2017 Citroen BERLINGO MULTISPACE RHD seats

98
Berlingo2VP_en_Chap04_Ergonomie_ed02-2016Berlingo2VP_en_Chap04_Ergonomie_ed02-2016
From insideFrom outside
Rear box
This roof box can be accessed from
the
  rear   seats   and   the   boot.
From
  the   rear   seats,   slide   the   flaps   to  
open.
Vents
A 3-position control allows you to
adjust  the   air   flow   through   the   vents.
The
  vents   are   also   fitted   with   a   scented  
air

  freshener.
From the boot, place your thumb on
the recess then pull the handle to
open.
Open
 
carefully
 
to
 
prevent
 
objects
 
stored in this interior roof box from
fallin

g
 
out.
The
 
maximum
 
authorised
 
load
 
is
 
10
 
kg.
Practical information

103
Berlingo2VP_en_Chap04_Ergonomie_ed02-2016Berlingo2VP_en_Chap04_Ergonomie_ed02-2016
Automatic switching on/off
The front courtesy lamp comes on when
the  key   is   removed   from   the   ignition,   when the

  vehicle   is   unlocked,   when   one   of   the
 front doors is opened and for location of


the
  vehicle   using   the   remote   control.
It goes off gradually after the ignition is
switched on and when the vehicle is
locked.Front seats: comes on when one of the front doors is
opened. These are switched on and of
f by
means of a manual switch, with
the
  ignition   on.
Rear
  seats:   comes   on   when  
one of the rear doors is
opened.
If the doors remain open for
a few minutes, the courtesy
lamps

  go   off.
Permanently
  off.
Permanently
 
on,
 
ignition
 
on.
Front courtesy lamp
COURTESY
LAMPS
Rear courtesy lamp Front individual reading lamps
EASE OF USE and COMFORT
4
Practical information

104
Berlingo2VP_en_Chap04_Ergonomie_ed02-2016Berlingo2VP_en_Chap04_Ergonomie_ed02-2016
LOAD SPACE COVER (5 SEAT VERSION)
This rigid shelf conceals the objects stored  in   the   boot. Removing
Fold
  the   load   space   cover.
Detach it from the notches A and B
pulling
  it   towards   you.
Raise
  it   and   remove   the   assembly.
Refitting
Place the load space cover in front
of A and B.
Push it forwards to insert the lugs in
the
  notches.
Unfold and clip into the notches C.
Folding
From the boot, fold the half-shelf,
raising it to detach it from the notch C. Storing (according to version)
A 
location   is   provided   in   the   back   of   the  rear seats to accommodate the load
space
  cover   folded   onto   itself.
Slide it vertically between the side
guides
  located   at   mid   seat   back   height.
Insert
  the   hinge   first,   with   the   free   flaps  
turned

  upwards.
This rigid load space cover can
form
  a   shelf.   However,   as   a   safety  
measure,

  do   not   place   objects  
on it which could become dangerous
projectiles

  in   the   event   of   sharp   braking  
or

  rear   impact.
Practical information

108
Berlingo2VP_en_Chap04_Ergonomie_ed02-2016Berlingo2VP_en_Chap04_Ergonomie_ed02-2016
BLIND, LOAD SPACE COVER
Position the load space screen so as to
present  the   rear   load   space   cover   flaps  
towards

  you.
Engage the left-hand lug of the roller in
the support A.
The load space cover is the roller blind
type.
 
T

ake
 
care
 
not
 
to
 
place
 
heavy
 
objects

 
on
 
the
 
load
 
space
 
cover
 
when
 
unreeled.
Compress then place the right-hand
lug facing the support
B.
Release to engage the roller in its
support.
Unroll the load space cover to the rear
side
  pillars.
Engage the ends in the rear notches to
keep
  it   taut.
To install it
Place the row 3 seats in the fully folded
position.
Raise
 
the
 
storage
 
flap
 
at
 
the
 
boot
 
sill.
Take
 
hold
 
of
 
the
 
roller
 
in
 
the
 
centre
 
and
 
compress

 
it
 
towards
 
the
 
left-hand
 
pillar.
Raise
 
the
 
assembly.
Practical information

109
Berlingo2VP_en_Chap04_Ergonomie_ed02-2016Berlingo2VP_en_Chap04_Ergonomie_ed02-2016
To remove it
From the boot, pull the load space
cover towards you to release it from
the  side   pillars.
Guide
  the   load   space   cover   as   it   rolls   up.
Remove
  the   clips   of   the   three   flaps  
from the base of each row 2 head
restraint.
Compress the roller to the left to
remove it from the support

