2017 MAZDA MODEL CX-5 bulb

The rear fog light indicator light in the
instrument cluster illuminates while the
rear fog light is on.

Fog light switch
To turn the rear fog light off, do any of the
following:
•Rotate the fog light switch to the
position again (the fog light switch
returns to its original position
automatically).
•Turn the headlight switch to the
position.
The rear fog light indicator light in the
instrument cluster goes off when the rear
fog light is turned off.
NOTE
(With auto-light control)
When the headlight switch is in the
position and the headlights, exterior lights
and instrument panel illuminated, the rear
fog light turns on when the rear fog light
switch is turned on.
Turn and Lane-Change Signals
The ignition must be switched ON to use
the turn and lane-change signals.
▼Direction Indicators
Move the signal lever down (for a left
turn) or up (for a right turn) to the stop
position. The signal will self-cancel after
the turn is completed.

If the indicator light continues to flash
after a turn, ma
nually return th e lever to its
original position.
Right turn
Left turn
Right lane change
Left lane change OFF
The direction indicato
rs in the instrument
cluster flash according to the operation of
the direction indicator lever to show which
signal is working.

NOTE
•If an indicator light stays on without
flashing or if it flashes abnormally, one
of the direction indicator bulbs may be
burned out.
•A personalised function is available to
change the turn indicator sound volume.
(page 9-12)
When Driving
Switches and Controls
4-70
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

6Maintenance and Care
How to keep your Mazda in top condition.
Essential Information........................6-2 Introduction.................................. 6-2
Scheduled Maintenance.................... 6-3 Scheduled Maintenance................ 6-3
Maintenance Monitor................. 6-17
Owner Maintenance........................ 6-20 Owner Maintenance
Precautions................................. 6-20
Bonnet........................ .................6-22
Engine Compartment
Overview.................................... 6-24
Engine Oil...................................6-25
Engine Coolant........................... 6-29
Brake/Clutch Fluid ..................... 6-31
Window and Headlight Washer
Fluid............................................6-32
Body Lubrication...... .................. 6-32
Wiper Blades.............................. 6-33
Battery........................................ 6-38
Key Battery Replacement........... 6-41
Tyres........................................... 6-43
Light Bulbs................................. 6-47
Fuses........................................... 6-54
Appearance Care............................. 6-61
Exterior Care.............................. 6-61
Interior Care................................6-66
6-1
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

Light Bulbs
Type A
Type B
Headlights (High/Low beam)
Running lights/Position lights
Headlights (Low beam)*
Running lights*
Front fog lights*
Front direction indicator lights
Position lights
Side direction indicator lights
Brake lights
Maintenance and Care
Owner Maintenance
*Some models.6-47
2017-6-7 7:51:19Form No. CX-5 8FY4-EE-17E+L_Edition2

Brake lights/Tail lights
Rear direction indicator lights
Reverse lights
Rear fog light (Left-hand drive model)*
Rear fog light (Right-hand drive model)*
High-mount brake light
Number plate lights
Overhead lights/Front map lights
Vanity mirror lights*
Rear map lights
Luggage compartment light
WA R N I N G
Never touch the glass portion of a halogen
bulb with your bare hands and always
wear eye protection when handling or
working around the bulbs:
When a halogen bulb breaks, it is
dangerous. These bulbs contain
pressurised gas. If one is broken, it will
explode and serious injuries could be
caused by the
flying glass.
If the glass portion is touched with bare
hands, body oil could cause the bulb to
overheat and explode when lit.
Always keep halogen bulbs out of the reach
of children:
Playing with a halogen bulb is dangerous.
Serious injuries could be caused by
dropping a halogen bulb or breaking it
some other way.
CAUTION
When removing the lens or lamp unit using
a flathead screwdriver, make sure that the
flathead screwdriver does not contact the
interior terminal. If the flathead screwdriver
contacts the terminal, a short circuit may
occur.
NOTE
•To replace the bulb, contact an expert
repairer, we recommend an Authorised
Mazda Repairer.
•If the halogen bulb is accidentally
touched, it should be cleaned with
rubbing alcohol before being used.
•Use the protective cover and carton for
the replacement bulb to dispose of the
old bulb promptly and out of the reach
of children.
Maintenance and Care
Owner Maintenance
6-48*Some models.
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

