2017 MITSUBISHI SHOGUN light

Power type
Adjust the seat by operating the switch as in-
dicated by the arrows.
1- Adjustment forward
2- Adjustment backward
NOTEl To prevent the battery from running down,
operate the power seat with the engine run-ning.To recline the seatback
E00400600056
Manual type
In order to recline the seatback, lean forward slightly, pull the seatback lock lever up, and
then lean backward to the desired position
and release the lever. The seatback will lock in that position.
CAUTIONl The reclining mechanism of the seatback is
spring loaded, causing it to return to the ver- tical position when the lock lever is operat- ed. When using the lever, sit close to the
seatback or hold it with your hand to control its return motion.Power type
Adjust the seatback angle by operating the
switch as indicated by the arrows.
1- To move to forward direction
2- To recline rearward
NOTEl To prevent the battery from running down,
operate the power type seat with the engine
running.
Front seats
4-06OVWX17E1Seat and seat belts4

CAUTIONlThe reclining mechanism of the seatback is
spring loaded, causing it to return to the ver- tical position when the lock lever is operat- ed. When using the lever, sit close to the
seatback or hold it with your hand to control its return motion.Heated seats*
E00401102384
The heated seats can be operated with the ig-
nition switch in the “ON” position. Operate
the switch as indicated by arrows.
The indication lamp (A) will illuminate while the heater is on.
1 (HI)-Heater high (for quick
heating).2 (neutral posi- tion)-Heater off.3 (LO)-Heater low (to keep the
seat warm).CAUTIONl Switch off seat heaters when not in use.
l Operate in the high position for quick heat-
ing. Once the seat is warm, set the heater to low to keep it warm. Slight variations in seat
temperature may be felt while using the heated seats. This is caused by the operation
of the heater’s internal thermostat and does not indicate a malfunction.
l If the following types of persons use the
heated seats, they might become too hot or receive minor burns (red skin, heat blisters,
etc.):
• Children, elderly or ill people
• People with sensitive skin
• Excessively tired people
• People under the influence of alcohol or
sleep inducing medication (cold medicine, etc.)
l Do not place heavy objects on the seat or
stick pins, needles, or other pointed objects into it.
l Do not use a blanket, cushion, or other mate-
rial with high heat insulation properties on the seat while using the heater; this might
cause the heater element to overheat.
l When cleaning the seat, do not use benzene,
kerosene, petrol, alcohol, or other organicsolvents; these might damage the surface of the seat and also the heater element.CAUTIONl If water or any other liquid is spilled on the
seat, allow it to dry thoroughly before at-tempting to use the heater.
l Turn the heater off immediately if it appears
to be malfunctioning during use.Rear seats (3-door models)*/
Second seats (5-door
models)* E00402000184WARNINGlWhen a person is sitting in the middle
seating position of the rear seats (3-doormodels)/second seats (5-door models), pull
up the head restraint to a height at which
it locks in position. Be sure to make this adjustment before starting to drive. Seri- ous injuries could otherwise be suffered as
the result of an impact. Refer to “Head
restraints” on page 4-12.
Rear seats (3-door models)*/Second seats (5-door models)*
4-09OVWX17E1Seat and seat belts4

To recline the seatback
E00402201297
In order to recline the seatback, lean forwardslightly, pull the seatback lock lever up, and then lean backward to the desired position
and release the lever. The seatback will lock
in that position.
3-door models5-door models
CAUTIONl The reclining mechanism of the seatback is
spring loaded, causing it to return to the ver- tical position when the lock lever is operat- ed. When using the lever, sit close to the
seatback or hold it with your hand to control its return motion.NOTEl Each seatback can be adjusted by the lever
on its side.
l On 5-door models, each of the second seat’s
sidebacks (A) is foldable. When either side
of the seatback is reclined to a new position,
its sideback automatically folds inward ac- cordingly.Armrest
E00402400218
For rear seats (3-door models)
Press the button (A) at the top of the armrest
and allow the armrest to drop down.
Rear seats (3-door models)*/Second seats (5-door models)*
4-10OVWX17E1Seat and seat belts4

For second seats (5-door mod-els)
Lift the centre head restraint and then tilt the armrest for use as illustrated.
CAUTIONl When storing the armrest, push the armrest
securely to prevent it from falling down while driving the vehicle.NOTEl Do not stand or sit on the armrest. It could
break.To get in and out of the third
seat (5-door models)
E00402500163
Getting in and out of the third seat can be
made easily by folding the second seat. Referto “Folding the rear seats (3-door models) / Folding the second seats (5-door models)” on
page 4-14.
Third seat (5-door models)*
E00402700149To recline the seatback
E00402800124
In order to recline the seatback, lean forwardslightly, pull the seatback lock lever as shown in the illustration, and then lean back-ward to the desired position and release the
lever. The seatback will lock in that position.
CAUTIONl The reclining mechanism of the seatback is
spring loaded, causing it to return to the ver- tical position when the lock lever is operat- ed. When using the lever, sit close to the
seatback or hold it with your hand to control its return motion.
Third seat (5-door models)*
4-11OVWX17E1Seat and seat belts4

