2017 Peugeot 208 engine

120
- Gear lever in position N.
- Brake pedal released.
-

T
hen gear lever in position A / D or M .
or
-
R

everse gear engaged.
Special cases: START invoked
automatically
As a safety measure and for your comfort,
START mode is invoked automatically when:
-
y
ou open the driver's door,
-
y

ou unfasten the driver's seat belt,
-
s

ome special conditions (battery charge,
engine temperature, braking assistance,
air conditioning setting, etc.) where the
engine is needed for control of the system
or vehicle.
The ECO warning lamp flashes for a
few seconds, then goes off.
This operation is perfectly normal.
Manual deactivation
In certain circumstances, such as the need
to maintain a comfortable temperature in the
passenger compartment, it may be preferable
to deactivate the Stop & Start system.
The system can be deactivated at any time,
once the ignition is switched on.
This control switches off the Stop & Start
system.
-
Press.
-

T
he indicator lamp in the control remains
on.
-

A m
essage is displayed.
If you are stationary in Stop mode, the engine
restarts immediately.
Manual reactivation
- Press.
- T he indicator lamp in the control goes off.
-

A c
onfirmation message is displayed. If the engine is in STOP mode, it restarts
immediately.
The Stop & Start system is reactivated
automatically every time the ignition is
switched on.
Opening the bonnet
Before doing anything under the bonnet,
deactivate the Stop & Start system to
avoid the risk of injury related to an
automatic change to START mode.
Driving on flooded roads
Before driving in a flooded area, it is
strongly recommended that you deactivate
the Stop & Start system.
For more information on Driving advice
,
particularly on flooded roads, refer to the
corresponding section.
Driving

121
Operating fault
In the event of a fault with the system, the ECO
OFF switch warning lamp flashes then comes
on fixed.
Have it checked by a PEUGEOT dealer or a
qualified workshop.
If a fault occurs in STOP mode, the vehicle
may stall. All of the instrument panel warning
lamps come on. It is then necessary to switch
the ignition off and to restart the engine using
t h e key.The Stop & Start system requires a
12
V battery of specific technology and
specification.
All work on this type of battery must be
carried out only by a PEUGEOT dealer or
a qualified workshop.
For more information on the 12
V batter y,
refer to the corresponding section.
Speed limiter "LIMIT"
The system prevents the vehicle from
exceeding the speed setting programmed by
the driver.
Steering mounted controls
1. Speed limiter mode selection / off.
2. Increases the set value.
3. Decreases the set value.
4. Speed limiter On / Pause. The vehicle responds to the accelerator until
resistance is felt in the pedal, which signifies
that the vehicle has reached the limiter speed
setting.
However, pressing the pedal beyond this point
of resistance to the floor permits exceeding
of the programmed speed. To resume use of
the limiter, simply reduce the pressure on the
accelerator pedal gradually and return to a
speed below that programmed.
Setting and operation of the system can be
done stationar y with the engine running or
when driving.
Selection
F Place the thumbwheel at the "LIMIT"

position: the speed limiter mode is selected
but is not switched on (PAUSE).
Switching the speed limiter on is not required to
set the speed limit.
The speed setting is selected with the engine
running, stationary or when driving. The
minimum speed setting possible is 20

mph
(30


km/h).
6
Driving

122
Registering a limit speed
This can be done without switching the limiter
on, but the engine must be running.
To register a speed higher than the previous
setting:
-

P
ress the SET +
button.
A short press increases the speed setting by
1
mph (km/h).
Pressing and holding increases the setting in
steps of 5
mph (km/h).
To register a speed lower than the previous
setting:
-

