2017 Citroen BERLINGO MULTISPACE RHD ECO mode

 197
Berlingo2VP_en_Chap09_Caract-technique_ed02-2016Berlingo2VP_en_Chap09_Caract-technique_ed02-2016
ENGINE CHARACTERISTICS
The engine characteristics (capacity,
maximum power, maximum power
speed, fuel, CO
2 emissions...) for your vehicle are given in the registration
certificate.
These characteristics correspond
to the values type-approved
on a test bed, under conditions
defined
 
in
 
European   legislation  
(Directive 1999/99/EC).
For more information, refer to the
manufacturer's website or sales
brochure

 
for
 
the
  model.   Contact  
a

 
CITROËN
 
dealer   or   a   qualified  
workshop.
WEIGHTS AND TOWED LOADS
These values, expressed in kg, can be found on the manufacturer's VIN plate
or
  label.
The maximum weights and towed
loads for your vehicle can be found on
the
  vehicle's   registration   certificate.
The
  kerb   weight   is   equal   to   the   weight  
without

  load   +   driver   (75   kg)   +   fuel   tank  
filled

  to   90%.
The GTW and towed load values
indicated are valid up to a maximum
altitude
  of   1000   metres.  
The
  value   of  
the towed load mentioned must be
reduced by 10 % for each additional
1000

  metres.
With
  load   transfer,   the   braked   trailer  
weight can be increased, on condition
that the equivalent of this load is
removed from the vehicle so that the
GTW

  is   not   exceeded. High ambient temperatures
may result in a reduction in the
performance of the vehicle in
order
  to   protect   the   engine.   When   the  
ambient temperature is higher than
37 °C,

  limit   the   towed   weight.
Towing with a lightly loaded
vehicle can adversely affect road
holding.
Towing
  a   trailer   increases   braking  
distances.
When towing, the maximum permitted
speed is reduced (comply with the
legislation

  in   force   in   the   country).
The recommended nose weight is
the downward force on the towball
(removable
  with   or   without   tools).
GVW: gross vehicle weight, the
maximum
  authorised   weight.
GTW: gross train weight, the maximum
weight
  for   vehicle   plus   trailer.
The location of the manufacturer's
plate is given in chapter 9,
"Identification
  markings"   section.
In each country, it is imperative that
the maximum towed loads authorised
by local legislation are complied
with.
 
T
o   find   out   your   vehicle's   towing  
capacities and its gross train weight,
consult

  a   CITROËN   dealer.
TECHNICAL DATA
9
Weights

199
Berlingo2VP_en_Chap09_Caract-technique_ed02-2016Berlingo2VP_en_Chap09_Caract-technique_ed02-2016
Diesel Engines / Weights
5-seatEngine Gearbox Engine oil
capacity with filter
replacement (litres) Unbraked trailer (kg)
Recommended nose
weight (kg)
1.6 HDi 75 hp 5-speed manual -600 70
1.6 HDi 75 hp FAP 5-speed manual -715 70
BlueHDi 75 hp Euro
65-speed manual
-720 70
1.6 HDi 90 hp 5-speed manual 3.75735 70
1.6 HDi 92 hp FAP 5-speed manual 3.75715 70
1.6 e-HDi 92 hp FAP 5-speed manual 3.75690 70
1.6 BlueHDi 100 hp Euro 6 5-speed manual
3.75600 70
1.6 BlueHDi 100 hp S&S 5-speed manual
3.75600
70
6-speed electronic 60070
1.6 HDi 115 hp FAP 5-speed manual 3.75735 70
1.6 BlueHDi 120 hp Euro 6 6-speed manual
3.75600 70
FA P :
 

particle   filter.
e-HDi :
  model   equipped   with   Stop   &   Start.
TECHNICAL DATA
9
Weights

