2016 SUBARU FORESTER fog light

About EyeSight
3
Continued on next page Ÿ
CAUTION
xThe characteristics of the stereo cameras are similar to those of human eyes. For this
reason, conditions that make it difficult for the driver to see in the forward direction have
the same effect on the stereo cameras and make it difficult for the system to detect vehi-
cles, obstacles and traffic lanes.
xDetection by the EyeSight system is limited to objects that are within the range of the
stereo cameras’ field of vision. Also, after an object enters the range of the cameras’
field of vision, it may take some time for the system to detect it as a controllable target
and warn the driver.
xUnder the conditions listed below, it will become more difficult for the system to detect
the vehicle in front, motorcycles, bicycles, pedestrians and obstacles on the road and
lane markers, and EyeSight may temporarily stop operating. However, the system will
resume operation once these conditions have improved and the vehicle is driven for a
short period of time.
- Bad weather (for example heavy rain, a blizzard or thick fog). In particular, the system
is more likely to temporarily stop operating when there is an oil film adhering to the
windshield, a glass coating has been applied or old wipers are used.)
- When affected by strong light from the front (sunlight or headlight beams, etc.)
- The windshield has become fogged, or snow, dirt, dust or frost has adhered to it,
reducing the stereo cameras’ field of view.
- The vehicle is tilted at an extreme angle due to loaded cargo or other factors.
- When the stereo cameras’ field of view is obstructed (for example by a canoe on the
roof of the vehicle)
- When visibility is poor due to sand, smoke or water vapor in the air, or when the vehi-
cle in front or oncoming traffic causes water, snow, dirt or other substances to obscure
the view
S02030
Low objects surrounding the vehicle cannot
be detected.

Pre-Collision Braking System
44
ŸContinued from previous page
- Even if the obstacle is a motorcycle, bicycle or pedestrian, depending on
the brightness of the surroundings as well as the relative movement, and
aspect or angle of the object, there may be cases when the system can-
not detect it.
- When the system determines that operation by the driver (based on
accelerator pedal operation, braking, steering wheel angle, etc.) is
intended as evasive action
- Vehicle maintenance status (brake systems, tire wear, tire pressure,
whether a temporary spare tire is being used, etc.)
- When towing a trailer or vehicle, etc.
- When the brakes are cold due to outside temperature being low or just
after starting the engine.
- When the brakes are overheated on downhill grades (braking effective-
ness is reduced)
- When driving in rain or after washing the vehicle (the brakes are wet and
braking effectiveness is reduced)
- Recognition conditions of the stereo cameras
In particular, the function may be unable to stop the vehicle or may not
activate in the following cases.
• Bad weather (for example heavy rain, a blizzard or thick fog)
• When visibility is poor due to sand, smoke or water vapor in the air or
when the vehicle in front or oncoming traffic causes water, snow, dirt,
dust or other substances to obscure the view through the windshield
• When driving at night or in a tunnel without the headlights on
• When driving at night or in a tunnel when there is a vehicle in front that
does not have its taillights on
• When approaching a motorcycle, bicycle or pedestrian at night
• When ambient light is poor in the evening or early morning
• When a vehicle, motorcycle, bicycle or pedestrian is outside the area
illuminated by the headlights
• When affected by strong light from the front (for example, sunlight at
dawn, sunset or headlight high beams, etc.)
• When there is snow, frost, dirt or dust on the windshield or it is clouded
• When fluid has not been fully wiped off the windshield during or after
washer use
• When the target cannot be correctly recognized because the stereo
cameras’ view is obstructed by water droplets from rain or the window
washer, or by the wiper blades.
• When the stereo cameras’ field of view is obstructed (for example by a
canoe on the roof of the vehicle)
• When the rear aspect of
the vehicle in front is
low, small or irregular
(the system may recog-
nize another part of the
vehicle as its rear and
will determine operation
from that)
- When there is an
empty truck or trailer
with no rear and/or
side panels on the
cargo bed
- With vehicles that
have cargo protruding
from their back ends
- With non-standard
shaped vehicles (vehicle transporters or vehicles with a sidecar
fitted, etc.)
- When the height of the vehicle is low, etc.
S01928

Pre-Collision Throttle Management
53
Continued on next page Ÿ
xPre-Collision Throttle Management will not reduce acceleration under all
conditions. It is also not designed to prevent collisions.
xPre-Collision Throttle Management will operate when an obstacle is
detected in front. However, this function will not reduce acceleration in
cases where no obstacle is recognized (for example when approaching a
cliff, etc.)
xDo not intentionally depress the accelerator pedal excessively when there
are obstacles nearby. If the driver relies only on Pre-Collision Throttle
Management to control acceleration, collisions may occur.
xIf your vehicle is trapped on a railroad crossing and you are trying to
escape by driving through the crossing gate, the stereo cameras may rec-
ognize the crossing gate as an obstacle and Pre-Collision Throttle
Management system may activate. In this case, remain calm and either
continue to depress the accelerator pedal or turn off the Pre-Collision
Throttle Management system.
* Refer to page 57.
xPre-Collision Throttle Management may not activate depending on the fol-
lowing conditions:
- The distance between your vehicle and the obstacle, speed difference,
and lateral displacement (amount of offset)
- Recognition status of the stereo cameras
In particular, the function may not activate in the following cases:
• Bad weather (for example heavy rain, a blizzard or thick fog)
• When visibility is poor due to sand or smoke in the air
• When light is poor in the evening, early morning, or at night
• In a dark area (indoor parking area, etc.)
• When there is an obstacle outside the area illuminated by the head-
lights
• When affected by strong light from the front (for example sunlight at
sunrise or sunset headlight high beams, etc.)
• When there is snow, frost, dirt or dust on the windshield, or it is clouded
• When fluid has not been fully wiped off the windshield during or after
use of the window washer
• When obstacles cannot be correctly recognized due to water droplets
from rain or the washer, or the wiper blades obstructing the stereo cam-
eras’ field of view
• When the stereo cameras’ field of view is obstructed (for example by a
canoe on the roof of the vehicle)
• With low obstacles (low wall, crash barrier, low vehicle, etc.)
• When the size and height of an obstacle is smaller than the limitations
of the stereo cameras’ recognition capability
• With small animals or children
• With pedestrians who are sitting or lying down

EyeSight malfunction and temporary stop
77
■Temporary stop
The buzzer will sound one short beep, and the
Pre-Collision Braking System OFF indicator
light and Lane Departure Warning OFF
indicator light will illuminate at the same time.
A symbol of “E1”, “E2” or “E3” is displayed on
the meter display, and a pop-up screen is
displayed on the multi function display. (When
the main cruise control is off, they are not
displayed.)
When the cause has been eliminated,
temporary stop will be canceled and the
EyeSight system will automatically restart.
Display Cause Action

It is difficult for the stereo
cameras to detect objects in
front
xThe front windshield is
dirty or fogged up
xPoor weather conditions
xStrong light from the front
xExtremely hot or cold
temperaturesxClean the front windshield.
xIn bad weather or if there is
strong light from the front,
the EyeSight system will
restart once you have
driven your vehicle for a
period of time and the
conditions affecting the
system have improved.
Also, as the “E1” screen
will be displayed after the
“E2” screen, once
operation of the cameras is
stable, the system will
restart. In either case, it
may take some time for the
system to restart.
If the system does not
restart, even after the
conditions have improved
and a period of time has
elapsed, contact your
SUBARU dealer for an
inspection.
S00882
S00861
S00862
EyeSight Disabled
No Camera View