B.
Raise
  it   and   pivot   it   forwards. To store it
Store it in the recess at the boot sill,
with
  the   two   rear   flaps   uppermost.
First, compress the load space screen
to
  the   left.
Release.
Arrange
  the   two   flaps   and   close   the  
storage

  flap.
The
 
roller
 
is
 
fitted
 
with
 
three
 
flaps
 
permitting concealment of the
boot, whether the row 2 seats
are in the normal position or the
comfort

 
position.
Each
 
flap
 
has
 
two
 
clips
 
which
 
are
 
hooked

 
on
 
the
 
base
 
of
 
each
 
head
 
restraint.
EASE OF USE and COMFORT
4
Practical information

111
Berlingo2VP_en_Chap04_Ergonomie_ed02-2016Berlingo2VP_en_Chap04_Ergonomie_ed02-2016
SURVEILLANCE MIRROR
This mirror, placed on top of the
central mirror, enables the driver or
front passenger to observe all the rear
seats.
Fitted  on   its   own   ball   joint,   its   manual  
adjustment

  is   simple   and   provides   a  
view

  of   the   rear   interior   of   the   vehicle.
It
  can   also   be   adjusted   for   improved  
visibility during manoeuvres or when
overtaking.
REAR WINDOWS
To partially open the rear windows, tilt
the  lever   and   push   it   fully   to   lock   the  
windows

  in   the   open   position.
Manual rear view mirror
The rear view mirror has two positions:
-
day (normal),
-

 
night
  (anti-dazzle).
To change from one to the other, push
or pull the lever on the lower edge of
the
  mirror.
EASE OF USE and COMFORT
4
Mirrors and windows

 127
Berlingo2VP_en_Chap05_Securite_ed02-2016
Berlingo2VP_en_Chap05_Securite_ed02-2016
Seat belts
Recommendations for children:
-

use a suitable child seat if the
passenger is less than 12 years old
or

 
shorter
 
than
 
one
 
metre
 
fifty,
-

never allow a child to travel on
your lap, even with the seat belt
fastened. For more information on child
seats, refer to the "Child safety"
section

 
of
 
chapter
 
5.
Clean the seat belt straps with
soapy water or a textile cleaning
product, sold by CITROËN
dealers.
In accordance with current safety
regulations, your CITROËN dealer can
guarantee
 
all
 
work
 
or
 
any
 
checks,
 
from
 
testing to maintenance, on your seat
belt

 
equipment.
Have
 
the
 
seat
 
belts
 
checked
 
regularly
 
(even after a minor impact) by a
CITROËN

 
dealer
 
or
 
a
 
qualified
 
workshop:

 
they
 
must
 
not
 
show
 
any
 
signs of wear

, cutting or fraying
and they must not be converted or
modified.
The force limiter reduces the pressure
of the seat belt against the body of the
occupants.
The pretensioning seat belts are active
when
 
the
 
ignition
 
is
 
switched
 
on.
The
 
inertia
 
reels
 
are
 
fitted
 
with
 
a
 
device
 
which

 
automatically
 
locks
 
the
 
strap
 
in
 
the event of a collision or emergency
braking

 
or
 
if
 
the
 
vehicle
 
rolls
 
over.
You can unfasten the seat belt by
pressing
 
the
 
red
 
button
 
on
 
the
 
buckle.
 
Guide

 
the
 
seat
 
belt
 
after
 
unfastening.
The airbag warning lamp comes on
if
 
the
 
pretensioners
 
are
 
deployed.
 
Contact a CITROËN dealer or a
qualified

 
workshop.
In
 
order
 
to
 
be
 
effective,
 
a
 
seat
 
belt:
-

must restrain one person only

,
-
 
must

 
not
 
be
 
twisted,
 
check
 
by
 
pullin

g in front of you with an even
movement,
-

must be tightened as close to the
body

 
as
 
possible.
The upper part of the seat belt should
be positioned in the hollow of the
shoulder.
The lap part should be placed as low
as
 
possible
 
on
 
the
 
pelvis.
Do not interchange the seat belt
buckles
 
as
 
they
 
will
 
not
 
fulfil
 
their
 
role
 
properly

.
 
If
 
the
 
seats
 
are
 
fitted
 
with
 
armrests, the lap part of the seat belt
should

 
always
 
pass
 
under
 
the
 
armrest.
Check
 
that
 
the
 
seat
 
belt
 
is
 
fastened
 
correctly

 
by
 
pulling
 
the
 
strap
 
firmly.
Front seat belts
The front seats are fitted with pretensioners   and   force   limiters.
Rear seat belts
(5 seat version)
The rear seats are fitted with 
three-point   inertia   reel   seat   belts.
SAFETY
5

128
Berlingo2VP_en_Chap05_Securite_ed02-2016
128
Berlingo2VP_en_Chap05_Securite_ed02-2016
Rear seat belts
(7 seat version)
In row 2
The  three   seats   are   fitted   with  
three-point
  inertia   reel   seat   belts.
When folding the side seats or the
seat
  backs   to   the   table   position,  
avoid

trapping the strap of the centre
seat
  belt.
When handling the side seats
(removing/installing)
  or   when  
accessing

  row   3,   avoid   hooking   the  
centre

  seat   belt.
Ensure that the centre seat belt is
rolled up correctly in its strengthener
on
  the   roof. In row 3
The
  two   seats   are   fitted   with  
three-point   inertia   reel   seat   belts.
Do not attach the seat belts to the
stowing   rings   marked   with   a   red   cross,  
represented

  on   the   label.
Take
  care   to   hook   the   seat   belts  
correctly on the rings provided for this
purpose.The row 3 seat belts which are not in
use can be stored to clear the load
space

  and   make   use   of   the   load   space  cover
  easier.
Hook   the   snap   hook   in   the   location  provided
  on   the   rear   pillar   trim.
Seat belts