2016 Ram ProMaster coolant level

ENGINE BREAK-IN RECOMMENDATIONS
The diesel engine does not require a break-in period due
to its construction. Normal operation is allowed, provid-
ing the following recommendations are followed:
•Warm up the engine before placing it under load.
• Do not operate the engine at idle for prolonged
periods.
• Use the appropriate transmission gear to prevent
engine lugging.
• Observe vehicle oil pressure and temperature indica-
tors.
• Check the coolant and oil levels frequently.
• Vary accelerator pedal position at highway speeds
when carrying or towing significant weight. NOTE:
Light duty operation such as light trailer towing
or no load operation will extend the time before the
engine is at full efficiency. Reduced fuel economy and
power may be seen at this time.
The engine oil installed in the engine at the factory is a
high-quality energy conserving type lubricant. Oil
changes should be consistent with anticipated climate
conditions under which vehicle operations will occur.
The recommended viscosity and quality grades are
shown under “Fluids, Lubricants and Genuine Parts”,
under “Maintaining Your Vehicle” in this manual. NON-
DETERGENT OR STRAIGHT MINERAL OILS MUST
NEVER BE USED.
8 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

WARNING!
A hot engine cooling system is dangerous. You or
others could be badly burned by steam or boiling
coolant. You may want to call an authorized dealer
for service if your vehicle overheats. If you decide to
look under the hood yourself, see “Maintaining Your
Vehicle”. Follow the warnings under the Cooling
System Pressure Cap paragraph.
5. Fuel Gauge •The pointer shows the level of fuel in the fuel tank
when the ignition switch is in the ON/RUN position
The fuel pump symbol points to the side of the
vehicle where the fuel door is located.
WARNING AND INDICATOR LIGHTS
IMPORTANT: The warning light switches on in the
instrument panel together with a dedicated message
and/or acoustic signal when applicable. These indica-
tions are indicative and precautionary and as such must
not be considered as exhaustive and/or alternative to the
information contained in the Owner Manual, which you
are advised to read carefully in all cases. Always refer to
the information in this chapter in the event of a failure
indication.
4
UNDERSTANDING YOUR INSTRUMENT PANEL 17

Please review these recommendations for using Organic
Additive Technology (OAT) engine coolant (antifreeze)
that meets the requirements of FCA Material Standard
MS.90032. When adding engine coolant (antifreeze):
•We recommend using MOPAR Antifreeze/Coolant 10
Year/150,000 Mile Formula OAT (Organic Additive
Technology) that meets the requirements of FCA Ma-
terial Standard MS.90032.
• Mix a minimum solution of 50% OAT engine coolant
that meets the requirements of FCA Material Standard
MS.90032 and distilled water. Use higher concentra-
tions (not to exceed 70%) if temperatures below 34°F
(37°C) are anticipated.
• Use only high purity water such as distilled or deion-
ized water when mixing the water/engine coolant
(antifreeze) solution. The use of lower quality water
will reduce the amount of corrosion protection in the
engine cooling system. Please note that it is the owner’s responsibility to main-
tain the proper level of protection against freezing ac-
cording to the temperatures occurring in the area where
the vehicle is operated.
NOTE:
•
Some vehicles require special tools to add coolant
properly. Failure to fill these systems properly could
lead to severe internal engine damage. If any coolant is
needed to be added to the system, please contact your
local authorized dealer.
• Mixing engine coolant (antifreeze) types is not recom-
mended and can result in cooling system damage. If
HOAT and OAT coolant are mixed in an emergency,
have a authorized dealer drain, flush, and refill with
OAT coolant (conforming to MS.90032) as soon as
possible.
114 MAINTAINING YOUR VEHICLE

FLUID CAPACITIES
U.S.Metric
Fuel (Approximate)
3.0L Diesel Engine 24 Gallons90 Liters
Diesel Exhaust Fluid Tank 5 Gallons18.9 Liters
Engine Oil with Filter
3.0L Diesel Engine 9.5 Quarts9.0 Liters
Cooling System *
3.0L Diesel Engine With MTA
Transmission (MOPAR Antifreeze/
Engine Coolant 10 Year/150,000
Mile Formula or equivalent) 12.7 Quarts
12 Liters
* Includes heater and coolant recovery bottle filled to MAX level. Add 2.9 Qts (2.8 L) if equipped with a rear
heater.
6
MAINTAINING YOUR VEHICLE 119