P
ress the SET –
button. A short press decreases the setting by 1
mph
(km/h).
Pressing and holding decreases the setting in
steps of 5 mph (km/h).
On / Pause
A first press on this button switches the speed
limiter on, a second press pauses it.
Exceeding the registered
limit speed
Pressing the accelerator pedal to
exceed the registered speed will not
have any effect, unless you press
the pedal firmly
past the point of
resistance .
The speed limiter is deactivated temporarily
and the registered speed setting flashes,
accompanied by an audible signal.
To return to normal operation of the speed
limiter, reduce your speed to below the
registered speed setting.
Flashing of the speed setting
It flashes:
- a fter forcing the accelerator pedal past the
point of resistance,
-

w
hen the limiter cannot prevent the speed
of the vehicle increasing, because of the
profile of the road or when going down a
steep hill,
-

u
nder sharp acceleration.
F

P
lace the thumbwheel at the 0 position or
switch off the ignition to stop the system.
The last speed registered stays in memory.
Switching the system off
Driving

124
Registering a cruise speed
setting
- Bring the vehicle up to the desired speed by pressing the accelerator.
-

P
ress the SET – or
SET + button.
The speed setting is registered/activated and
the vehicle will maintain this speed.
Temporarily exceeding the
programmed speed
It is possible to accelerate and
temporarily drive at a speed higher
than the registered speed setting.
The cruise speed setting value
flashes.
When the accelerator pedal is
released, the vehicle will return to
the registered speed setting.
Pause (OFF)
- Press this button or the brake or clutch pedal (depending on the version). With 1.2 PureTech 82 and 110 (Euro
6.2)
or 1.5 BlueHDi (Euro 6.2) engines, a
manual gearbox and the Stop & Start,
pressing the clutch pedal does not pause
the cruise control, the cruise control
remains active after changing gears.
Resume
- After the cruise control has been paused, press this button.
The vehicle returns to the last registered speed.
Alternatively, you can also resume the
procedure for "Registering a cruise speed
setting".
Driving

128
The collision can be automatically avoided
if the speed difference between your
vehicle and the one ahead is not more
than 9 mph (15 km/h).
Above this threshold, the system will do
what is possible to avoid or reduce the
seriousness of the accident by lowering
the speed of impact.
Activation / Deactivation
It is possible to activate or
deactivate the Active City Brake
from the Driving / Vehicle menu.
The system state remains in memory when the
ignition is switched off.
Each subsequent time the ignition is switched
on, if the automatic emergency braking function
is deactivated, a temporary message will
be displayed indicating the speed threshold
(6

mph (10 km/h)). Please deactivate the Active City
Brake:
-

F
ollowing impact damage to the
windscreen close to sensor,
-
W
hen towing a trailer,
-
W
hen the vehicle is being towed,
-
W
hen the vehicle is about to cross a
toll barrier.
-
W
hen the vehicle is passing through
an automatic car wash,
Operating limits
Not detected are:
- Pe destrians, animals, motorcyclists,
cyclists.
-

F
ixed and non-reflective materials and
objects (cardboard box, wall, etc.).
-

V
ehicles not travelling in the same direction.
This system will not trigger or inter vene if the
driver:
-

p
resses the accelerator pedal firmly,
-

t
urns the wheel sharply (avoiding
manoeuvre).
-

m

ay stop the vehicle, holding the brakes on
for around 1.5

seconds when stationary to
allow the driver time to take back control of
the vehicle,
-

m

ay cause the engine to stall,
-

m

ay give rise to a pumping noise, due to the
pressurisation of the braking system.
Operating faults
Clean or clear any dirt, mist or objects (stickers,
leaves, etc.) from the top of the windscreen that
could obstruct the laser's field of vision. In the following cases, you should have the
system checked by a PEUGEOT dealer or a
qualified workshop:
-

T
he message "
Automatic braking system "
fault detected accompanied by an audible
signal indicates that a fault has been
detected.
-
F
ollowing an impact, the system is
automatically put out of ser vice, it no longer
works. The system detects the deployment
of airbags.
Do not attempt to remove, adjust or test
the sensor.
Only a PEUGEOT dealer or a qualified
workshop is able to work on the system.
Misting of the windscreen or accumulations
of snow on the bonnet could inter fere with the
operation of the laser. A message appears if
the laser is obstructed.
Use windscreen demisting and regularly clean
the area of the windscreen in front of the
sensor.
Be particularly vigilant when driving in poor
weather (very heavy rain, hail, fog, snow, etc.).
This is because braking distances increase
while the laser's calculation parameters remain
the same.
Driving

