2017 Abarth 500 warning light

[x] Cancel search: warning light

Page 75 of 192

Abarth 500 2017  Owner handbook (in English) Main recommendations to carry
children safely
Install the child restraint systems on
the rear seat, which is the most
protected position in the event of an
impact.
Keep children in rear facing child
r

Page 77 of 192

Abarth 500 2017  Owner handbook (in English) The front airbags (driver, passenger,
driver's knee bags) are designed and
calibrated to protect front seat
passengers wearing seat belts.
Their volume at the moment of
maximum inflation fills mos

Page 81 of 192

Abarth 500 2017  Owner handbook (in English) WARNING
92)Do not apply stickers or other objects
on the steering wheel, on the dashboard in
the passenger side airbag area, on the
side upholstery on the roof and on the
seats. Never put objects (e.g

Page 82 of 192

Abarth 500 2017  Owner handbook (in English) 102)When the ignition key is turned to
MAR, thewarning light switches for few
seconds, then if the passenger airbag
protection is active it should switch off.
103)Do not wash the seats with water or
p

Page 84 of 192

Abarth 500 2017  Owner handbook (in English) STARTING THE
ENGINE
The car is fitted with an electronic
engine lock device: if the engine fails to
start, see the paragraph "Fiat CODE
system" in the "Knowing your car"
chapter.
PROCE

Page 85 of 192

Abarth 500 2017  Owner handbook (in English) PARKING THE
VEHICLE
When parking and leaving the car,
proceed as follows:
engage a gear (1st gear if facing
uphill or reverse if facing downhill) and
leave the wheels turned;
stop the engine and engag

Page 86 of 192

Abarth 500 2017  Owner handbook (in English) USING THE MANUAL
GEARBOX
To engage the gears, fully depress the
clutch pedal and put the gear lever
into the required position (the diagram
is shown on the knob fig. 74).
114)
19)
To engage reverse R

Page 91 of 192

Abarth 500 2017  Owner handbook (in English) WARNING
21)For correct operation of the system,
sensors must always be clean from mud,
dirt, snow or ice. Be careful not to scratch
or damage the sensors while cleaning
them. Avoid using dry, rough or