• The lane number increases or decrea‐ses or the lane lines are crossing
complicatedly.
• Putting something on the dashboard.
• Driving with the sun in front of you.
• Driving in areas under construction.
• The lane line is more than two in ei‐ ther side (Left/Right).
• The windshield is fogged by humid air in the vehicle.
Driving your vehicle
7-82
• The width of the lane is below 2.6 mor over 4.5 m.
• ESC(Electronic Stability Control) and VSM(Vehicle stability management)are activated.
• When the system is on or after changing a lane, drive in the middle of
the lane. If not, the system will not
provide the steering assist function.
• The steering will not be assisted when you drive fast on a sharp curve.
• The steering will not be assisted when you change lanes fast.
• The steering will not be assisted when you brake suddenly.
Driver's attention
The driver must be cautious in the be‐
low situations for the system may not assist the driver and may not work
properly. • The lane is not visible due to snow, rain, stain, a puddle or many other
things.
• The brightness of the outside changes suddenly such as passing
through a tunnel.
• Not turning on the headlight or the light is weak even at night or in a
tunnel. • Difficult to distinguish the color of
the lane marker from the road.
• Driving on a steep grade or a curve.
• Light reflects from the water on the road such as sunlight, streetlight or
the light of oncoming vehicles.
• The lens or windshield is stained with foreign matter.
• The surrounding of the inside rear view mirror temperature is high due
to direct light.
• The lane is very wide or narrow.
• The lane marker is damaged or indis‐ tinct.
• The shadow is on the lane marker by a median strip.
• There is a mark similar to a lane marker.
• There is a boundary structure.
• The distance from vehicle ahead is very short or the vehicle ahead driveshiding the lane marker.
• The vehicle shakes heavily.
• The lane number increases or decrea‐ ses or the lane marker are crossing
complicatedly.
• Placing something on the dashboard. • Driving with the sun in front of you.
• Driving in areas under construction.
• The lane marker is more than two.
• The lane marker in a tunnel is hard to
distinguish due to dust or grease.
• The lane marker is hard to distinguish after raining at night.
• The lane marker is hard to distinguish due to dust.
• MDPS (motor driven power steering) is not operational.
• Some objects are attached in steering wheel.
• The windshield is fogged by humid air in the vehicle.
• The distance from the vehicle ahead is very short or the vehicle ahead
drives covering the lane line.
• The lane line is merged or divided.
• Driving through a toll plaza or toll gate.
7-87
7
Driving your vehicle
If it fits loosely, we recommend that
you consult an authorized Kia dealer.
If you do not have a spare, use a fuse of the same rating from a circuit you
may not need for operating the vehicle,
such as the cigarette lighter fuse.
If the headlights or taillights, stop lights, courtesy lamp, day time running
lights (D.R.L) do not work and the fuses
are OK, check the fuse panel in the en‐ gine compartment. If a fuse is blown, it
must be replaced.
Fuse switch
0 + '
Always, put the fuse switch at the ON
position. If you move the switch to the OFF posi‐
tion, some items such as audio and dig‐
ital clock must be reset and transmitter
(or smart key) may not work properly.
If the fuse switch is in OFF, a warning sign will illuminate on the dashboard.
CAUTION
•Put all switches in ON when driv‐ing.
•If the vehicle remains idle for over1 month, put all switches in OFF toprevent the batteries from beingdischarged.
•Excluding long-term parking forover 1 month, the contact pointsof switches may wear out uponextensive use. Please refrain fromexcessive use of switches.
Engine compartment fuse
replacement
1. Turn the ignition switch and all oth‐ er switches off.
2. Remove the fuse panel cover by pressing the tab and pulling the
cover up. When the blade type fuse
is disconnected, remove it by using
the clip designed for changing fuses
located in the engine room fuse
box. Upon removal, securely insert
reserve fuse of equal quantity.
3. Check the removed fuse; replace it if it is blown. To remove or insert
the fuse, use the fuse puller in the
engine compartment fuse panel.
Maintenance
9-54