2016 Peugeot 308 Ond II

17
308_en_Chap01_instruments-de-bord_ed02-2015
Deactivation indicator lamps
If one of the following indicator lamps comes on, this confirms that the corresponding system has been switched off intentionally.this is may be accompanied by an audible signal and the display of a message.
Warning
/

indicator lamp State Cause Action
/

Observations
Passenger's
front airbag fixed in the seat belt
and front passenger's
airbag warning lamps
display.
the c

ontrol switch, located on the
passenger's end of the dashboard, is
set to the "OFF" position.
the p

assenger's front airbag is
deactivated.
You can install a rear ward facing
child seat, unless there is a fault with
the airbags (airbag warning lamp on).
to ac

tivate the front passenger's airbag, set the switch
to the "ON" position; in this case, you must not install
a child seat in the rear ward facing position on this
seat.
Dynamic
stability control
(DSC/ASR) fixed.
the b

utton is pressed and the
indicator lamp comes on.
the DS

C/ASR is deactivated.
DSC: dynamic stability control.
ASR: anti-slip regulation. Press the button to activate the DSC/ASR. Its
indicator lamp goes off.
the D

SC/ASR system is activated automatically when
the vehicle is started.
If deactivated, the system is reactivated automatically
from around 30 mph (50 km/h).
For more information on the
eS

C system (DSC/ASR),
refer to the corresponding section.
1
Instruments

19
308_en_Chap01_instruments-de-bord_ed02-2015
Warning / indicator lampStateCause Action / Observations
Service on temporarily. A minor fault has occurred for which
there is no specific warning lamp. Identify the fault by means of the associated
message, such as:
-
lo

w engine oil level,
-
lo

w screenwash/headlamp wash fluid level,
-
di

scharged remote control battery,
-
lo

w tyre pressures,
-
sa

turation of the particle filter (FAP) on Diesel
vehicles.
For more information on checking the particle filter,
refer to the corresponding section.
For any other faults, contact a P
eu

ge
Ot d
ealer or a
qualified workshop.
fixed. A major fault has occurred for which
there is no specific warning lamp. Identify the fault by reading the message and contact
a P
eu

ge
Ot d
ealer or a qualified workshop.
fixed, associated with
flashing and then fixed
display of the service
spanner.
the ser

vicing interval has been
exceeded. Only on BlueHDi Diesel versions.
Your vehicle must be serviced as soon as possible.
1
Instruments

20
Warning / indicator lampStateCause Action / Observations
Electric parking
brake flashing.
the e

lectric parking brake is not
applied automatically.
the

application/release is faulty.You must stop as soon as it is safe to do so.
Park on flat level ground, engage a gear (or place the
lever in position P for an automatic gearbox), switch
off the ignition and contact a P
eu

ge
Ot d
ealer or a
qualified workshop.
Electric parking
brake fault fixed.
the e

lectric parking brake has a fault. Contact a P
eu
ge
Ot d
ealer or a qualified workshop
without delay.
For more information on the electric parking brake,
refer to the corresponding section.
Deactivation of
the automatic
functions of the
electric parking
brake fixed.
the

"automatic application"
(on switching off the engine) and
"automatic release" functions are
deactivated or faulty.
In the event of a fault, illumination of
this warning lamp is accompanied by
a message.
to re

activate the automatic functions, refer to the
"
elec

tric parking brake" section.
Contact a P
eu

ge
Ot d
ealer or a qualified workshop if
automatic application
/

release is not possible.
the

parking brake can be released manually.
For more information on the electric parking brake,
refer to the corresponding section.
Instruments

23
308_en_Chap01_instruments-de-bord_ed02-2015
Warning / indicator lampStateCause Action / Observations
Battery charge *fixed.
the

battery charging circuit has a
fault (dirty or loose terminals, slack or
cut alternator belt, ...).
the w

arning lamp should go off when the engine is
started.
If it does not go off, contact a P
eu

ge
Ot d
ealer or a
qualified workshop.
*
D

epending on the country of sale. Seat belt(s)
not fastened
/
un

fastened fixed
or flashing
accompanied by an
audible signal. A seat belt has not been fastened or
has been unfastened.
Pull the strap then insert the tongue in the buckle.
Airbags on temporarily.
thi

s lamp comes on for a few
seconds when you turn on the
ignition, then goes off.
thi

s lamp should go off when the engine is started.
If it does not go off, contact a P
eu

ge
Ot d
ealer or a
qualified workshop.
fixed. One of the airbag or seat belt
pretensioner systems has a fault. Have it checked by a P
eu

ge
Ot d
ealer or a qualified
workshop.
1
Instruments

24
Engine oil
pressurefixed.the
re is a fault with the engine
lubrication system. You must stop as soon it is safe to do so.
Park, switch off the ignition and contact a Peu
geOt
d
ealer or a qualified workshop.
Deflated tyre fixed.
the p

ressure in one or more tyres is
too low. Check the pressures of the tyres as soon as possible.
thi

