2017 MAZDA MODEL CX-3 warning lights

4–184
When Driving
i-ACTIVSENSE
NOTE
  If the Forward Sensing Camera (FSC) cannot operate normally due to backlight or fog,
the system functions related to the Forward Sensing Camera (FSC) are temporarily
stopped and the following warning lights turn on. However, this does not indicate a
malfunction.
 


 High Beam Control System (HBC) warning light (amber) 



 Adaptive LED Headlights (ALH) warning light (amber) 



 Lane Departure Warning System (LDWS) warning light 



 Smart Brake Support/Smart City Brake Support (SBS/SCBS) warning light (amber) 

 If the Forward Sensing Camera (FSC) cannot operate normally due to high
temperatures, the system functions related to the Forward Sensing Camera (FSC) are
temporarily stopped and the following warning lights turn on. However, this does not
indicate a malfunction. Cool down the area around the Forward Sensing Camera (FSC)
such as by turning on the air conditioner.
 


 High Beam Control System (HBC) warning light (amber) 



 Adaptive LED Headlights (ALH) warning light (amber) 



 Lane Departure Warning System (LDWS) warning light 



 Smart Brake Support/Smart City Brake Support (SBS/SCBS) warning light (amber) 

 If the Forward Sensing Camera (FSC) detects that the windscreen is dirty or foggy,
the system functions related to the Forward Sensing Camera (FSC) are temporarily
stopped and the following warning lights turn on. However, this does not indicate a
problem. Remove the dirt from the windscreen or press the defroster switch and defog
the windscreen.
 


 High Beam Control System (HBC) warning light (amber) 



 Adaptive LED Headlights (ALH) warning light (amber) 


 Lane Departure Warning System (LDWS) warning light 



 Smart Brake Support/Smart City Brake Support (SBS/SCBS) warning light (amber) 

 If there are recognizable cracks or damage caused by À ying gravel or debris on the
windscreen, always have the windscreen replaced. Consult an Authorised Mazda
Repairer for replacement.

4–198
When Driving
Tyre Pressure Monitoring System
*Some models.
Tyre Pressure Monitoring System *
The Tyre Pressure Monitoring System (TPMS) monitors the air pressure of all four tyres. If
the air pressure of one or more tyres is too low, the system warns the driver by indicating the
tyre pressure monitoring system warning light in the instrument cluster and operating a beep
sound. The system monitors the tyre pressures indirectly using the data sent from the ABS
wheel speed sensors.
To allow the system to operate correctly, the system needs to be initialized with the speci¿ ed
tyre pressure (value on the tyre pressure label). Follow the procedure and perform the
initialization.
Refer to Tyre Pressure Monitoring System Initialization on page 4-201 .
The warning light À ashes when the system has a malfunction.
Refer to Warning Lights on page 4-36 .


ABS wheel speed sensor

6–46
Maintenance and Care
Owner Maintenance
*Some models.
WARNING
Never touch the glass portion of a
halogen bulb with your bare hands
and always wear eye protection when
handling or working around the bulbs:
When a halogen bulb breaks, it is
dangerous. These bulbs contain
pressurised gas. If one is broken, it will
explode and serious injuries could be
caused by the À ying glass.
If the glass portion is touched with bare
hands, body oil could cause the bulb to
overheat and explode when lit.

Always keep halogen bulbs out of the
reach of children:
Playing with a halogen bulb is
dangerous. Serious injuries could be
caused by dropping a halogen bulb or
breaking it some other way.
CAUTION
When removing the lens or lamp unit
using a À athead screwdriver, make
sure that the À athead screwdriver does
not contact the interior terminal. If
the À athead screwdriver contacts the
terminal, a short circuit may occur.
NOTE
  To replace the bulb, contact an
expert repairer, we recommend an
Authorised Mazda Repairer.
  If the halogen bulb is accidentally
touched, it should be cleaned with
rubbing alcohol before being used.
  Use the protective cover and carton
for the replacement bulb to dispose
of the old bulb promptly and out of
the reach of children.
Replacing Exterior Light Bulbs
Headlights (With LED headlights)
The LED bulb cannot be replaced as a
single unit because it is an integrated unit.
The LED bulb has to be replaced with
the unit. We recommend an Authorised
Mazda Repairer when the replacement is
necessary.
Headlights (With halogen headlights)
High-beam bulbs (With running lights)/
Running lights
*
1. Make sure the ignition is switched off,
and the headlight switch is off.
2. Lift the bonnet.
3. Turn the cover anticlockwise and
remove it.

6–54
Maintenance and Care
Owner Maintenance
Replacing the fuses under the bonnet
If the headlights or other electrical
components do not work and the fuses
in the cabin are normal, inspect the fuse
block under the bonnet. If a fuse is blown,
it must be replaced. Follow these steps:


1. Make sure the ignition is switched off,
and other switches are off.
2. Remove the fuse block cover.


3. If any fuse but the MAIN fuse is
blown, replace it with a new one of the
same amperage rating .

Normal
Blown

WARNING
Do not replace the main fuse by
yourself. Have an Authorised Mazda
Repairer perform the replacement:
Replacing the fuse by yourself is
dangerous because the MAIN fuse
is a high current fuse. Incorrect
replacement could cause an electrical
shock or a short circuit resulting in a
¿ re.
4. Reinstall the cover and make sure that
it is securely installed.

