2017 MAZDA MODEL CX-5 wiper blades

1–7
Pictorial Index
Exterior Overview
Front





Windshield wiper blades ........................................................................\
............... page 6-29



Moonroof ...............................................................\
............................................... page 3-42



Window ..................................................................\
............................................... page 3-39



Fuel-fi ller lid ........................................................................\
................................. page 3-33



Request switch ........................................................................\
............................. page 3-14



Door ...................................................................\
................................................... page 3-12
The equipment and installation position varies by vehicle
CX-5_8FN1-EA-16L_Edition1.indb 72016/12/12 10:05:13

4–53
When Driving
Switches and Controls
*Some models.
Auto-light control *
When the headlight switch is in the
position and the ignition is switched ON, the light
sensor senses the surrounding lightness or darkness and automatically tu\
rns the headlights
and other exterior lights on or off.
CAUTION
 Do not shade the light sensor by adhering a sticker or a label on the windshield. Otherwise the light sensor will not operate correctly.

 The light sensor also works as a rain sensor for the auto-wiper control. Keep hands and scrapers clear of the windshield when the wiper lever is in the
position and the
ignition is switched ON as fi ngers could be pinched or the wipers and wiper blades could be
damaged when the wipers activate automatically. If you are going to clean the windshield,
be sure the wipers are turned off completely when it is particularly tempting to leave the
engine running. This is particularly important when clearing ice and snow.

NOTE
   The headlights and other exterior lights may not turn off immediately ev\
en if the
surrounding area becomes well-lit because the light sensor determines that it is night\

time if the surrounding area is continuously dark for several minutes such as inside long
tunnels, traf fi c jams inside tunnels, or in indoor parking lots.
 In this case, the lights turn off if the light switch is turned to the \
position.   If the headlight switch and the windshield wiper switch are in , and the wipers are
operated at low or high speed by the auto wiper control for several seconds, bad weather
conditions are determined and the headlights may be turned on.
   The sensitivity of the auto-light control may be changed. Refer to Personalization Features on page 9-11 .
CX-5_8FN1-EA-16L_Edition1.indb 532016/12/12 10:05:54

4–60
When Driving
Switches and Controls
Auto-wiper control
When the wiper lever is in the

position, the rain sensor senses the amount
of rainfall on the windshield and turns the
wipers on or off automatically (off—
intermittent—low speed—high speed).

The sensitivity of the rain sensor can be
adjusted by turning the switch on the
wiper lever.
From the center position (normal), rotate
the switch upward for higher sensitivity
(faster response) or rotate it downward for
less sensitivity (slower response).


Higher sensitivity
Less sensitivitySwitch
Center
position

CAUTION
 Do not shade the rain sensor by adhering a sticker or a label on the
windshield. Otherwise the rain sensor
will not operate correctly.

 When the wiper lever is in the
position and the ignition is switched ON,
the wipers may move automatically in
the following cases:
 If the windshield above the rain sensor is touched or wiped with a
cloth.
 If the windshield is struck with a hand or other object from either outside or
inside the vehicle.
 Keep hands and scrapers clear of the windshield when the wiper lever is in the

position and the ignition is
switched ON as fi ngers could be pinched
or the wipers and wiper blades damaged
when the wipers activate automatically.
 If you are going to clean the windshield, be sure the wipers are turned off
completely (when it is most likely
that the engine is left running) this is
particularly important when clearing ice
and snow.

CX-5_8FN1-EA-16L_Edition1.indb 602016/12/12 10:05:57

6–1
6Maintenance and Care
How to keep your Mazda in top condition.


Essential Information ........................................................................\
6-2 Introduction ........................................................................\
........... 6-2

Scheduled Maintenance ..................................................................... 6-4 Scheduled Maintenance (U.S.A., Canada, and Puerto Rico) ........ 6-4
Scheduled Maintenance (Mexico) .............................................. 6-10
Maintenance Monitor .................................................................. 6-16

Owner Maintenance ........................................................................\
. 6-18 Owner Maintenance Precautions ................................................ 6-18
Hood ........................................................................\
.................... 6-20
Engine Compartment Overview ................................................. 6-22
Engine Oil ........................................................................\
........... 6-23
Engine Coolant ........................................................................\
.... 6-25
Brake/Clutch Fluid ...................................................................... 6-27
Washer Fluid ........................................................................\
....... 6-27
Body Lubrication ........................................................................\
6-28
Wiper Blades ........................................................................\
....... 6-29
Battery ........................................................................\
................. 6-34
Key Battery Replacement ........................................................... 6-36
Tires........................................................................\
..................... 6-39
Light Bulbs ........................................................................\
.......... 6-44
Fuses ........................................................................\
................... 6-50

Appearance Care........................................................................\
...... 6-56 Exterior Care ........................................................................\
....... 6-56
Interior Care ........................................................................\
........ 6-62
CX-5_8FN1-EA-16L_Edition1.indb 12016/12/12 10:07:04

6–29
Maintenance and Care
Owner Maintenance
Wiper Blades
CAUTION
 Hot waxes applied by automatic car washers have been known to aff ect the
wiper's ability to clean windows.
 To prevent damage to the wiper blades, do not use gasoline, kerosene, paint
thinner, or other solvents on or near
them.
 When the wiper lever is in the AUTO position and the ignition is switched ON,
the wipers may move automatically in
the following cases:
 If the windshield above the rain sensor is touched.
 If the windshield above the rain sensor is wiped with a cloth.
 If the windshield is struck with a hand or other object.
 If the rain sensor is struck with a hand or other object from inside the vehicle.
 Be careful not to pinch hands or fi ngers as it may cause injury, or damage the
wipers. When washing or servicing the
vehicle, make sure the wiper lever is in
the OFF position.