s check should preferably carried out with the tyres
cold.
flashing then fixed.
the u

nder-inflation detection system
has a fault. Have it checked by a P
eu

ge
Ot d
ealer or a qualified
workshop.
For more information on under-inflation detection,
refer to the corresponding section.
Warning
/

indicator lamp
State Cause Action
/
Observations
Foot on the
brake pedal fixed.
the b

rake pedal must be pressed. With an automatic gearbox, press the brake pedal, engine running, before releasing the parking brake, to
unlock the lever and come out of position P .
If you wish to release the parking brake without
pressing the brake pedal, this warning lamp will
remain on.
Foot on the
clutch fixed.
In the S
tOP m

ode of Stop & Start,
changing to S
tARt m

ode is refused
because the clutch pedal is not fully
down. You must declutch fully to allow the change to engine
S
tA

R
t m o
d e .
Instruments

26
AdBlue® additive
(BlueHDi Diesel) fixed, on switching
on the ignition,
accompanied by an
audible signal and a
message indicating the
remaining driving range.the r
emaining driving range is
between 350 miles (600 km) and
1500 miles (2400 km). Have the AdBlue® additive tank topped up as soon
as possible: go to a Peu geOt d ealer or a qualified
workshop, or carry out this operation yourself.
+ flashing associated with
the S
eRV

IC
e wa

rning
lamp, accompanied by
an audible signal and a
message indicating the
remaining driving range.
the r

emaining driving range is
between 0 and 350 miles (600 km). You must top-up the AdBlue
® additive tank to avoid
a breakdown : go to a Peu
geOt d ealer or a qualified
workshop, or carry out this operation yourself.
flashing, associated
with the S
eRV

IC
e
war

ning lamp,
accompanied by an
audible signal and a
message indicating that
starting is prevented.
the

AdBlue
® tank is empty: the
starting inhibition system required
by legislation prevents starting of the
engine.to be a ble to start the engine, you must top-up the
AdBlue® additive tank: go to a Peu geOt d ealer
or a qualified workshop, or carry out this operation
yourself.
It is essential to add at least 3.8 litres of AdBlue
® to
the additive tank.
Warning or indicator lamp
in the instrument panel
State
Cause Action
/

Observations
For topping-up or for more information on the AdBlue
® additive, refer to the corresponding section.
Instruments

29
308_en_Chap01_instruments-de-bord_ed02-2015
Between 600 miles (1 000 km)
and 1 800 miles (3 000 km) remain
before the next service is due
For 5 seconds after the ignition is switched on, the
spanner symbolising the service operations comes
on.
the d
istance recorder display line indicates the
distance remaining before the next service is due.
Example: 1 700 miles (2 800 km) remain before
the next service is due.
For 5 seconds after the ignition is switched on, the
screen indicates:
5 seconds after the ignition is switched on,
the spanner goes off ; the distance recorder
resumes its normal operation.
the s

creen then
indicates the total distance.
Service overdue
5 seconds after the ignition is switched on,
the distance recorder resumes its normal
operation. The spanner remains on .
For 5 seconds after the ignition is switched on,
the spanner flashes
to indicate that the service
must be carried out as soon as possible.
Example: the service is overdue by 180 miles
(3 0 0 k m).
For 5 seconds after the ignition is switched on,
the screen indicates:
Less than 600 miles (1 000 km)
remain before the next service is due
Example: 560 miles (900 km) remain before
the next service is due.
For 5 seconds after the ignition is switched on,
the screen indicates:
5 seconds after the ignition is switched on,
the distance recorder resumes its normal
operation. The spanner remains on to
indicate that a service must be carried out
soon.
For BlueHDi Diesel versions, this alert may
also be accompanied by the fixed illumination
of the service warning lamp when the ignition
is on.
1
Instruments

30
the distance remaining may be
w eighted by the time factor, depending
on the driving conditions.
the

refore, the spanner may also come
on if you have exceeded the period
since the last service, indicated in the
manufacturer's service schedule.
For BlueHDi Diesel versions, the
spanner may also be brought on earlier
than expected, depending on the
degree of deterioration of the engine oil
(depending on the country of sale).
the r

ate of deterioration of the engine
oil depends on the driving conditions in
which the vehicle is used.
Service indicator zero reset
Following this operation, if you wish to
disconnect the battery, lock the vehicle
and wait at least five minutes for the
zero reset to be registered.
Retrieving the service
information
You can access the service information at any
time.
F
Pr

ess the trip distance recorder zero reset
button.
the s

ervice information is displayed for a
few seconds, then disappears.
After each service, the service indicator must
be reset to zero.
If you have carried out the service on your
vehicle yourself:
F
swi

tch off the ignition,
F
pr

ess and hold the trip distance recorder
zero reset button,
F
sw

itch on the ignition; the distance recorder
display begins a countdown,
F
when

the display indicates "=0" , release
the button; the spanner disappears.
Instruments