2016 SUBARU FORESTER instrument panel

About EyeSight
8
ŸContinued from previous page
xDo not install any accessories other than the ones designated by SUBARU on the pro-
hibited areas shown in the illustrations (grey zones). Doing so may affect the stereo
cameras’ field of view and could prevent the EyeSight system from functioning properly.
If you must affix any stickers, such as automobile inspection certificate stickers, or install
accessories, do not cover the front of the cameras. If abnormal EyeSight operation
occurs, remove the stickers or accessories.
xIf the top of the instrument panel is polished with chemicals or other substances, the ste-
reo cameras may not be able to detect objects accurately and the EyeSight system may
not operate properly due to reflections in the front windshield.
xDo not place any objects on top of the instrument panel and do not coat the surface
above the instrument panel with chemical liquid. The stereo cameras may not be able to
detect objects accurately and the EyeSight system may not function properly due to
reflections in the front windshield. For details, contact a SUBARU dealer.
xDo not install any wiper blades other than genuine SUBARU wiper blades. Doing so
may affect the stereo cameras’ field of vision and could prevent the EyeSight system
from functioning properly.
xReplace damaged wiper blades as soon as possible. The stereo cameras may not be
able to detect objects accurately and the EyeSight system may not function properly
due to liquid remaining on the windshield.
xKeep the windshield (outside and inside) clean at all times. When the windshield has
become fogged, or it has dirt or an oil film on it, the stereo camera may not detect
objects accurately and the EyeSight system may not operate correctly. Never mount
any device to the center air vent, as any air flow change may impact performance of the
EyeSight system.
xNever mount any device to the center air vent, as any air flow change may impact
EyeSight performance.
S02031Monitor or other accessories

About EyeSight
12
■Combination meter

Instrument panel display layout
SPORTEye
SightStay
AlertObstacle
DetectedLane
Departure
MPH
miles
S01858
SI-DRIVE indicator lights Customization display
EyeSight temporary
stop indicator Set vehicle speed display READY indicatorSET indicator Steering wheel indicatorLane indicator (right) Following distance setting
indicator
X-mode indicator
lightLane indicator (left)
Lead vehicle indicator
Selector indicator /
shift position indicator
Conventional
Cruise Control
indicator
Adaptive Cruise
Control indicator
EyeSight
warning
light
Lane Departure Warning
OFF indicator light
Brake system warning
light (red) Pre-Collision Braking System
OFF indicator light

About EyeSight
18
■Steering wheel switches
● (CRUISE) switch
xSwitches cruise control* on/off.
* Refer to page 28.
xWhen this switch is pressed and “ ” or “ ” appears on the instrument panel, the
main cruise control is on.
*Adaptive Cruise Control and Conventional Cruise Control
●SET/- switch
xCan be used to set cruise control*.
xCan be used to reduce the set vehicle speed (when cruise control* is currently set).
* Adaptive Cruise Control and Conventional Cruise Control
●RES/+ switch
xAfter cruise control* is canceled, this switch can be used to resume the cruise control
function at the vehicle speed that was previously set.
xCan be used to increase set vehicle speed (when cruise control
* is currently set).
*Adaptive Cruise Control and Conventional Cruise Control
Switch layout
S00812
SwitchSwitch(CRUISE) switch
(INFO)/SET switch(Following distance
setting) switch
CANCEL switch
RES/+ switch
SET/- switch

S/I switch
S switch
I switch S#/I switch

About EyeSight
20
● switch/ switch
The screen displayed on the multi function display can be switched.
● (Info)/SET switch
The pop up screen displayed on the multi function display can be displayed again.
* Refer to page 81.
■ Pre-Collision Braking System OFF switch
Press and hold this switch for approximately 2
seconds or longer to turn off the Pre-Collision
Braking System and Pre-Collision Throttle
Management.
When these functions are off, the Pre-
Collision Braking System OFF indicator light
on the instrument panel illuminates.
Press and hold the switch again to turn on the
Pre-Collision Braking System and Pre-
Collision Throttle Management. This turns off
the Pre-Collision Braking System OFF indica-
tor light.
* Refer to page 51.
■ Lane Departure Warning OFF switch
Press and hold this switch for approximately 2
seconds or longer to turn off the Lane
Departure Warning and Lane Sway Warning
functions.
When these functions are off, the Lane
Departure Warning OFF indicator light on the
instrument panel illuminates.
Press and hold the switch again to turn on the
Lane Departure Warning and Lane Sway
Warning functions. This turns off the Lane
Departure Warning OFF indicator light.
* Refer to page 60.
S00813
S00814

