2016 Ram ProMaster oil type

ENGINE BREAK-IN RECOMMENDATIONS
The diesel engine does not require a break-in period due
to its construction. Normal operation is allowed, provid-
ing the following recommendations are followed:
•Warm up the engine before placing it under load.
• Do not operate the engine at idle for prolonged
periods.
• Use the appropriate transmission gear to prevent
engine lugging.
• Observe vehicle oil pressure and temperature indica-
tors.
• Check the coolant and oil levels frequently.
• Vary accelerator pedal position at highway speeds
when carrying or towing significant weight. NOTE:
Light duty operation such as light trailer towing
or no load operation will extend the time before the
engine is at full efficiency. Reduced fuel economy and
power may be seen at this time.
The engine oil installed in the engine at the factory is a
high-quality energy conserving type lubricant. Oil
changes should be consistent with anticipated climate
conditions under which vehicle operations will occur.
The recommended viscosity and quality grades are
shown under “Fluids, Lubricants and Genuine Parts”,
under “Maintaining Your Vehicle” in this manual. NON-
DETERGENT OR STRAIGHT MINERAL OILS MUST
NEVER BE USED.
8 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

6. Check that the oil pressure warning light has turnedoff.
7. Release the parking brake.
To start the engine if the transmission is faulty, the
“Delayed startup” procedure may be required.
NOTE: Not all Transmission Failures requires the “De-
layed startup” Procedure, it depends on the type of
failure.
(refer to Instrument Cluster Messages underAuto-
mated Manual Transmission in this section for further
information):
• Begin with the key in the OFF position.
• Press and hold the brake pedal. •
Turn the key to the START/AVV position and hold it
there for at least seven seconds with the brake de-
pressed. The engine will start, and the transmission
will operate in recovery mode (maximum gear permit-
ted = 3rd, automatic mode not available). If the engine
does not start, contact your authorized dealer.
Starting Fluids
The engine is equipped with a glow plug preheating
system. If the instructions in this manual are followed,
the engine should start in all conditions and no type of
starting fluid should be used.
WARNING!
• Do not leave children or animals inside parked
vehicles in hot weather. Interior heat build up may
cause serious injury or death.
(Continued)
5
STARTING AND OPERATING 55

Engine Oil
Engine Oil Selection
For best performance and maximum protection under all
types of operating conditions, the manufacturer recom-
mends engine oils that meet the requirements of FCA US
Material Standard MS-11106, and that are approved to
ACEA C3.
Checking Oil Level
To assure proper lubrication of your vehicle’s engine, the
engine oil must be maintained at the correct level. Check
the oil level at regular intervals. The best time to check
the oil level is before starting the engine after it has been
parked overnight. When checking oil after operating the
engine, first ensure the engine is at full operating tem-
perature, then wait for 30 minutes after engine shutdown
to check the oil.Checking the oil while the vehicle is on level ground will
improve the accuracy of the oil level readings. Add oil
Engine Oil Dipstick
1 — Maximum Notch
2 — Minimum Notch
104 MAINTAINING YOUR VEHICLE

Adding Engine Coolant (Antifreeze)............113
Adding Fuel ..............................82
Air Bag Light .............................19
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . .106
Antifreeze (Engine Coolant) ...............112,119
Disposal ..............................115
Anti-Lock Warning Light .....................40
Automated Manual Transmission Fluid Type ........................... .123
Battery ............................. .20, 110
Charging System Light ....................20
Brake Fluid ............................ .123
Brake System ............................117
Fluid Check ...........................117
Master Cylinder ........................117
Warning Light ..........................26
Capacities, Fluid ..........................119 Caps, Filler
Oil (Engine) .......................... .105
Radiator (Coolant Pressure) ................115
Coolant Pressure Cap (Radiator Cap) ...........115
Cooling System ...........................111
Adding Coolant (Antifreeze) ...............113
Coolant Capacity .......................119
Coolant Level ..........................111
Disposal Of Used Coolant .................115
Drain, Flush, And Refill ...................112
Points To Remember .....................116
Pressure Cap ..........................115
Radiator Cap ..........................115
Selection Of Coolant (Antifreeze) ......112,119,120
Cruise Light .......................... .46, 47
Diesel Exhaust Fluid (DEF) ..................120
Diesel Fuel .......................... .76, 120
Diesel Fuel Requirements .................76, 120
136 INDEX