Page 101 of 291
TIPS FOR OPERATING THE AUDIO/VISUAL SYSTEM
99
AUDIO
3
File type Bit rate (kbps)
$ $ & ¿ O H V
MPEG4/AAC-LC16 - 320
”The player is compatible with VBR (Variable Bit Rate).
”MP3 (MPEG Audio Layer 3), WMA (Windows Media
Audio) and AAC (Advanced Audio Coding) are audio
compression standards.
Page 105 of 291
TIPS FOR OPERATING THE AUDIO/VISUAL SYSTEM
103
AUDIO
3
MP3
”MP3 is an audio compression standard determined
by a working group (MPEG) of the ISO (International
Standard Organization). MP3 compresses audio data
to about 1/10 the size of that on conventional discs.
WMA
”WMA (Windows Media Audio) is an audio
compression format developed by Microsoft®. It
F R P S U H V V H V
Page 110 of 291
PHONE OPERATION (HANDS-FREE SYSTEM FOR CELLULAR PHONES)
108
NOTE
OKeep call volume down. Otherwise, the other party’s voice
may be audible outside the vehicle and voice echo may
increase. When talking on the phone, speak clearly towards the
microphone.
OThe other party may not hear you clearly when:
‡ <00270055004c0059004c0051004a000300520051000300440051000300580051005300440059004800470003005500520044004700110003000b00300044004e004c0051004a00030048005b0046004800560056004c005900480003005700550044004900
bf0046000300510052004c005600480011000c>
‡ Driving at high speeds.
‡ Driving with a window open.
‡ When air from the ventilator blows directly toward the
microphone.
‡ The sound of the air conditioning fan is loud.
‡ There is a negative effect on sound quality due to the phone
and/or network being used.
REGISTERING/CONNECTING A Bluetooth
PHONE
To use the hands-free system for cellular phones, it is
necessary to register a cellular phone with the system.
: 3
Bluetooth PHONE CONDITION DISPLAY
The condition of the Bluetooth phone appears on the upper
U L J K W V L G H R I W K H V F U H H Q : 3
USING THE PHONE SWITCH/MICROPHONE
XSteering switch
By pressing the phone switch, a call can be received or
ended without taking your hands off the steering wheel.
Volume control switch
”Press the “+” side to increase the volume.
”Press the “-” side to decrease the volume.
Off hook switch
On hook switch
XMicrophone
The microphone is built into the map light slits.
Page 232 of 291
TIPS FOR THE NAVIGATION SYSTEM
230
CAUTION
OThe installation of window tinting may obstruct the GPS
signals. Most window tinting contains some metallic content
that will interfere with GPS signal reception of the antenna in
the instrument panel. We advise against the use of window
tinting on vehicles equipped with navigation systems.
”Accurate current position may not be shown in the
following cases:
‡ When driving on a small angled Y-shaped road.
‡ When driving on a winding road.
‡ When driving on a slippery road such as in sand,
gravel, snow, etc.
‡ When driving on a long straight road.
‡ When freeway and surface streets run in parallel.
‡ After moving by ferry or vehicle carrier.
‡ When a long route is searched during high speed
driving.
‡ After repeating a change of direction by going
forward and backward, or turning on a turntable in
a parking lot.
‡ When leaving a covered parking lot or parking
garage. ‡ When a roof carrier is installed.
‡ When driving with tire chains installed.
‡ When the tires are worn.
‡ After replacing a tire or tires.
‡ When using tires that are smaller or larger than the
I D F W R U \ V S H F L ¿ F D W L R Q V
‡ When the tire pressure in any of the 4 tires is not
correct.
”Inappropriate route guidance may occur in the
following cases:
‡ When turning at an intersection off the designated
route guidance.
‡ If you set more than 1 destination but skip any of
them, auto reroute will display a route returning to
the destination on the previous route.
‡ When turning at an intersection for which there is
no route guidance.
‡ When passing through an intersection for which
there is no route guidance.
‡ During auto reroute, the route guidance may not be
available for the next turn to the right or left.
‡ During high speed driving, it may take a long time
for auto reroute to operate. In auto reroute, a detour
route may be shown.
Page 236 of 291
VOICE RECOGNITION SYSTEM OPERATION
234
VOICE RECOGNITION SYSTEM OPERATION
VOICE RECOGNITION SYSTEM
The voice recognition system enables the navigation,
audio, hands-free systems, etc. to be operated using voice
commands.
Refer to the command list for samples of voice commands.
: 3
USING THE VOICE RECOGNITION SYSTEM
STEERING SWITCH
Talk switch
”Press the talk switch to start the voice recognition
system.
”To cancel voice recognition, press and hold the talk
switch.
MICROPHONE
The microphone is built into the map light slits.
”It is unnecessary to speak directly into the
microphone when giving a command.
NOTE
O :<0044004c0057000300490052005500030057004b0048000300460052005100bf0055005000440057004c0052005100030045004800480053000300450048004900520055004800030056005300480044004e004c0051004a00030044000300460052005000
500044005100470011>
OVoice commands may not be recognized if:
‡ Spoken too quickly.
‡ Spoken at a low or high volume.
‡ Driving with a window open.
‡ Passengers are talking while voice commands are spoken.
‡ The air conditioning speed is set high.
‡ When air from the ventilator blows directly toward the
microphone.
OIn the following conditions, the system may not recognize the
command properly and using voice commands may not be
possible:
‡ The command is incorrect or unclear. Note that certain words,
D F F H Q W V R U V S H H F K S D W W H U Q V P D \ E H G L I
