25
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
In practice
It is possible to drive with the right-
hand door open to make it easier to
carry
long loads.
The
left-hand door is
kept
closed by the distinctive "yellow"
lock,
positioned at the base of the door.
This closed door must not be used as
a
load retainer.
Driving with the right-hand door open
is
a special dispensation. Comply with
the usual safety indications to warn
other
drivers.
From inside
When present on the vehicle, pulling
this handle towards you opens the left-
hand door.
Opening to approximately 180°
A check strap system permits extension of the opening from approximately 90°
to
approximately 180°.
Pull the yellow control when the door is
open.
The
check strap will engage again
automatically
on closing.
When parked with the rear doors open to 90°,
the doors mask the rear
lamps.
T
o signal your
position to other road
users driving in the same
direction who may not
have seen your vehicle,
use a warning triangle
or other device required
by the legislation in your
country
.
Access
READY TO GO
3
27
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
CENTRAL LOCKING
An initial press permits
central
locking of the vehicle,
when all of the doors are
closed.
Door open warning lamp
The
control switch LED:
-
flashes
when the doors are locked
with the vehicle stationary and the
engine of
f,
-
comes on when the doors are
locked
and from the time the
ignition
is switched on.
Anti-intrusion security
If this warning lamp comes
on, check that all of your
vehicle's doors are closed
correctly
.
Locking while driving
When the vehicle moves off, as soon
as you reach approximately 6 mph
(10 km/h),
the system locks the doors.
The
characteristic central locking noise
is
heard.
The
LED in the switch on the
dashboard
central switch panel comes on.
During the journey, opening a door results in complete unlocking of the
vehicle.
Activating / deactivating the
function
With the ignition on, press
and hold this switch to
activate or deactivate the
function.
Driving
with
the
doors
locked
may
make
access
to
the
interior
more
difficult
in
an
emergency.
A second press permits central
unlocking
of
the
vehicle.
The control is inactive when the vehicle
has
been
locked
using
the
remote
control
or
the
key
from
the
outside.
The doors can still be opened from the
inside.
Access
READY TO GO
3
32
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Instruments and controls
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
WARNING LAMPS
Warning lamp is indicatesSolution - action
STOP on, associated
with another
warning
lamp and
accompanied
by a message
in
the screen.major
faults linked with
the
"Brake fluid level",
"Engine oil pressure and
temperature", "Coolant
temperature", "Electronic
brake
force distribution" and
"Power steering" warning
lamps.Y
ou must stop as soon as it is safe to do
so. Park and switch off the ignition. Have it
checked by a CITROËN dealer or a qualified
workshop.
Parking
brake
/
Brake fluid
level
/ EBFDon.
that the
parking brake is applied or
has not been released fully.Releasing the parking brake switches off the warning lamp.
on. low
brake
fluid
level. Top up using a fluid recommended by CITROËN.
remaining on even
though the level
is correct and
associated with the
ABS
warning
lamp.
a fault with the electronic
brake force distribution. You must stop as soon as it is safe to do so.
Park and switch off the ignition.
Have it checked by a CITROËN dealer or a
qualified workshop.
Engine oil
pressure and
temperature on while
driving.
low pressure or a high
temperature. Park
and switch off the ignition then allow to cool.
Visually
check the level.
Chapter
7, "Levels" section.
remaining on,
even though the
level is correct.a major fault. Have it checked by a CITROËN dealer or a qualified
workshop.
Each
time
the
vehicle
is
started:
a
series
of
warning lamps comes on applying a self-test check.
They
go off almost
immediately
.
Engine
running:
the
lamp
becomes
a
warning if it remains on continuously or flashes.
This
initial
warning
may
be
accompanied
by an audible signal and a message in the screen.
Do
not
ignore
these
warnings.
33
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Instruments and controls
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Warning lamp isindicatesSolution - action
Coolant
temperature
and level on with needle
in the red
zone.
an abnormal increase in
temperature.
Park
and switch off the ignition then allow to cool.
V
isually check the level.
flashing. a
drop in the coolant level.Chapter
7, "Levels" section.
Contact
a CITROËN dealer or a qualified
workshop.
Service on
temporarily. minor faults or warnings.Consult
the alert log in the display or screen.
If your vehicle is equipped with a trip computer or
a
screen: refer to the "Steering mounted controls"
section
in Chapter 4.
Contact
a CITROËN dealer or a qualified
workshop.
remaining
on. major faults.
Seat belt not
fastened on then
flashing.
the
driver and/or front
passenger has not fastened
their
seat belt.Pull
the strap then insert the tongue in the buckle.
accompanied
by an audible
signal then
remains
on.the vehicle is moving with
the
driver's and/or front
passenger's seat belt not
fastened.Check
that the seat belt is fastened by pulling the
strap.
Chapter
5, "Seat belts" section.
ECO on.
The Stop & Start
system
has put the engine in STOP
mode following a vehicle
stop
(red light, traffic jam,
etc...).As soon as you want to move of
f, the warning
lamp goes off and the engine restarts
automatically
in START
mode.
flashes
for a
few seconds,
then
goes off.STOP mode is temporarily
unavailable.
or
START mode has been
invoked
automatically.Chapter
3, "Stop & Start" section.
READY TO GO
3
34
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Instruments and controls
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Warning lamp isindicatesSolution - action
Front / lateral
airbag flashing
or
remaining
on.a
failure of an airbag.Have
the system checked by a CITROËN dealer
or
a qualified workshop without delay.
