NOTE
•(Automatic transaxle vehicle)
The detection indicator and buzzer of the front sensors/front corner sensors do not
operate when the selector lever is in the P position.
•The detection indicator and buzzer sound do not activate when the parking brake is
applied.
▼Obstruction Detection Indication
The position of a sensor which has detected an obstruction is i
ndicated. The gauge
illuminates in different areas d epending on the distance to an obstruction detected by the
sensor.
As the vehicle approaches closer to an obstruction, the zone in the gauge closer to the
vehicle illuminates.
Front left corner
sensor gauge Front right corner
sensor gauge
Rear right corner
sensor gauge
Rear left corner
sensor gauge Front sensor gauge
Rear sensor gauge
NOTE
The detection indicator can switch between display and non-display.
Refer to Personalisation Features on page 9-12.
System problem notification
If any of the pr oblems indicated in the table occurs, the driver is notified of the problem
depending on the type of system as shown.
Detection Indicator Solution
Disconnection
The system may have a ma lfunction. Have the ve-
hicle inspected at an expert repairer, we recom-
mend an Authorised Mazda Repairer as soon as
possible.
When Driving
Parking Sensor System
4-232
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2
Detection IndicatorSolution
System mal- function
The system may have a ma lfunction. Have the ve-
hicle inspected at an expert repairer, we recom-
mend an Authorised Mazda Repairer as soon as
possible.
Frost/soiling
Foreign matter may be on the sensor area corre-
sponding to the obstructio n detection indication
shown. If the system does not recover, have the ve-
hicle inspected at an expert repairer, we recom-
mend an Authorised Mazda Repairer.
▼ Parking Sensor Warning Beep
The beeper sounds as follows while the system is operating.
Front Sensor, Rear Sensor
Distance Detec-
tion area Distance between vehicle and obstruction
Beeper sound*1Front SensorRear Sensor
Farthest distance Approx. 100―60 cm (39.3―23.6
in)
Approx. 150―60 cm (59.0―23.6in)
Slow intermittent
sound
Far distance Approx. 60―45 cm (23.6―17.7
in)
Approx. 60―45 cm (23.6―17.7in)
Medium intermit-
tent sound
When Driving
Parking Sensor System
4-233
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2
Distance Detec-tion area Distance between vehicle and obstruction
Beeper sound*1Front SensorRear Sensor
Middle distance Approx. 45―35 cm (17.7―13.7
in)
Approx. 45―35 cm (17.7―13.7in)
Fast intermittent
sound
Close distance Within approx. 35 cm (13.7 in)
Within approx. 35 cm (13.7 in)
Continuous sound
*1 The rate at which the interm
ittent sound beeps increases as the vehicle approaches the obstruction.
Front Corner Sensor, Rear Corner Sensor
Distance Detection areaDistance between vehicle and obstruction
Beeper sound*1Front/Rear Corner Sensor
Far distance Approx. 55―38 cm (21.7―15.0 in)
Medium intermittent sound
Middle distance Approx. 38―25 cm (15.0―9.8 in)
Fast intermittent sound
Close distance Within approx. 25 cm (9.8 in)
Continuous sound
*1 The rate at which the interm
ittent sound beeps increases as the vehicle approaches the obstruction.
When Driving
Parking Sensor System
4-234
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2
NOTE
If an obstruction is detected in a zone for 6 seconds or more, the beep sound is stopped
(except for the close-distance zone). If the same obstruction is detected in another zone, the
corresponding beep sound is heard.
▼ When Warning Indicator/Beep is Activated
The system notifies th
e driver of an abnormality by activating the beep sound and the
indicator light.
Indicator/Beep How to check
The beep sound is not heard. The system may have a malfuncti
on. Have the vehicle inspected at an expert
repairer, we recommend an Authoris ed Mazda Repairer as soon as possible.
The intermittent sound of the
buzzer is heard five times. Remove any foreign material from the sensor area. If the system does not re-
cover, have the vehicle inspected at an expert repairer, we rec
ommend an Au-
thorised Mazda Repairer.