3.Push the seat until you hear a “click”
and the seat locks securely.
To replace
Raise the seatback until it locks securely into
place.
Push lightly on the seatback to confirm that it has actually been secured.
Folding the rear seats (3-door
models) / Folding the secondseats (5-door models)
E00403700221
To create luggage space, you can fold the
rear (3-door models) / second (5-door mod- els) seats.
If your vehicle is equipped with the third
seat, by folding the second seat, you can get
in and out easier.
WARNINGl When driving the vehicle, do not allow
anyone to sit on the third seat if the sec-
ond seat is in the foldeddown position. The second seat could tip rearward in the event of hard braking or a collision, re-
sulting in serious injuries.
To fold
1. If your vehicle is equipped with a rear
shelf (3-door models) / cargo area cover
(5-door models), remove it before per- forming the following steps. Refer to“Rear shelf (3-door models)” on page
7-86 and “Cargo area cover (5-door mod-
els)” on page 7-86.
2. Lift up the knob (A) behind the seat-
back, then tilt the seatback forward.
3. Lift the seat until you hear a “click”.
Making a luggage area
4-14OVWX17E1Seat and seat belts4

To replace
1.Hold the seat with your hand, then return
the seat to its original position while pushing the stopper (A).
2. Push the seat until you hear a “click”
and the seat locks securely.
3. Raise the seatback until it locks securely
into place.
Push lightly on the seatback to confirm
that it has actually been secured.Storage of the third seat
E00404101287
By folding the third seat into the luggage floor box, large articles can be stored in the vehicle.
To store
1. Remove the luggage floor board (A) and
the head restraints (B).
Refer to “Luggage floor box” on page
7-84 and “Head restraints” on page 4-12.
2. Stow the removed head restraints in the
luggage floor box with their front faces
facing upward.
Making a luggage area
4-15OVWX17E1Seat and seat belts4

6. Fold down the stands (F).
7. Refit the luggage floor board.
To replace
1. Remove the luggage floor board. And
then raise the stands.
2. Raise the seat forward until you hear a
“click” and the seat locks securely.
3. Push knob (A) forward, and raise the
seatback until it locks securely into
place. After the operation, push lightly on the seatback to confirm that it has ac-
tually been secured.
4. Refit the luggage floor board and head
restraints.
Removing the third seat
E00404201220
To create more luggage space, you can re-
move the third seat.
CAUTIONl For safety, do not allow children to remove
or refit the seat.CAUTIONl Be careful not to trap your hands or feet
when removing or refitting the seat. Also, be careful not to drop or trip over the seat. If
necessary, have someone help you remove
it.
To remove
1. Remove the head restraints.
Refer to “Head restraints” on page 4-12.
2. Pull up the knob (A) on the side of the
seatback, then tilt the seatback forward.
Making a luggage area
4-17OVWX17E1Seat and seat belts4

After the operation, push the seatback
lightly to confirm that it has actually been secured.
6. Refit the head restraints.
Making a flat seat (Except
for 3-door models equipped
with the power seat) E00404301960
By removing the head restraints and fully re-
clining the seatbacks of the seats, one large flat seat is achieved.
WARNINGl Never drive with passengers on the flat
seat. This is highly dangerous.CAUTIONl To make a flat seat, stop the vehicle in a safe
place.
l Make sure the seat is adjusted by an adult or
with adult supervision for correct and safe
operation.
l When sliding the seat, be sure not to catch
your hand or leg.
l Do not walk around on top of the seats after
they have been laid flat.
l To ensure the seats are locked securely, at-
tempt to move them back and forth.
l Do not jump on, or impact the seatbacks
heavily.
l To raise the seatback, put a hand on the seat-
back and raise slowly. Never have a child do this operation, or an unexpected accident
may result.
1. If your vehicle is equipped with a rear
shelf (3-door models) / cargo area cover
(5-door models), remove it before per- forming the following steps. Refer to“Rear shelf (3-door models)” on page
7-86 and “Cargo area cover (5-door mod-
els)” on page 7-86.
2. Remove the head restraints from the
front seats.
If your vehicle is equipped with the third seat (5-door models), store the third seat into the luggage floor box.
Refer to “Head restraints” on page 4-12
and “Storage of the third seat” on page
4-15.
3. Slide the front seats fully forward, then
tip their seatbacks backward.
On 5-door models, slide the front seats backward until their seatbacks touch the second seat.
Making a flat seat (Except for 3-door models equipped with the power seat)
4-20OVWX17E1Seat and seat belts4