Chapter
5, "Airbags" section.
Front
passenger's
airbag
deactivated on. the intentional deactivation
of this airbag in the
presence of a rearward
facing
child seat.Chapter
5, "Airbags" or "child safety" section.
Low fuel
level on with gauge
needle in the
red
zone.When
it first comes on,
there remains around
8 litres
of fuel in the tank.
The distance you can drive
on this fuel depends on
your style of driving and the
engine
type.You
must fill up with fuel to avoid running out.
This warning lamp comes on each time you
switch
on the ignition until you have filled up.
Capacity
of the tank: approximately 60 litres (or
55
litres according to version).
Never
risk driving until the tank is empty, this
could
damage the emissions and injection
systems.
flashing. cutting of
f of the fuel supply
following
a serious impact.Restore
the supply.
Chapter
7, "Fuel" section.
EOBD
emission
control
system flashing
or
remaining
on.a
failure of the system.There
is a risk of damage to the catalytic
converter
. Have it checked by a CITROËN
dealer
or a qualified workshop.
Battery
charge on.
a fault in the charging
circuit. Check
the battery terminals, …
Chapter
8, "Battery" section.
flashing. placing of the active
functions on standby
(economy
mode).Chapter
8, "Battery" section.
remaining on,
in spite of the
checks. an
ignition or injection
malfunction.Have
it checked by a CITROËN dealer or a
qualified
workshop.
+
ABS
35
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Instruments and controls
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Warning lamp isindicatesSolution - action
Power
steering on. a fault with the
system.
The vehicle
retains conventional steering without assistance. Have
it checked by a CITROËN dealer or a qualified workshop.
Door open
detectionon and accompanied
by a message in the
screen. that a door is not
closed
correctly.Check
that all of the doors are closed.
ABS remaining
on.a fault with the anti-
lock
braking system.The
vehicle retains conventional braking.
Have
it checked by a CITROËN dealer or a
qualified
workshop.
ESC flashing.
triggering of the ASR
or
DSC regulation.The system optimises traction and improves the
directional
stability of the vehicle.
Chapter
5, "Driving safety" section.
remaining
on.a fault with the
system.
E.g.:
under-inflation
of
the tyres.E.g.:
check the pressure of the tyres.
Have
it checked by a CITROËN dealer or a
qualified
workshop. (Wheel speed sensor,
hydraulic
valve block, ...).
Under-
inflation on.
the tyre pressure is
too low in or more
wheels.Check
the tyre pressure as soon as possible.
This
check must be done with the tyres cold.
flashing
then
remaining on,
accompanied by the
Service warning
lamp, and depending
on equipment, the
display
of a message.the tyre pressure
monitoring system
has a fault or one of
the wheels does not
have
a sensor.Detection
of under-inflation is no longer assured.
Have
it checked by a CITROËN dealer or a
qualified
workshop.
Particle filter on. a problem with the
particle
filter (fuel
additive
level, risk of
blockage, ...).Have
the filter checked by a CITROËN dealer or
a
qualified workshop.
Chapter
7, "Levels" section.
READY TO GO
3
36
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Instruments and controls
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Warning lamp isindicatesSolution - action
Dipped beam
headlamps
/
Daytime
running
lamps on.a manual selection or
automatic illumination of
headlamps.
Turn
the ring on the lighting control stalk to the
second
position.
illumination of the dipped beam headlamps
from the time the ignition is switched on: daytime running lamps (depending on the
country
in which the vehicle is sold).
Chapter 4, "Steering mounted controls" section.
Main beam
headlamps pullin
g
of
the
stalk
towards
you. Pull
the stalk to return to dipped beam
headlamps.
Direction
indicators flashing
with
audible
signal. a change of direction via
the
lighting
stalk. Flashing
right: push stalk downwards.
Flashing
left: push stalk upwards.
Front
foglamps on.
a
manual
selection. The foglamps only operate if the sidelamps or
dipped
beam headlamps are on.
Rear
foglamps on.
a
manual
selection. The foglamps only operate if the sidelamps or
dipped
beam headlamps are on.
In conditions of normal visibility, switch them off
to
avoid breaking the law.
"This
lamp is a dazzling red".
37
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Instruments and controls
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Warning lamp
in the screenis
indicates Solution - action
Cruise
control on.
cruise
control selected.Manual
selection.
Chapter
4, "Steering mounted controls" section.
Speed limiter on.speed
limiter selected.Manual
selection.
Chapter
4, "Steering mounted controls" section.
Gear shift
indicator on.a recommendation
independent of the type and
density
of traffic.To reduce fuel consumption, change to an
appropriate
gear with a manual gearbox.
The driver retains responsibility to follow this
indication
or not.
Diesel
pre-heating on.climatic conditions requiring
pre-heating. Wait until the warning lamp goes off before
operating
the starter.
Presence of
water in the
Diesel filter
on and
accompanied by
a message in
the
screen.
water in the Diesel filter. Have the filter bled by a CITROËN dealer or a qualified
workshop without delay.
Chapter 7, "Checks" section.
According
to country.
Service
spanner on.that a service will be due
shortly. Refer
to the list of checks in the maintenance and
warranty
guide.
Have the service carried out by a CITROËN
dealer
or a qualified workshop.
Time flashing. adjustment
of the time.Use
the left-hand button on the instrument panel.
Chapter
3, "Instruments and controls" section.
READY TO GO
3