6–56
Maintenance and Care
Owner Maintenance
*Some models.
DESCRIPTION FUSE
RATING PROTECTED COMPONENT
16 AT PUMP 15 A Transaxle control system
*
17 AT 15 A Transaxle control system *
18 D.LOCK 25 A Power door locks
19 H/L RH 20 A Headlight (RH)
20

7.5 A Engine control system
21 TAIL 20 A Tail lights, Number plate lights, Position lights
22 ST.HEATER 15 A Heated steering wheel
*
23 ROOM 25 A Overhead light
24 FOG 15 A Front fog lights
*
25 H/CLEAN 20 A Headlight washer *
26 STOP 10 A Brake lights, Rear fog light *
27 HORN 15 A Horn
28 H/L LH 20 A Headlight (LH)
29 ABS/DSC S 30 A ABS, Dynamic stability control system
30 HAZARD 15 A Hazard warning À ashers, Direction indicator lights
31 FUEL PUMP 15 A Fuel system
*
32 FUEL WARM 25 A Fuel warmer *
33 WIPER 20 A Front window wiper
34

50 A For protection of various circuits
35 FAN2 30 A —
36 FUEL PUMP 30 A Fuel system
*
37 ABS/DSC M 50 A ABS, Dynamic stability control system
38 EVVT 20 A Engine control system
*
39 — — —
40 FAN1 30 A —
41 FAN3 40 A Cooling fan
42 ENG.MAIN 40 A Engine control system
43 EPS 60 A Power steering system
*
44 DEFOG 40 A Rear window defogger
45 IG2 30 A For protection of various circuits
46 INJECTOR 30 A Engine control system
*
47 HEATER 40 A Air conditioner
48 P.WINDOW1 30 A Power windows
49 DCDC DE 40 A For protection of various circuits
*

7–1*Some models.7–1
7If Trouble Arises
Helpful information on what to do if a problem arises with the vehicle.

Mazda ERA-GLONASS (Russia) ...... 7-2
Mazda ERA-GLONASS ................ 7-2
Indicator Light/Beep Sound ......... 7-11
Test Mode ..................................... 7-12

Parking in an Emergency ................. 7-15
Parking in an Emergency ............. 7-15

Flat Tyre ............................................. 7-16
Spare Tyre and Tool Storage ........ 7-16
Emergency Flat Tyre Repair
Kit
* ............................................... 7-22
Changing a Flat Tyre
(With Spare Tyre) ......................... 7-29

Battery Runs Out .............................. 7-37
Jump-Starting ............................... 7-37

Emergency Starting .......................... 7-40
Starting a Flooded Engine
(SKYACTIV-G 2.0 ) .................... 7-40
Push-Starting ................................ 7-40
Running Out of Fuel
(SKYACTIV-D 1.5) ..................... 7-41

Overheating ....................................... 7-42
Overheating .................................. 7-42

Emergency Towing ............................ 7-44
Towing Description ...................... 7-44
Towing/Tiedown Hooks ............... 7-46
Warning/Indicator Lights and Warning
Sounds ................................................ 7-49
If a Warning Light Turns On or
Flashes .......................................... 7-49
Message Indicated on Display
* .... 7-62
Warning Sound is Activated ......... 7-64

When Liftgate Cannot be
Opened ............................................... 7-70
When Liftgate Cannot be
Opened ......................................... 7-70

Active Driving Display Does Not
Operate ............................................... 7-71
If the Active Driving Display does not
operate
* ......................................... 7-71

7–13
If Trouble Arises
Mazda ERA-GLONASS (Russia)
Method to start test mode
Switch the ignition ON while the parking brake is applied, and wait two minutes with the
vehicle stopped.
After that, perform the following procedure.

Move the signal lever up to right
turn
Move the signal lever up to right
turnMove the signal lever down
to left turn
Move the signal lever down
to left turn Return the signal lever to offReturn the signal lever to off
Return the signal lever to off
Return the signal lever to off Return the signal lever to off Move the signal lever up to right
turnWithin five seconds
Within one second Within one second Within one second Within one second
Within one second
Within one second
Within one second
Within one second Within five seconds
Within five second
Within one second Turn on the hazard warning
lights.
Turn off the hazard warning
lights.
Both red and green Mazda
ERA-GLONASS switch
indicator lights turn on.
Press the Mazda
ERA-GLONASS switch for
one second or longer and
release it.

7–15
If Trouble Arises
Parking in an Emergency
Parking in an Emergency
The hazard warning lights should always
be used when you stop on or near a
roadway in an emergency.




The hazard warning lights warn other
drivers that your vehicle is a traf¿ c hazard
and that they must take extreme caution
when near it.



Depress the hazard warning À asher and
all the direction indicators will À ash. The
hazard warning indicator lights in the
instrument cluster À ash simultaneously.
NOTE

 The direction indicators do not work
when the hazard warning lights are
on.
  Check local regulations about the use
of hazard warning lights while the
vehicle is being towed to verify that
it is not in violation of the law.