200
Berlingo2VP_en_Chap09_Caract-technique_ed02-2016Berlingo2VP_en_Chap09_Caract-technique_ed02-2016
7-seatEngine Gearbox Engine oil
capacity with filter
replacement (litres) Unbraked trailer (kg)
Recommended nose
weight (kg)
1.6 HDi 92 hp FAP 5-speed manual 3.75750 70
1.6 BlueHDi 100 hp Euro 6 5-speed manual
3.75600 70
1.6 BlueHDi 100 hp Euro 6 S&S 5-speed manual
3.75600 70
1.6 HDi 115 hp FAP 5-speed manual 3.75750 70
1.6 BlueHDi 120 hp Euro 6 6-speed manual
3.75600 70
FA P :
 

particle   filter.
e-HDi :
  model   equipped   with   Stop   &   Start.
Weights

203
Berlingo2VP_en_Chap10a_SMEGplus_ed02-2016
7-inch touch screen tablet
GPS satellite navigation - Multimedia audio - Bluetooth® telephone
Contents
First steps
2 04
Steering mounted controls
20

6
Menus
 2

07
Navigation


208
Navigation - Guidance
2

16
Traffic
 2

20
Radio Media

2
22
Radio

2
28
DAB (Digital Audio Broadcasting) radio

2
30
Media
2

32
Settings


234
Connected services
2

42
MirrorLink
TM 2 42
CarPlay® 246
T
elephone
2
48
Frequently
  asked   questions  
2
56
The system is protected in such a way that it will only operate in
your
 
vehicle. As a safety measure, the driver should only carry out operations
which
 
require
 
prolonged
 
attention   while   the   vehicle   is   stationary.
The display of an energy economy mode message signals that
electrical
 
systems
 
operating
 
are   going   into   standby.
Refer
 
to
 
the
 
energy
 
economy   mode   section.
Audio and Telematics
TECHNOLOGY on BOARD
10

209
Berlingo2VP_en_Chap10a_SMEGplus_ed02-2016
Level 1Level 2 Level 3 Comments
Navigation Settings
Navigation Enter destination
Display
  recent   destinations.
Route settings Fastest
Choose
  the   navigation   criteria.
The map displays the route chosen according to
these
 c

riteria.
Shortest
Time/distance
Ecological
To l l s
Ferries
Tr a f f i c
Strict-Close
Show route on map
Display
  the   map   and   start   navigation.
Confirm Save
  the   options.
Save current location Save
  the   current   address.
Stop navigation Delete
  the   navigation   information.
Voice synthesis Choose the volume for voice and announcement
of
  street   names.
Diversion Detour from your initial route by a determined
distance.
Navigation Display in text mode
Zoom
  in.
Zoom
  out.
Display
  in   full   screen   mode.
Use
  the   arrows   to   move   the   map.
Switch
  to   2D   map.
Audio and Telematics
TECHNOLOGY on BOARD
10

228
Berlingo2VP_en_Chap10a_SMEGplus_ed02-2016
Press on Radio Media to display the
primary pag e.
Press on Radio Media to display the
primary
 pag

e. Select "
Save".
If necessary, select change of
source. Press on Radio Media
to display the
primary pag e.
Select
  change   source.
"
AM Radio ". By automatic frequency search
Select "FM Radio ".
" AM Radio ".
Press
  on   the   secondary   page.
Or
Select a preset radio station
in
  the   list.
Select " FM Radio ".
Select a radio station from
the
  list   offered.
Select " Update list " to refresh the
list. Select " List"
  in   the   primary   page.
Press on Radio Media to display the
primary
 pag

e.
Radio
Changing a radio frequency
Selecting a station
THEN
Radio reception may be affected by
the use of electrical equipment not
approved by CITROËN, such as a USB
charger
 
connected
 
to
 
the
 
12
 
V
 
socket.
The exterior environment (hills,
buildings,
 
tunnel,
 
car
 
park,
 
below
 
g

round...)
 
may
 
prevent
 
reception,
 
e

ven
 
in
 
RDS
 
station
 
tracking
 
mode.
 