▼Replacing Exterior Light Bulbs
Headlights, Running lights/Position
lights (Type A), Ru
nning lights (Type
A), Front fog lights*, Side direction
indicator lights, Bra ke lights (Type A),
Brake lights/Tail lights (Type A),
Reverse lights, High-mount brake light
The LED bulb cannot be replaced as a
single unit because it is an integrated unit.
The LED bulb has to be replaced with the
unit. We recommend an Authorised Mazda
Repairer when the replacement is
necessary.
Front direction indicator lights, Position
lights (Type B)
1. Make sure the ignition is switched off,
and the headlight switch is off.
2. Lift the bonnet. Refer to Bonnet on page 6-22.
3. Turn the socket and bulb assembly anticlockwise and remove it.
4. Disconnect the bulb from the socket. Front direction indicator lights
Position lights
5. Install the new bulb in the reverse
order of the removal procedure.
Running lights (Type B)
*
1. Make sure the ignition is switched off, and the headlight switch is off.
2. If you are changing the right bulb, start
the engine, turn the steering wheel all
the way to the left, and turn off engine.
If you are changing the left bulb, turn
the steering wheel to the right.
3. Pull the centre of each plastic retainer
using a flathead screwdriver and
remove the retainers, and then partially
peel back the over fender.
Removal
Installation
Maintenance and Care
Owner Maintenance
*Some models.6-49
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

4. Pull the centre of each plastic retainerusing a flathead screwdriver and
remove the retainers, and then partially
peel back the mudguard.
Removal
Installation
5. Turn the socket and bulb assemblyanticlockwise and remove it.
6. Disconnect the bulb from the socket.
7. Install the new bulb in the reverse order of the removal procedure.
Rear direction indicator lights, Brake
lights/Tail lights (Type B)
1. Make sure the ignition is switched off, and the headlight switch is off.
2. Wrap a small flathead screwdriver witha soft cloth to prev ent damage to the
cover, and then remove the cover with
the flathead screwdriver.
3. Turn the screws anticlockwise and remove them.
4. Pull the unit rearward to remove it.
5. Turn the socket and bulb assembly
anticlockwise and remove it.
Maintenance and Care
Owner Maintenance
6-50
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

6. Disconnect the bulb from the socket.Rear direction indicator lights
Brake lights/Tail lights
7. Install the new bulb in the reverseorder of the removal procedure.
Rear fog light
*
1. Make sure the ignition is switched off and the headlight switch is off.
2. Pull the centre of each plastic retainer and remove the retainers.
3. Remove the cover.
Removal
Installation
4. Turn the socket and bulb assembly
anticlockwise and remove it.
5. Disconnect the bulb from the socket.
6. Install the new bulb in the reverse order of the removal procedure.
Number plate lights
1. Make sure the ignition is switched off, and the headlight switch is off.
2. Wrap a flathead screwdriver with a soft cloth to prevent damage to the
lens, and then remove the lens by
carefully prying on t he edge of the lens
with a flathead screwdriver.
Maintenance and Care
Owner Maintenance
*Some models.6-51
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

3. Disconnect the bulb by pulling it out.
4. Install the new bulb in the reverseorder of the removal procedure.
▼Replacing Interior Light Bulbs
Overhead light/Front map lights, Rear
map lights, Vanity mirror lights*
1. Wrap a flathead s
crewdriver with a
soft cloth to prevent damage to the
lens, and then remove the lens by
carefully prying on th e edge of the lens
with a flathead screwdriver.
2. Disconnect the bulb by pulling it out.
Overhead light/Front map lights
Maintenance and Care
Owner Maintenance
6-52*Some models.
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2