131
Park Assist
The system detects a parking space and then
provides assistance with the parallel parking
manoeuvres.
It controls the steering and provides visual and
audible information to the driver.
The driver manages the accelerator, brakes,
gears and the clutch in the case of a manual
gearbox.
The driver can take control at any time by
gripping the steering wheel.The Park Assist system cannot in any
circumstances replace the need for
vigilance on the part of the driver.
The driver must remain in control of their
vehicle ensuring that the space remains
clear during the manoeuvre.
In some circumstances, the sensors may
not detect small obstacles located in their
blind spots.
During manoeuvring phases, the steering
wheel per forms rapid turns: do not hold
the steering wheel, do not put your hands
between the spokes of the steering wheel.
Watch out for any object that could block
the manoeuvre (loose clothing, scar ves,
ties, etc.) – Risk of injury! For entry into a parallel parking space the
system does not detect spaces which are
clearly much smaller or larger than the
size of the vehicle.
The "Parking sensors" function activates
automatically during the manoeuvres, it is
possible that a warning lamp illuminates
on the screen, accompanied by an audible
signal, without affecting the parking.
Changing tyre sizes (out-size tyres, winter
tyres, etc.) can inter fere with the correct
operation of the parking assistance
system.
When the Park Assist is active, it prevents
the Stop & Start going into STOP mode.
In STOP mode, activating Park Assist
restarts the engine.
Entering a parallel parking
space
F Once you have detected an available space,
limit the speed of the vehicle to 12 mph
(20


km/h).
F

P
osition your vehicle before this space.
The system provides assistance in entering and
exiting a parking space when parallel parking.
6
Driving

133
The driver takes back control of the vehicle's
steering.
Exit from a parallel parking
space
F When you want to exit from a parallel parking space, start the engine.
With the vehicle stationary, to activate the Park
Assist system:
F

P
ress this control.
The indicator lamp in the control remains off.
A message is displayed in the screen. F

S
elect the exit parking space manoeuvre.

The indicator lamp in the control comes on.
F
O
perate the direction indicator on the exit
from parking side.
The direction indicator flashes throughout
the manoeuvre, whatever the position of the
control stalk.
F
S
elect a for ward or reverse gear then
release the steering wheel.
The assisted exit from parking manoeuvre is in
progress.
Without exceeding 3 mph (5 km/h), continue
the manoeuvres following the information given
by the "parking assistance" system, until the
end of manoeuvre message is displayed.
The manoeuvre is complete once the front
wheels of the vehicle are out of the parking
space.
The indicator lamp in the control goes off,
accompanied by an audible signal. The driver takes back control of the vehicle's
steering.
Deactivation
The system is deactivated automatically:
-
o n switching off the ignition,
-

i
f the engine stalls,
-

i
f no manoeuvre is per formed within
5
minutes of selecting the type of
manoeuvre,
-

a
fter a prolonged stop of the vehicle during
a manoeuvre,
-

i
f the road wheel anti-slip regulation (ASR)
is triggered,
-

i
f the speed of the vehicle exceeds the
stated limit,
-

w
hen the driver interrupts movement of the
steering wheel,
-

i
f the driver presses the Park Assist control,
6
Driving

PEUGEOT & TOTAL
The PEUGEOT TOTAL team knows how to push back
the limits of performance to win victories in the most
difficult conditions, as confirmed by the first three places
achieved in 2017.
To obtain these exceptional results, the PEUGEOT Sport
teams chose TOTAL QUARTZ for the PEUGEOT 3008
DKR, a high-tech lubricant that protects the engine in the
most severe conditions.
TOTAL QUARTZ protects your engine against the effects
of time.
TOTAL QUARTZ Ineo First is an ultra-high performance
lubricant, the result of collaboration between Peugeot
and Total’s R&D teams. Specially formulated for Peugeot
engines, its innovative technology significantly reduces
CO
2 emissions and keeps your engine clean.
A PARTNERSHIP FOR
PERFORMANCE!