A certain obstruc tion detection
indicator is con tinuously dis-
played. Refer to Obstruction Detection Indication on page 4-232.
When Driving
Parking Sensor System
4-235
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2
•When selecting heat, the system will
restrict airflow until it has warmed to
prevent cold air from blowing out of the
vents.
▼Windscreen Defrosting and
Defogging
Press the windscreen defroster switch.
In this position, the outside air position is
automatically selected, and the air
conditioner automatically turns on. The air
conditioner will direct
ly dehumidify the
air to the front windscreen and side
windows on page 5-6.
Airflow amount wil l be increased.
WA R N I N G
Set the temperature control to the hot or
warm position when defogging (
position):
Using the
position with the temperature
control set to the cold position is
dangerous as it will cause the outside of the
windscreen to fog up. Your vision will be
hampered, which could lead to a serious
accident.
NOTE
Use the temperature control dial to
increase the air flow temperature and
defog the windscreen more quickly.
▼ Sunlight/Interior temperature
sensor
Sunlight sensor
Do not place objects on the sunlight
sensor. Otherwise, the interior temperature
may not adjust correctly.
Sunlight sensor
Interior temperature sensor
Do not cover the interior temperature
sensor. Otherwise, the interior temperature
may not adjust correctly.
Interior temperature sensor
Interior Features
Air-Conditioning System
5-14
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2
Wiper Blades
CAUTION
Hot waxes applied by automatic car
washers have been known to
affect the
wiper's ability to clean windows.
To prevent damage to the wiper blades,
do not use petrol, paraffin, paint thinner,
or other solvents on or near them.
When the wiper lever is in the AUTO
position and the ignition is switched ON,
the wipers may move automatically in
the following cases:
If the windscreen above the rain sensor
is touched.
If the windscreen above the rain sensor
is wiped with a cloth.
If the windscreen is struck with a hand
or other object.
If the rain sensor is struck with a hand
or other object from inside the vehicle.
Be careful not to pinch hands or fingers
as it may cause injury, or damage the
wipers. When washing or servicing the
vehicle, make sure the wiper lever is in
the OFF position.
Contamination of either the windscreen or
the blades with foreign matter can reduce
wiper effectiveness. Common sources are
insects, tree sap, and hot wax treatments
used by some commercial car washes.
If the blades are not wiping properly, clean
the window and blades with a good
cleaner or mild detergent; then rinse
thoroughly with clean water. Repeat if
necessary.
▼ Replacing Windscreen Wiper Blades
When the wipers no longer clean well, the
blades are probably worn or cracked.
Replace them.
CAUTION
To prevent damage to the wiper arms
and other components, do not try to
sweep the wiper arm by hand.
Do not bend the blade rubber
unnecessarily when replacing it.
Otherwise, the metal stiffener in the
blade may deform and the windscreen
wiper operation may be adversely
affected.
NOTE
When raising both windscreen wiper arms,
raise the driver's side wiper arm first.
When lowering the wiper arms, slowly
lower the wiper arm from the passenger's
side first while supporting it with your
hand. Forcefully lowering the wiper arms
could damage the wiper arm and blade,
and may scratch or crack the windscreen.
1. Raise the wiper arm.
CAUTION
To prevent damage to the windscreen
let the wiper arm down easily, do not
let it slap down on the windscreen.
Maintenance and Care
Owner Maintenance
6-33
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2
Wa t e r M a r k s
Occurrence
Rain, fog, dew, and even tap water can
contain harmful minerals such as salt and
lime. If moisture containing these minerals
settles on the vehicle and evaporates, the
minerals will concentrate and harden to
form white rings. The rings can damage
your vehicle's finish.
Prevention
It is necessary to wash and wax your
vehicle to preserve its finish according to
the instructions in this section. These steps
should be taken immediately after you find
water marks on your vehicle's finish.
Paint Chipping
Occurrence
Paint chipping occurs when gravel thrown
in the air by another v ehicle's tyres hits
your vehicle.
How to avoid paint chipping
Keeping a safe distance between you and
the vehicle ahead reduces the chances of
having your paint chipped by flying
gravel.