Pre-Collision Braking System
51
When pressing and holding the Pre-Collision
Braking System OFF switch for approximately
2 seconds (or longer), a single short beep will
sound and the Pre-Collision Braking System
(including Pre-Collision Brake Assist) will turn
off. When this control is turned off, the Pre-
Collision Braking System OFF indicator light
on the instrument panel illuminates. To turn
the control back on, press and hold the Pre-
Collision Braking System OFF switch for
approximately 2 seconds or longer again.
When this control is turned on, the Pre-
Collision Braking System OFF indicator light
will turn off.
■Pre-Collision Braking System OFF indicator light
This indicator light illuminates when the
ignition switch is turned to the ON position,
and remains illuminated for approximately 7
seconds after the engine starts. It turns on
when the Pre-Collision Braking System is
turned off.
It also illuminates under the following
conditions.
xWhen the VDC OFF switch is pressed and
VDC is canceled
xWhen the EyeSight system has a
malfunction
* Refer to page 76.
xWhen the EyeSight system has stopped
temporarily
* Refer to page 77.
Turning off the Pre-Collision Braking System
NOTE
xWhen the Pre-Collision Braking System is turned off, the Pre-Collision
Throttle Management Control function is also turned off.
xEven when the Pre-Collision Braking System is turned off, if the ignition
switch is turned off and the engine is then restarted, the Pre-Collision
Braking System will be turned on. The system default setting when the
vehicle is restarted in “ON”.
S00813
S00840

Pre-Collision Throttle Management
57
When pressing and holding the Pre-Collision Braking System OFF switch for approximately
2 seconds or longer a single short beep will sound and the Pre-Collision Throttle
Management System will turn off. When this function is turned off, the Pre-Collision Braking
System OFF indicator light on the instrument panel illuminates.
To turn the system back on, press and hold the Pre-Collision Braking System OFF switch
again for approximately 2 seconds or longer. When this function is turned on, the Pre-
Collision Braking System OFF indicator light turns off.
* Refer to page 51.
Turning off Pre-Collision Throttle Management
NOTE
xWhen Pre-Collision Throttle Management is turned off, the Pre-Collision
Braking System also turns off.
xEven when Pre-Collision Throttle Management is turned off, if the ignition
switch is turned off and the engine is restarted, Pre-Collision Throttle
Management will be turned on. The default setting for Pre-Collision
Throttle Management when the vehicle is restarted is “ON”.
S00813S00840

Lane Departure Warning
60
When pressing and holding the Lane
Departure Warning OFF switch for approxi-
mately 2 seconds or longer, a single short
beep will sound and the Lane Departure
Warning will turn off. When this function is
turned off, the Lane Departure Warning OFF
indicator light on the instrument panel will illu-
minate.
To turn the function back on, press and hold
the Lane Departure Warning OFF switch
again. When the function is turned on, the
Lane Departure Warning OFF indicator light
will turn off.
■Lane Departure Warning OFF indicator light
This indicator illuminates when the ignition
switch is turned to the ON position, and then
approximately 7 seconds after the engine
starts, it turns off. It turns on when the Lane
Departure Warning feature is turned off.
It also illuminates under the following
conditions.
xWhen the VDC OFF switch is pressed and
VDC is canceled
xWhen the EyeSight system has a
malfunction
* Refer to page 76.
xWhen the EyeSight system has stopped
temporarily
* Refer to page 77.
Turning off Lane Departure Warning
NOTE
xWhen the Lane Departure Warning is turned off, the Lane Sway Warning is
also turned off.
xEven when the Lane Departure Warning is turned off, if the ignition switch
is turned off and then the engine is restarted, the Lane Departure Warning
will be turned on. The default setting for the Lane Departure Warning when
the vehicle is restarted is “ON”.
S00814
S00847

Lane Sway Warning
63
Press and hold the Lane Departure Warning OFF switch for approximately 2 seconds or
longer to turn off the Lane Sway Warning. When this function is turned off, a single short
beep sounds and the Lane Departure Warning OFF indicator light on the instrument panel
illuminates.
To turn the function back on, press and hold the Lane Departure Warning OFF switch again
for approximately 2 seconds or longer. When the function is turned on, the Lane Departure
Warning OFF indicator light turns off.
* Refer to page 60.
Turning off Lane Sway Warning
NOTE
xWhen the Lane Sway Warning is turned off, the Lane Departure Warning is
also turned off.
xEven when the Lane Sway Warning is turned off, if the ignition switch is
turned off and then the engine is restarted, the Lane Sway Warning will be
turned on. The default setting for the Lane Sway Warning after the vehicle
is restarted is “ON”.
S00814S00847