T

his phenomenon is normal in the
propagation of radio waves and is in no
way indicative of a fault with the audio
system.
Select "
Radio list " in the secondary
page. Or
Press 3 or 4 to move the cursor for an
automatic search down or up for a radio
frequency.
Or
To
 
select
 
a
 
preset
 
radio
 
station.
Audio and Telematics

232
Berlingo2VP_en_Chap10a_SMEGplus_ed02-2016
The audio system will only play audio files
with  ".wma,   .aac,   .flac,   .ogg   and   .mp3"   file  
e

xtensions and with a bit rate of between
32 Kbps
  and   320   Kbps.
It
  also   supports   VBR   (Variable   Bit   Rate)   mode.
No
  other   type   of   file   (.mp4,   ...)   can   be   played.
".wma"
  files   must   be   of   the   standard   wma   9   type.
The sampling rates supported are 32, 44 and
48
  KHz.
Information and advice
Media
USB port
Selection of source
The steering mounted SRC (s o u r c e)
button can be used to go to the next
media source, available if the source
is
  active.
Select
 
change
 
of
 
source.
Press on Radio Media
to display the
primary
 pag

e.
The system builds playlists (in temporary
memory),
 
an
 
operation
 
which
 
can
 
take
 
from
 
a f

ew seconds to several minutes at the first
connection.
Reduce the number of non-music files and the
number
 
of
 
folders
 
to
 
reduce
 
the
 
waiting
 
time.
The playlists are updated every time the
ignition is switched off or on connection of a
USB
 
memory
 
stick.
 
The
 
lists
 
are
 
memorised:
 
if
 
t

hey are not modified, the subsequent loading
time
 
will
 
be
 
shorter.
Insert
 
the
 
USB
 
memory
 
stick
 
into
 
the
 
USB
 
port
 o
r connect the USB device to the USB port
using
 
a
 
suitable
 
cable
 
(not
 
supplied).
Auxiliary socket (AUx)
Connect the portable device (MP3 player…) to
the   auxiliary   Jack   socket   using   an   audio   cable  
(

not
 sup
plied).
This source is only available if the "Auxiliary
socket"
  option   has   been   activated   in   the  
"

Media"   settings.
First   adjust   the   volume   of   your   portable   device  
(

to   a   high   level).   Then   adjust   the   volume   of   your  
a

udio   system.
Display and management of the controls are
via
  the   portable   device. Choose
  the   source.
To protect the system, do not use a
USB
 
hub.
Audio and Telematics

233
Berlingo2VP_en_Chap10a_SMEGplus_ed02-2016
It is advisable to restrict file names to
20 characters, without using special characters
(e.g.
  "   "   ?   ;   ù)   to   avoid   any   playing   and  
d

isplaying
 pro
blems.
Use
  only   USB   memory   sticks   formatted   FAT32  
(

file   allocation   table).
The system supports USB mass
storage
  portable   players,   BlackBerry
®
devices or Apple® players via USB
ports.
 
The
 
adaptor   cable   is   not  
sup

plied.
Control of the peripheral device is with
the
 
audio
 
system
 
controls.
Other peripheral devices, not
recognised by the system on
connection, must be connected to the
auxiliary
 
socket
 
using   a   Jack   cable   (not  
sup

plied).
It is recommended that the USB cable
for
 
the
 
portable
 
device   is   used.
To protect the system, do not use a
USB
 
hub.
Bluetooth® audio streaming
Streaming allows audio files on your telephone
to   be   played   through   the   vehicle's   speakers.
Connect
  the   telephone:   see   the   "Telephone "
section, then " Bluetooth".
Choose the " Audio" or "All"
 pro

file.
If play does not start automatically, it may be
necessary
  to   start   the   audio   playback   from   the  
t

elephone.
Control is from the peripheral device or by
using
  the   audio   system   buttons.
Once connected in streaming mode,
the telephone is considered to be a
media
  source.
It is recommended that you activate
" Repeat " on the Bluetooth
® peripheral.
Connecting Apple® players
Connect the Apple® player to the USB port
using
 
a
 
suitable
 
cable   (not   supplied).
Play
 
starts
 
automatically.
Control
 
is
 
via
 
the
 
audio   system.
The classifications available are those
of the portable device connected
(artists
 
/
 
albums   /   genres   /   playlists   /  
a

udiobooks
 
/
  podcasts).
The default classification used is by
artist.
 
To
 
modify   the   classification   used,  
r

eturn to the first level of the menu
then select the desired classification
(playlists for example) and confirm
to go down through the menu to the
desired
 t

rack.
The version of software in the audio system
may not be compatible with the generation of
your Apple
® player.
Audio and Telematics
TECHNOLOGY on BOARD
10