NOTE
•The paint chipping zone varies with the
speed of the vehicle. For example, when
travelling at 90 km/h (56 mph), the paint
chipping zone is 50 m (164 ft).
•In low temperatures a vehicle's finish
hardens. This increases the chance of
paint chipping.
•Chipped paint can lead to rust forming
on your Mazda. Before this happens,
repair the damage by using Mazda
touch-up paint according to the
instructions in this section. Failure to
repair the affected area could lead to
serious rusting and expensive repairs.
Follow all label and container directions
when using a chemical cleaner or polish.
Read all warnings and cautions.
▼ Maintaining the Finish
Wa s h i n g
CAUTION
When the wiper lever is in the
position and the ignition is switched ON,
the wipers may move automatically in
the following cases:
If the windscreen above the rain sensor
is touched or wiped with a cloth.
If the windscreen is struck with a hand
or other object from either outside or
inside the vehicle.
Keep hands and scrapers clear of the
windscreen when the wiper lever is in the
position and the ignition is
switched ON as fingers could be pinched
or the wipers and wiper blades damaged
when the wipers activate automatically.
If you are going to clean the windscreen,
be sure the wipers are turned off
completely (when it is most likely that the
engine is left running) this is particularly
important when clearing ice and snow.
Maintenance and Care
Appearance Care
6-62
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2
SignalWarning
(Amber)
i-stop Warning
Light
*
When the light is turned on
A problem in the system may be i ndicated under the following conditions. Have your ve-
hicle inspected at an expert repairer, we recommend an Authoris ed Mazda Repairer.
•The light does not turn on when the ignition is switched ON.•The light continues to remain on even though the i-stop OFF swi tch has been pressed
while the engine is running.
When the light is flashing
The light continues to flash if the system has a malfunction. H ave your vehicle inspected
at an expert repairer, we recommend an Authorised Mazda Repaire r.
i-ELOOP Warning
Indication*
The Warning indication turns on if there is any malfunction in the i-ELOOP system. Con-
sult an expert repairer, we reco mmend an Authorised Mazda Repai rer.
(Amber)
High Beam Control System (HBC)
Wa r n i n g L i g h t
*
The light remains turned on if th ere is a problem with the system. Have your vehicle in-
spected at an expert repairer, we recommend an Authorised Mazda Repairer.
NOTE
If the windscreen area in front of the Forward Sensing Camera (FSC) is fogged or ob-
structed, the light turns on temporarily. If the light remains turned on, there may be a
problem with the system.
(Amber)
Adaptive LED
Headlights (ALH)
Wa r n i n g L i g h t
*
The light remains turned on if th ere is a problem with the system. Have your vehicle in-
spected at an expert repairer, we recommend an Authorised Mazda Repairer.
NOTE
If the windscreen area in front of the Forward Sensing Camera (FSC) is fogged or ob-
structed, the light turns on temporarily. If the light remains turned on, there may be a
problem with the system.
Blind Spot Monitor-
ing (BSM) Warning
Indication
*
This light illuminates if there i s a malfunction in the Blind Spot Monitoring (BSM). Have
your vehicle inspected by an expe rt repairer, we recommend an Authorised Mazda Re-
pairer.
NOTE
If the vehicle is driven on a road with less traffic and few vehicles that the radar sensors
can detect, the system may pause. However , it does not indicate a malfunction.
Blind Spot Monitor-
ing (BSM) OFF In-
dicator Light
*
A problem in the system may be i ndicated under the following conditions.
Have your vehicle inspected at an expert repairer, we recommend an Authorised Mazda
Repairer.
•The light does not turn on when the ignition is switched ON.•The light remains on even when the Blind Spot Monitoring (BSM) system can be operat-
ed.
•The light turns on while driving the vehicle.
NOTE
If the vehicle is driven on a road with less traffic and few vehicles that the radar sensors
can detect, the system may pause (The Bli nd Spot Monitoring (BSM) OFF indicator light
in the instrument cluster illuminates). However, it does not indicate a malfunction.
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
7-52*Some models.
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2