Page 79 of 741
RAV4_OM_OM42A41U_(U)
792. Instrument cluster
2
Instrument cluster
Warning lights inform the driver of malfunctions in the indicated vehi-
cle’s systems.
Warning lights
*1
(U.S.A.)
Brake system warning
light ( →P. 615)*1SRS warning light
(→P. 616)
*1
(Canada)
Brake system warning
light ( →P. 615)*1
(U.S.A.)
ABS warning light
(→P. 616)
*1
(if equipped)
Charging system
warning light ( →P. 615)*1
(Canada)
ABS warning light
(→P. 616)
*1
(U.S.A.)
Malfunction indicator
lamp ( →P. 615)*1Electric power steering
system warning light
(→P. 616)
*1
(Canada)
Malfunction indicator
lamp ( →P. 615)*1
Slip indicator ( →P. 616)
*1
(if equipped)
Low engine oil pressure
warning light (→P. 615)
(if equipped)
Open door warning light
(→P. 616)
Page 80 of 741
80
RAV4_OM_OM42A41U_(U)
2. Instrument cluster
*1: These lights turn on when the engine switch is turned to the “ON” position(vehicles without smart key system) or IGNITION ON mode (vehicles with
smart key system), to indicate that a system check is being performed.
They will turn off after the engine is started, or after a few seconds. There
may be a malfunction in a system if the lights do not come on, or turn off.
Have the vehicle inspected by your Toyota dealer.
*2: The light flashes to indicate a malfunction.
*3: The light comes on to indicate that the intuitive parking assist sensor is dirtyor covered with ice.
*4: This light illuminates on the center panel.
Seat belt reminder light
(→P. 616)*1
(if equipped)
Low washer fluid
warning light ( →P. 618)
Low fuel level warning
light ( →P. 617)*2, 3, 4
(if equipped)
Intuitive parking assist
indicator ( →P. 618)
*1
(if equipped)
High engine coolant
temperature warning
light ( →P. 617)*1
(if equipped)
Master warning light
(→P. 626)
*1
(U.S.A.)
(if equipped)
Maintenance required
reminder light ( →P. 617)
*1, 2
(if equipped)
PCS warning light
(→P. 618)
*1
(if equipped)
Automatic transmission
fluid temperature
warning light ( →P. 617)
(amber)
(if equipped)
LDA warning light
(→P. 619)
*1
(if equipped)
Dynamic Torque Control
AWD system warning
light ( →P. 617)*1
(if equipped)
Tire pressure warning
light (→P. 619)
(yellow)
(if equipped)
Cruise control warning
light (→P. 617)
Page 81 of 741
RAV4_OM_OM42A41U_(U)
812. Instrument cluster
2
Instrument cluster
The indicators inform the driver of the operating state of the vehicle’s
various systems.
Indicators
Turn signal indicator
( →P. 210)*1VSC OFF indicator
(→P. 299)
(U.S.A.)
Headlight indicator
(→P. 212)*1
(if equipped)
“TRAC OFF” indicator
(→P. 299)
(Canada)
Tail light indicator
(→P. 212)*3Security indicator
(→P. 73)
Headlight high beam
indicator ( →P. 214) “SPORT” indicator
(
→P. 205)
(green)
(if equipped)
Automatic High Beam
indicator ( →P. 216) “ECO MODE” indicator
(
→P. 205)
(if equipped)
Fog light indicator
(→P. 220)*1Eco Driving Indicator
Light ( →P. 83)
(green)
(if equipped)
Cruise control indicator
(→P. 272)*1
(if equipped)
All-wheel drive lock
indicator ( →P. 296)
(if equipped)
Dynamic radar cruise
control indicator
(→P. 260)*1
(if equipped)
“AUTO LSD” indicator
(→P. 299)
Cruise control “SET”
indicator ( →P. 272)
*3
(if equipped)
Intuitive parking assist
indicator (→P. 277)
*1, 2Slip indicator
(→P. 298)
(if equipped)
Intuitive parking assist
indicator ( →P. 278)
Page 82 of 741
82
RAV4_OM_OM42A41U_(U)
2. Instrument cluster
*1: These lights turn on when the engine switch is turned to the “ON” position(vehicles without smart key system) or IGNITION ON mode (vehicles with
smart key system), to indicate that a system check is being performed.
They will turn off after the engine is started, or after a few seconds. There
may be a malfunction in a system if the lights do not come on, or turn off.
Have the vehicle inspected by your Toyota dealer.
*2: The light flashes to indicate that the system is operating.
*3: This light illuminates on the center panel.
