G-Force
When selected, this screen displays all four G-Force values (two lateral
and two longitudinal) as well as steering angle.When G-Force is selected, the following features will be available:
Lateral G-Force Left and Right
• The lateral g-force measures the (sideways) left and right force of the
vehicle.
Longitudinal G-Force Acceleration and Braking
• The longitudinal g-force measures the acceleration and braking force of the vehicle.
Peak G-Forces Acceleration and Braking, Left and Right
• This shows the maximum g-forces that have been achieved since the last reset from the instrument cluster display. Peak values are
maintained through ignition cycles by the instrument cluster display
until they are cleared by the driver.
NOTE: To clear peak values, use the steering wheel controls while on the
instrument cluster g-force page.
Vehicle Speed
• Vehicle Speed measures the current speed of the vehicle in either mph or km/h, starting at zero with no maximum value.
Steering Wheel Angle
•
Steering Wheel Angle utilizes the steering angle sensor to measure the
degree of the steering wheel relative to zero. The zero degree measure-
ment indicates a steering wheel straight ahead position. When the
steering angle value is negative, this indicates a turn to the left, and
when the steering angle value is positive, a turn to the right.
SRT Performance Pages — G-Force
UNDERSTANDING YOUR INSTRUMENT PANEL
12
While in Valet Mode the following vehicle configurations are set and
locked to prevent unauthorized modification:
• All-Wheel Drive is set to 50/50.
• Transmission locks out access to first gear and up-shifts earlier thannormal.
• Stability Control, Steering, and Suspension are set to their STREET settings.
• Steering wheel paddle shifters are disabled.
• The Drive Mode interface is not available. Pushing the SRT button on Selec-Track switch will display the unlock keypad.
• The ESC Off button is disabled.
• The Launch Control button is disabled.
• Engine limited to a lowest power output state.
To exit Valet Mode you must enter the same four digit PIN that was used
to enter the mode. The unlock keypad can be accessed by either
pushing the SRT button on Selec-Track switch, or pressing the “Valet”
button on the touchscreen.
Valet Mode Deactivation
UNDERSTANDING YOUR INSTRUMENT PANEL
30
