2017 Hyundai Elantra fog light

3-125
Convenient features of your vehicle
3
Fan speed control
The ignition switch must be in the ON
position for fan operation.
The fan speed control knob allows
you to control the fan speed of the air
flowing from the ventilation system.
To c h a n g e t h e f a n s p e e d , t u r n t h e
knob to the right for higher speed or
left for lower speed.
Setting the fan speed control knob to
the “0” position turns off the fan.
Air conditioning (A/C)
Press the A/C button to turn the air
conditioning system on (indicator
light will illuminate). Press the button
again to turn the air conditioning sys-
tem off.
•Continuous operation of the
climate control system in the
recirculated air position may
allow humidity to increase
inside the vehicle which may
fog the glass and obscure vis-
ibility.
•Do not sleep in a vehicle with
the air conditioning or heating
system on. It may cause seri-
ous harm or death due to a
drop in the oxygen level
and/or body temperature.
•Continuous operation of the
climate control system in the
recirculated air position can
cause drowsiness or sleepi-
ness, and loss of vehicle con-
trol. Set the air intake control
to the outside (fresh) air posi-
tion as much as possible
whilst driving.
WA R N I N G
OAD045309OAD045308

7
Fuses ......................................................................7-50
Fuse/relay panel description .......................................7-56
Light bulbs.............................................................7-67
Headlamp, position lamp, turn signal lamp and
fog lamp light bulb replacement .................................7-68
Side repeater lamp replacement .................................7-74
Rear combination lamp bulb replacement ................7-75
High mounted stop lamp replacement ....................7-79
Licence plate light bulb replacement ........................7-79
Interior light bulb replacement ....................................7-80
Appearance care ..................................................7-81
Exterior care ....................................................................7-81
Interior care......................................................................7-87
Emission control system .....................................7-88
Crankcase emission control system ...........................7-88
Evaporative emission control system.........................7-89
Exhaust emission control system ...............................7-89

7-68
Maintenance
Information
After heavy rain, or washing, head-
lamp and tail lamp lenses could
appear frosty. This condition is caused
by the temperature difference between
the lamp inside and outside.
This is similar to the condensation on
your windows inside your vehicle
when raining and doesn’t indicate a
problem with your vehicle. If the
water leaks into the lamp bulb circuit-
ry, we recommend that the system be
checked by an authorised HYUNDAI
dealer.
Headlamp, position lamp,
turn signal lamp and fog lamp
light bulb replacement
Ty p e A – S t a n d a rd
(1) Headlamp (Low)
(2) Headlamp (High)
(3) Turn signal lamp
(4) Position lamp
(5) Daytime running lamp (DRL)
(6) Fog lamp (if equipped)
i
OAD075031
OAD075048
■ without fog lamp
■ with fog lamp

7-78
Maintenance
2.Remove the socket from the
assembly by turning the socket
anticlockwise until the tabs on the
socket align with the slots on the
assembly.
3.Remove the bulb by pulling it out.
4.Insert a new bulb by inserting it into
the socket.
5.Install the light assembly to the
boot.
6.Reinstall the nuts and connector
and then the boot lid cover by
pushing in the screw.
Tail and rear fog lamp (if equipped)
1.Remove the socket from the
assembly by turning the socket
anticlockwise until the tabs on the
socket align with the slots on the
assembly.
2.Remove the bulb from the socket
by pressing it in and rotating it anti-
clockwise until the tabs on the bulb
align with the slots in the socket.
Pull the bulb out of the socket.
3.Insert a new bulb by inserting it into
the socket and rotating it until it
locks into place.
4.Install the socket in the assembly
by aligning the tabs on the socket
with the slots in the assembly.
Push the socket into the assembly
and turn the socket clockwise.
OAD075069L
OAD075070L
■Ty p e A
■Ty p e B , C
Back up
Ta i lFog(if equipped)
Fog(if equipped)
Back up

8-3
8
Specifications & Consumer information
BBUULLBB WWAATTTTAAGGEE
* : if equipped
Light Bulb Bulb type Wattage
Front
HeadlampLowTy p e A , B 9 0 0 5 L + 6 0
Ty p e C D 5 S 2 5
High H7LL 55
Tu r n s i g n a l l a m p P Y 2 1 W 2 1
Position lampTy p e A W 5 W 5
Ty p e B , C L E D L E D
Fog lamp* HB4 51
Daytime running lamp (DRL)*Ty p e A , B P 2 1 W 2 1
Ty p e C L E D L E D
Side Repeater lamp (Outside mirror) LED LED
Rear
Rear combination lamp
OutsideTa i l / S t o pTy p e A P 2 1 / 5 W 2 1 / 5
Ty p e B , C L E D L E D
Tu r n s i g n a l P Y 2 1 W 2 1
Inside
Ta i lTy p e A P 2 1 / 5 W 5
Ty p e B , C L E D L E D
Stop LED LED
Reverse W16W 16
Fog H21W 21
High mounted stop lamp Bulb type P21W 21
Licence plate lamp W5W 5
Interior
Map lamp W10W 10
Passenger compar tment lamp FESTOON 8
Sunvisor lamp FESTOON 5
Luggage compartment lamp FESTOON 5