Contamination of either the windshield or
the blades with foreign matter can reduce
wiper effectiveness. Common sources are
insects, tree sap, and hot wax treatments
used by some commercial car washes.

If the blades are not wiping properly,
clean the window and blades with a good
cleaner or mild detergent; then rinse
thoroughly with clean water. Repeat if
necessary.
Replacing Windshield Wiper Blades
When the wipers no longer clean well, the
blades are probably worn or cracked.
Replace them.
CAUTION
 To prevent damage to the wiper arms
and other components, do not try to
sweep the wiper arm by hand.
 Do not bend the blade rubber unnecessarily when replacing it.
Otherwise, the metal stiff ener in the
blade may deform and the windshield
wiper operation may be adversely
aff ected.

NOTE
When raising both windshield wiper arms,
raise the driver's side wiper arm fi rst.
When lowering the wiper arms, slowly
lower the wiper arm from the passenger's
side fi rst while supporting it with your
hand. Forcefully lowering the wiper arms
could damage the wiper arm and blade,
and may scratch or crack the windshield.

CX-5_8FN1-EA-16L_Edition1.indb 292016/12/12 10:07:09

6–58
Maintenance and Care
Appearance Care
Maintaining the Finish
Washing
CAUTION
 When the wiper lever is in the
position and the ignition is switched ON,
the wipers may move automatically in
the following cases:
 If the windshield above the rain sensor is touched or wiped with a
cloth.
 If the windshield is struck with a hand or other object from either outside or
inside the vehicle.
 Keep hands and scrapers clear of the windshield when the wiper lever is in the

position and the ignition is
switched ON as fi ngers could be pinched
or the wipers and wiper blades damaged
when the wipers activate automatically.
 If you are going to clean the windshield, be sure the wipers are turned off
completely (when it is most likely
that the engine is left running) this is
particularly important when clearing ice
and snow.
 Do not spray water in the engine compartment. Otherwise, it could result
in engine-starting problems or damage
to electrical parts.
 When washing and waxing the vehicle, be careful not to apply excessive force
to any single area of the vehicle roof.
Otherwise, you could dent the vehicle.

To help protect the fi nish from rust
and deterioration, wash your Mazda
thoroughly and frequently, at least once a
month, with lukewarm or cold water.
If the vehicle is washed improperly, the
paint surface could be scratched. Here are
some examples of how scratching could
occur.

Scratches occur on the paint surface when:
 
 The vehicle is washed without fi rst
rinsing off dirt and other foreign matter.
   The vehicle is washed with a rough, dry,
or dirty cloth.
   The vehicle is washed at a car wash that
uses brushes that are dirty or too stiff.
   Cleansers or wax containing abrasives
are used.

NOTE
   Mazda is not responsible for scratches
caused by automatic car washes or
improper washing.
  Scratches are more noticeable on
vehicles with darker paint fi nishes.

To minimize scratches on the vehicle's
paint fi nish:
  Rinse off any dirt or other foreign matter
using lukewarm or cold water before
washing.
   Use plenty of lukewarm or cold water
and a soft cloth when washing the
vehicle. Do not use a nylon cloth.
   Rub gently when washing or drying the
vehicle.
   Take your vehicle only to a car wash
that keeps its brushes well maintained.
   Do not use abrasive cleansers or wax
that contain abrasives.

CX-5_8FN1-EA-16L_Edition1.indb 582016/12/12 10:07:17

10–9
Index
V
Vanity Mirrors ................................... 5-138
Vehicle Information Labels ................... 9-2
W
Warning Indication/Warning Lights .... 4-33
Warning Sound is Activated ................ 7-39 Advanced Key removed from vehicle
warning beep ................................. 7-41
Air bag/seat belt pretensioner system
warning beep ................................. 7-39
AUTOHOLD Warning Beep ......... 7-42
Blind Spot Monitoring (BSM) warning
beep ............................................... 7-42
Collision warning .......................... 7-43
Electric Parking Brake (EPB) Warning
Beep............................................... 7-42
Electronic steering lock warning
beep ............................................... 7-41
Ignition not switched off (STOP)
warning beep ................................. 7-40
Key left-in-luggage compartment
warning beep (With the advanced
keyless function) ........................... 7-41
Key left-in-vehicle warning beep (With
the advanced keyless function) ..... 7-41
Key removed from vehicle warning
beep ............................................... 7-41
Lane Departure Warning sound ..... 7-43
Lights-on reminder ........................ 7-39
Mazda Radar Cruise Control with Stop
& Go function (MRCC with Stop &
Go function) system warnings ...... 7-43
Power Liftgate Warning Beep ....... 7-42
Power steering warning buzzer ..... 7-42
Request switch inoperable warning
beep (With the advanced keyless
function) ........................................ 7-41
Seat belt warning beep .................. 7-40
Tire in fl ation pressure warning
beep ............................................... 7-42 Warranty .............................................. 8-16
Weights.................................................. 9-6
Windows
Power windows ............................. 3-39
Windshield Washer ............................. 4-61
Windshield Wiper De-icer................... 4-63
Windshield Wipers .............................. 4-59
Winter Driving .................................... 3-52
Wiper
Replacing Rear Window Wiper
Blade ............................................. 6-32
Replacing windshield wiper
blades............................................. 6-29

CX-5_8FN1-EA-16L_Edition1.indb 92016/12/12 10:07:43