2017 LEXUS RX200T engine

7198-2. Steps to take in an emergency
8
When trouble arises
RX350/RX200t_EE_OM48F32E
The coolant level is satisfactory if it is between the “FULL” and “LOW” lines on
the reservoir.
Add coolant if necessary.
4
EngineIntercooler (RX200t only)
Reservoir
“FULL” line
“LOW” line
Radiator cap
1
2
3
4
5
EngineIntercooler (RX200t only)
Water can be used in an emergency if coolant is unavailable.

7208-2. Steps to take in an emergency
RX350/RX200t_EE_OM48F32E
Start the engine and turn the air conditioning system on to check that the radi-
ator cooling fan operates and to check for coolant leaks from the radiator or
hoses.
The fans operate when the air conditioning system is turned on immediately after a
cold start. Confirm that the fans are operating by checking the fan sound and air flow. If it is difficult to check these, turn the air conditioning system on and off repeatedly. (The fan may not operate in freezing temperatures.)
If the fans are not operating:
Stop the engine immediately and contact any authorized Lexus dealer or
repairer, or another duly qualified and equipped professional.
If the fans are operating:
Have the vehicle inspected at the nearest any authorized Lexus dealer or
repairer, or another duly qualified and equipped professional.
Check if “Engine Coolant Temp High Stop in a Safe Place See Owner’s Man-
ual” is shown on the multi-information display.
If the message does not disappear:
Stop the engine and contact any authorized Lexus dealer or repairer, or
another duly qualified and equipped professional.
If the message is not displayed:
Have the vehicle inspected at the nearest authorized Lexus dealer or repairer,
or another duly qualified and equipped professional.
WARNING
■To prevent an accident or injury when in specting under the hood of your vehicle
Observe the following precautions.
Failure to do so may result in serious injury such as burns.
●If steam is seen coming from under the h ood, do not open the hood until the steam has subsided. The engine compartment may be very hot.
●Keep hands and clothing (especially a tie, a scarf or a muffler) away from the fans andbelts. Failure to do so may cause the hands or clothing to be caught, resulting in seri- ous injury.
●Do not loosen the radiator cap and the coolant reservoir caps while the engine andradiator are hot.High temperature steam or coolant could spray out.
6
7
8

7218-2. Steps to take in an emergency
8
When trouble arises
RX350/RX200t_EE_OM48F32E
NOTICE
■When adding engine coolant
Add coolant slowly after the engine has cool ed down sufficiently. Adding cool coolant to a hot engine too quickly can cause damage to the engine.
■To prevent damage to the cooling system
Observe the following precautions:
●Avoid contaminating the coolant with foreign matter (such as sand or dust, etc.).
●Do not use any coolant additive.

7228-2. Steps to take in an emergency
RX350/RX200t_EE_OM48F32E
Stop the engine. Shift the shift lever to P and set the parking brake.
Remove the mud, snow or sand from around the front wheels.
Place wood, stones or some other material under the front wheels to help pro-
vide traction.
Restart the engine.
AWD models: Activate all-wheel drive lock mode. ( P. 421)
Shift the shift lever to D or R and rele ase the parking brake. Then, while exer-
cising caution, depress the accelerator pedal.
■When it is difficult to free the vehicle
If the vehicle becomes stuck
Carry out the following procedures if the tires spin or the vehicle becomes
stuck in mud, dirt or snow:
Press to turn off TRC.
1
2
3
4
5
6

7289-1. Specifications
RX350/RX200t_EE_OM48F32E
■Engine number
RX350
The engine number is stamped on
the engine block as shown.
RX200t
The engine number is stamped on
the engine block as shown.
RX350
Engine
Model2GR-FKS
Type6-cylinder V type, 4-cycle, gasoline
Bore and stroke94.0  83.0 mm (3.70  3.27 in.)
Displacement3456 cm3 (210.9 cu. in.)
Valve clearance (engine cold)Automatic adjustment
Drive belt tensionAutomatic adjustment

729
9
9-1. Specifications
Vehicle specifications
RX350/RX200t_EE_OM48F32E
RX200t
*: The engine oil capacity is a reference quantity to be used when changing the engine
oil. Warm up the engine and turn off the engine, wait more than 5 minutes, and check
the oil level on the dipstick.
Model8AR-FTS
Type4-cylinder in line, 4-cycle, gasoline
(with turbocharger)
Bore and stroke86.0  86.0 mm (3.39  3.39 in.)
Displacement1998 cm3 (121.9 cu. in.)
Valve clearance (engine cold)Automatic adjustment
Drive belt tensionAutomatic adjustment
Fuel
Fuel type
EU area
Unleaded gasoline conforming to European stan-
dard EN228 only
Except EU area
Unleaded gasoline only
Research octane number95 or higher
Fuel tank capacity (Reference)72 L (19.0 gal., 15.8 lmp. gal.)
Lubrication system
Oil capacity
(Drain and refill reference*)
With filter
Without filter
RX350
5.5 L (5.8 qt., 4.8 Imp. qt.)
RX200t
4.9 L (5.2 qt., 4.3 Imp. qt.)
RX350
5.3 L (5.6 qt., 4.7 Imp. qt.)
RX200t
4.7 L (5.0 qt., 4.1 Imp. qt.)

7309-1. Specifications
RX350/RX200t_EE_OM48F32E
■Engine oil selection
RX350
“Toyota Genuine Motor Oil” is used in your Lexus vehicle. Lexus recom-
mends the use of approved “Toyota Genuine Motor Oil”. Another motor oil of
matching quality can also be used.
Oil grade:
0W-20, 5W-30 and 10W-30:
API grade SL “Energy-Conserving ”, SM “Energy-Conserving” or SN
“Resource-Conserving”; or IL SAC multigrade engine oil
15W-40:
API grade SL, SM or SN multigrade engine oil
Recommended viscosity (SAE):
SAE 0W-20 is filled into your Lexus
vehicle at manufacturing, and the
best choice for good fuel economy
and good starting in cold weather.
If SAE 0W-20 oil is not available,
SAE 5W-30 oil may be used. How-
ever, it should be replaced with SAE
0W-20 at the next oil change.
If you use SAE 10W-30 or a higher
viscosity engine oil in extremely low
temperatures, the engine may
become difficult to start, so SAE
0W-20 or 5W-30 engine oil is rec-
ommended.
Preferred
Temperature range anticipated
before next oil change

731
9
9-1. Specifications
Vehicle specifications
RX350/RX200t_EE_OM48F32E
Oil viscosity (0W-20 is explained here as an example):
• The 0W in 0W-20 indicates the characteristic of the oil which allows cold
startability. Oils with a lower value before the W allow for easier starting of
the engine in cold weather.
• The 20 in 0W-20 indicates the viscosity characteristic of the oil when the
oil is at high temperature. An oil with a higher viscosity (one with a higher
value) may be better suited if the vehicle is operated at high speeds, or
under extreme load conditions.
How to read oil container labels:
Either or both API registered marks are added to some oil containers to help
you select the oil you should use.
API Service Symbol
Top portion: “API SERVICE SN” means the oil quality designation by
American Petroleum Institute (API).
Center portion: “SAE 0W-20” means the SAE viscosity grade.
Lower portion: “Resource- Conserving” means that the oil hasfuel-saving and environmental pro-
tection capabilities.
ILSAC Certification Mark
The International Lubricant Specificatio n Advisory Committee (ILSAC) Certifica- tion Mark is displayed on the front of the container.
1
2