Page 155 of 196

Anti-theft wheel boltsFig. 183
Anti-theft wheel bolt and attach-
ment
The anti-theft wheel bolts protect wheels from being stolen. This can only be
B
.with the attachment » Fig. 183 loosened / tightened .
›
Insert the attachment
B
» Fig. 183 as far as it will go on the anti-theft wheel
bolt
A
.
›
Insert the key as far as it will go onto attachment
B
and loosen / tighten the
wheel bolt.
›
Remove the attachment.
The attachment for the anti-theft wheel bolts must always be kept in the ve-
hicle in case of a possible wheel change.
For wheel trims supplied ex-factory or from ŠKODA Original Accessories, the
anti-theft wheel bolt should be installed in the position marked on the back of
the wheel trim » page 152.
Note
The attachment and the anti-theft wheel bolts are provided with a code num-
ber. A replacement attachment can be ordered from ŠKODA Genuine Accesso-
ries using this.Loosening/tightening wheel boltsFig. 184
Loosening the wheel bolts
›
Insert the wheel wrench onto the wheel bolt to the stop. Use the associated
attachment for the anti-theft wheel bolts » Fig. 183 on page 153 .
›
To loosen the screws ,grasp the key end and turn the screw about one turn
rotation in the direction of the arrow » Fig. 184.
›
Totighten the screws grasp the key end and turn the screw about against
the direction of the arrow » Fig. 184until it is tight.
WARNINGIf it proves difficult to undo the bolts, carefully apply pressure to the end of
the wrench with your foot. Keep hold of the vehicle when doing so, and
make sure you keep your footing - danger of injury.
Raising the vehicle
Fig. 185
Jacking points for the jack
153Emergency equipment, and self-help
Page 156 of 196

Fig. 186
Attach lifting jack
The procedure for lifting the vehicle is valid for all body versions.
Before the vehicle is raised, please take note of the safety instructions »
.
To lift the vehicle, us the jack from the tool kit. Position the car jack at the
jacking point closest to the flat tyre.
The jacking points are located on the lower sill » Fig. 185.
›
Position the base plate of the jack with its full area resting on level ground
and ensure that the jack will fit in the jacking point when raised » Fig. 186 -
.
›
Use the crank to raise the jack until its pawl covers the jacking
point » Fig. 186 -
.
›
Raise the vehicle until the wheel is a little off the floor.
WARNINGThe following instructions must be observed, otherwise there is risk of in-
jury.■
Ensure the vehicle cannot unexpectedly roll away.
■
Always ensure the base plate of the lifting jack cannot slip.
■ Place a wide and stable base material under the jack if on a loose surfa-
ces (e.g. gravel).
■ Place an anti-slip base material (e.g. a rubber mat) under the jack if on a
smooth surface (e.g. cobblestones).
■
Always raise the vehicle with the doors closed.
■
Never position any body parts (e.g. arms or legs) under the vehicle while
the vehicle is raised.
■
When the vehicle is raised, never start the engine.
CAUTIONIt is important to ensure that the jack is correctly positioned against the bar of
the lower beam - otherwise there is a risk of damage to the vehicle.
Breakdown kit
Introduction
This chapter contains information on the following subjects:
Description of the breakdown kit
155
Preparing to use the breakdown kit
155
Sealing and inflating tyres
155
Information on driving with repaired tyres
156
The following information applies for the breakdown kit supplied ex-factory.
The breakdown kit can be used to seal punctures with a diameter of up to
about 4 mm.
A repair made using the breakdown kit is never intended to replace a perma-
nent repair on the tyre. Its purpose is to get you to the nearest specialist ga-
rage.
Replace the tyre that was repaired using the breakdown kit as soon as possi-
ble, or consult a specialist garage about repair options.
Do not remove foreign bodies which have penetrated into the tyre (e.g. nails).
Do not use the breakdown kit in the following cases.
▶ The rim is damaged.
▶ The outside temperature is below -20 ° C.
▶ Tyre punctures greater than 4 mm.
▶ Damage to the tyre wall.
▶ The use-by date (see inflation bottle) has passed.
WARNING■ If there is skin contact with the sealant wash the affected area immedi-
ately.■
Observe the manufacturer's usage instructions for the breakdown kit.
154Do-it-yourself
Page 187 of 196

Force limiterWindow52
Front Assist114
Deactivation/activation116
Distance warning115
Malfunctions116
Operation114
Radar sensor100
Warning and automatic braking115
Warning light36
Front seats62
Fuel135
Diesel136
Fuel gauge28
refer to Fuel135
Refuelling135
Unleaded petrol135
Warning light32
fuel consumption175
Fuel reserve32
Fuses162
in the dash panel163
in the engine compartment164, 165
G
Gearbox Information messages
33
Gear change Gear recommendation
37
Information on the selected gear37
Gear changing Gear stick
95
Genuine parts128
Glasses compartment71
GPS See Owner´s Manual -Infotainment
6
H
handbrake warning light
29
Handbrake94
Hazard warning light system56
HBA102
Headrests64
heater Rear window
58
Heater Recirculated air mode
88
Heating85, 86
Mirrors61
Seats65
Help in an emergency8
HHC102
Hill Start Assist (HHC)102
hitch123
Hitch119
Hooks77
horn26
I
I-PAD holder
73
Ignition lock91
Images See Owner´s Manual -Infotainment
6
Immobilizer90
In an emergency Changing a wheel
151
Inertia reel15
Information about the towing process157
information system Auto Check Control
36
door alarm36
Information system36
Gear recommendation37
MAXI DOT display40
Multifunction display38
Service interval display41
Infotainment6
Instrument cluster27
Warning lights28
interior light57
Interior lighting58
Interior monitor49
ISOFIX23
J
Jack
150
Jacking points Raise vehicle
153
Jump-starting156, 157
K
KESSY Unlocking/locking
46
key Starting / stopping the engine
91
Switch on/off ignition91
Key Change battery
159
Locking45
Unlocking45
L
Lamp failure Warning light
35
Lamps Warning light
35
LEAVING HOME56
lever Turn signal/main beam
54
Lever ACC
111
Cruise control108
Front Assist116
185Index