*4: In order to confirm operation, the BS M outside rear view mirror indicators
illuminate in the following situations:
• When the engine switch is turned to the “ON” position (vehicles without smart key system) or IGNITION ON mode (vehicles with smart key sys-
tem) while the system is set to on.
• When the system is set to on while the engine switch is in the “ON” posi- tion (vehicles without smart key system) or IGNITION ON mode (vehicles
with smart key system).
If the system is functioning correctly, the BSM outside rear view mirror indi-
cators will turn off after a few seconds.
If the BSM outside rear view mirror indicators do not illuminate or do not
turn off, there may be a malfunction with the system. If this occurs, have the
vehicle inspected by your Toyota dealer.
*5: This light illuminates on the outside rear view mirrors.
*6: The light turns on when the system is off.
*7: When the outside temperature is approximately 37° F (3°C) or lower, the
indicator will flash for approximately 10 seconds, then stay on.
(if equipped)
LDA indicator
( →P. 252)*1, 3“AIR BAG ON/OFF”
indicator ( →P. 49)
*4, 5
(if equipped)
BSM outside rear
view mirror indicators
(→P. 305)*1, 6
(if equipped)
PCS warning light
(→P. 242)
(if equipped)
BSM indicator ( →P. 305)
*7
(if equipped)
Ice warning indicator
(→P. 635)
Page 83 of 741
RAV4_OM_OM42A41U_(U)
832. Instrument cluster
2
Instrument cluster
■Eco Driving Indicator
Suggests Zone of Eco driving and Eco driving ratio based on acceleration.
Eco Driving Indicator will not operate in the following conditions:
● The shift lever is anything other than D.
● Paddle shift switch (if equipped) is operated.
● Neither normal mode nor Eco drive mode is selected. ( →P. 205)
● The vehicle speed is approximately 80 mph (130 km/h) or higher. Eco Driving Indicator Light
During Eco-friendly acceleration (Eco
driving), Eco Driving Indicator Light will
turn on.
When the acceleration exceeds Zone of
Eco driving, or when the vehicle is
stopped, the light turns off.
Eco Driving Indicator Light availability
can be customized. The default setting
is on. ( →P. 91, 697)
Eco Driving Indicator Zone Display
Suggests the Zone of Eco driving with
current Eco driving ratio based on
acceleration.
With monochrome display: Eco Driving
Indicator Zone Display availability can
be customized at your Toyota dealer.
The default setting is off.
Zone of Eco driving
Eco driving ratio based on acceleration
With monochrome display: If the accel-
eration exceeds Zone of Eco driving,
the right side of Eco Driving Indicator
Zone Display blinks.
With color display: If the acceleration
exceeds the Zone of Eco driving, the
right side of the Eco Driving Indicator
Zone Display illuminates.
With monochrome display
With color display
1
2
3
4
Page 84 of 741
84
RAV4_OM_OM42A41U_(U)
2. Instrument cluster
WARNING
■If a safety system warning light does not come on
Should a safety system light such as the ABS and SRS warning light not
come on when you start the engine, this could mean that these systems are
not available to help protect you in an accident, which could result in death
or serious injury. Have the vehicle inspected by your Toyota dealer immedi-
ately if this occurs.
NOTICE
■ To prevent damage to the engine and its components (with mono-
chrome display)
The engine may be overheating if the high engine coolant temperature
warning light flashes or turns on. In this case, immediately stop the vehicle
in a safe place, and check the engine after it has cooled completely.
(→P. 664)
Page 87 of 741
RAV4_OM_OM42A41U_(U)
872. Instrument cluster
2
Instrument cluster
With monochrome display
→ P. 8 9
With color display
Switches the items of the odome-
ter and trip meter display by
pressing the “TRIP” switch.
When the trip meter is displayed,
pressing and holding the “TRIP”
switch will reset the trip meter.
The brightness of the instrument pan el lights can be adjusted by turn-
ing the dial.
Brighter
Darker
Changing the odometer and trip meter display
Instrument panel light control
1
2
Page 91 of 741
RAV4_OM_OM42A41U_(U)
912. Instrument cluster
2
Instrument cluster
Eco Driving Indicator Light can be activated or deactivated.While the odometer is being
displayed, press and hold the
“DISP” button to display the
Eco Driving Indicator Light cus-
tomization screen.
Press the “DISP” button to set Eco Driving Indicator Light to on or
off.
Press and hold the “DISP” button to complete the setting.
■When disconnecting and reco nnecting battery terminals
The following information data will be reset:
● Trip meters “A” and “B”
● Average fuel consumption
● Average vehicle speed
● Driving range
■ Customization
Settings can be changed. (Customizable features: →P. 696)
Eco Driving Indicator Light customization
1
2
3