MAINTENANCE SCHEDULE — DIESEL ENGINE
Your vehicle is equipped with an automatic oil change
indicator system. The oil change indicator system will
remind you that it is time to take your vehicle in for
scheduled maintenance.
Based on engine operation conditions, the oil change
indicator message will illuminate in the instrument clus-
ter. This means that service is required for your vehicle.
Operating conditions such as frequent short-trips, trailer
tow, and extremely hot or cold ambient temperatures will
influence when the “Oil Change Required” message is
displayed. Severe Operating Conditions can cause the
change oil message to illuminate as early as 3,500 miles
(5,600 km) since last reset. Have your vehicle serviced as
soon as possible, within the next 500 miles (805 km).
Your authorized dealer will reset the oil change indicator
message after completing the scheduled oil change. If a
scheduled oil change is performed by someone otherthan your authorized dealer, the message can be reset by
referring to the steps described under “Electronic Vehicle
Information Center (EVIC)” in “Understanding Your
Instrument Panel” for further information.
NOTE:
Under no circumstances should oil change inter-
vals exceed 18,500 miles (29,773 km) or twelve months,
whichever comes first.
Once A Month Or Before A Long Trip:
• Check engine oil level
• Check windshield washer fluid level
• Check the tire inflation pressures and look for unusual
wear or damage
• Check the fluid levels of the coolant reservoir, brake
master cylinder, and power steering and fill as needed
• Check function of all interior and exterior lights
126 MAINTENANCE SCHEDULE

Adding Engine Coolant (Antifreeze)............113
Adding Fuel ..............................82
Air Bag Light .............................19
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . .106
Antifreeze (Engine Coolant) ...............112,119
Disposal ..............................115
Anti-Lock Warning Light .....................40
Automated Manual Transmission Fluid Type ........................... .123
Battery ............................. .20, 110
Charging System Light ....................20
Brake Fluid ............................ .123
Brake System ............................117
Fluid Check ...........................117
Master Cylinder ........................117
Warning Light ..........................26
Capacities, Fluid ..........................119 Caps, Filler
Oil (Engine) .......................... .105
Radiator (Coolant Pressure) ................115
Coolant Pressure Cap (Radiator Cap) ...........115
Cooling System ...........................111
Adding Coolant (Antifreeze) ...............113
Coolant Capacity .......................119
Coolant Level ..........................111
Disposal Of Used Coolant .................115
Drain, Flush, And Refill ...................112
Points To Remember .....................116
Pressure Cap ..........................115
Radiator Cap ..........................115
Selection Of Coolant (Antifreeze) ......112,119,120
Cruise Light .......................... .46, 47
Diesel Exhaust Fluid (DEF) ..................120
Diesel Fuel .......................... .76, 120
Diesel Fuel Requirements .................76, 120
136 INDEX

Bulk Storage Of.........................83
Diesel Fuel System, Re-Priming ...............108
Disposal Antifreeze (Engine Coolant) ................115
Door Ajar ...............................20
Door Ajar Light ...........................20
Draining Fuel/Water Separator Filter ...........107
Electronic Speed Control (Cruise Control) .........11
Electronic Throttle Control Warning Light .........21
Electronic Vehicle Information Center (EVIC) ......48
Engine ................................ .102
Air Cleaner .......................... .106
Block Heater ...........................61
Break-In Recommendations ..................8
Compartment ......................... .102
Coolant (Antifreeze) .....................120
Fuel Requirements ......................119
Identification ......................... .102Idling
................................59
Oil .......................... .104, 119, 120
Oil Filler Cap ......................... .105
Oil Selection ...........................119
Filters Air Cleaner .......................... .106
Engine Fuel .......................... .107
Engine Oil ........................ .106, 120
Engine Oil Disposal .....................106
Flashers Turn Signal ............................44
Fluid Capacities ..........................119
Fluid Level Checks Brake ................................117
Fluids, Lubricants And Genuine Parts ...........120
Fuel ................................ .76, 82
Adding ...............................82
Diesel ......................... .76, 82, 120
8
INDEX 137