unless otherwise indicated, check these components in accordance with the manufacturer's service schedule and according to your engine.
Other wise, have them checked by a PEUGEOT dealer or a qualified workshop.
Air filter and passenger compartment filter
Refer to the manufacturer's 
service schedule for details of the 
replacement intervals for these 
components.
Oil filter
Replace the oil filter each time the 
engine oil is changed.
Refer to the manufacturer's 
service schedule for details of 
the replacement interval for this 
component.
12 V battery
The battery does not require any 
maintenance.
However, check regularly that the 
terminals are correctly tightened 
(versions without quick release terminals) and 
that the connections are clean.
For more information and the precautions to 
take before starting work on the 12 V batter y , 
refer to the corresponding section. Depending on the environment (e.g. dusty 
atmosphere) and the use of the vehicle (e.g. 
city driving), replace them twice as often if 
necessary
.
A clogged passenger compartment filter may 
have an adverse effect on the per formance 
of the air conditioning system and generate 
undesirable odours. The start of saturation of the particle 
filter is indicated by the temporary 
On a new vehicle, the first particle 
filter regeneration operations may be 
accompanied by a "burning" smell, 
which is per fectly normal.
Following prolonged operation of the 
vehicle at very low speed or at idle, 
you may, in exceptional circumstances, 
notice the emission of water vapour at 
the exhaust on acceleration. This does 
not affect the behaviour of the vehicle 
or the environment.
7 
Practical information