2016 LEXUS LS460L parking brake

593
7When trouble arises
LS460/LS460L_GE (OM50G06E)
7-1. Essential information
Emergency flashers .................. 594
If your vehicle has to be
stopped in an
emergency.................................595
7-2. Steps to take in an
emergency
If your vehicle needs to
be towed..................................... 596
If you think something is
wrong...........................................603
Fuel pump shut off system ......604
If a warning light turns on
or a warning
buzzer sounds ..........................605
If a warning message is
displayed ......................................614
If you have a flat tire ................... 618
If the engine will not start ........ 627
If the parking brake
cannot be released................. 629
If the electronic key does
not operate properly .............. 631
If the vehicle battery is
discharged ................................. 636
If your vehicle overheats ...........641
If the vehicle becomes
stuck ............................................. 645

5997-2. Steps to take in an emergency
7
When trouble arises
LS460/LS460L_GE (OM50G06E)
Take out the towing eyelet. (P. 619)
Remove the eyelet cover using a
flathead screwdriver.
To protect the bodywork, place a rag
between the screwdriver and the vehi-
cle body as shown in the illustration.
Insert the towing eyelet into the
hole and tighten partially by hand.
Tighten down the towing eyelet
securely using a wheel nut
wrench or hard metal bar.
Securely attach cables or chains to the towing eyelet.
Take care not to damage the vehicle body.
Enter the vehicle being towed and start the engine.
If the engine does not start, turn the engine switch to IGNITION ON mode.
Shift the shift lever to N and release the parking brake.
When the shift lever cannot be shifted: P. 267, 275
Emergency towing procedure
1
2
3
4
5
6
7

6077-2. Steps to take in an emergency
7
When trouble arises
LS460/LS460L_GE (OM50G06E)
(Flashes)
(If equipped)
Pre-crash safety system warning light
Indicates a malfunction in the pre-crash safety system
The warning light will operate as follows, even when the system
is not malfunctioning:
• The light will flash quickly when the system is operating.
( P. 368)
• The light will turn on when the pre-crash braking is disabled.
( P. 363, 370)
• The light will turn on when the system cannot temporarily be
used.
Slip indicator
Indicates a malfunction in:
•The VSC system;
•The TRC system;
•The ABS; or
• The hill-start assist control system
The light will flash when the VS C, the TRC, the ABS or the hill-
start assist control system is operating. ( P. 362)
(Flashes)
Brake hold operated indicator
Indicates a malfunction in the brake hold system
(Flashes)
Parking brake indicator
Indicates a malfunction in the electric parking brake
Brake system warning light
Indicates a malfunction in:
• The electronically controlled brake system; or
• The electric parking brake
Warning lightWarning light/Details

6167-2. Steps to take in an emergency
LS460/LS460L_GE (OM50G06E)
■Warning message in radar cruise mode (if equipped)
In the following cases, the warning message may not be displayed even if vehicle-to-
vehicle distance decreases:
●When your vehicle and the vehicle ahead are traveling at the same speed or the
vehicle ahead is traveling more quickly than your vehicle
●When the vehicle ahead is traveling at a very low speed
●Immediately after cruise control speed is set
●At the instant the accelerator pedal is depressed
■The LKA (Lane-Keeping Assist) lane de parture warning function (if equipped)
In the following cases, the warning message will not be displayed even if a lane line is
crossed.
●When the vehicle speed deviates from the operating range of the LKA system
functions
●When the lane lines cannot be recognized
●When the steering wheel is turned as far as necessary to cause the vehicle to
change lanes
■System warning lights
The master warning light does not come on or flash in the following cases. Instead, a
separate system warning light will come on or flash along with the message shown
on the multi-information display.
●Malfunction of the brake system
The brake system warning light (red indicator) comes on. ( P. 605)
●Malfunction of the electronically controlled brake system or electric parking brake
The brake system warning light (yellow indicator) comes on. ( P. 607)
●Malfunction of the ABS
The ABS warning light comes on. ( P. 606)
●Malfunction of the charging system
The charging system warning light comes on. ( P. 606)
●Indicates that a door or the trunk is not fully closed
The open door warning light comes on. ( P. 608)
●High engine coolant temperature
The needle of the engine coolant temperature gauge enters the red zone.
( P. 641)

6187-2. Steps to take in an emergency
LS460/LS460L_GE (OM50G06E)
●Stop the vehicle in a safe place on a hard, flat surface.
●Set the parking brake.
●Shift the shift lever to P.
●Stop the engine.
●Turn on the emergency flashers. ( P. 594)
If you have a flat tire
Your vehicle is equipped with a spare tire. The flat tire can be replaced
with the spare tire.
For details about tires: P. 556
CAUTION
■If you have a flat tire
Do not continue driving with a flat tire.
Driving even a short distance with a flat tire can damage the tire and the wheel
beyond repair, which could result in an accident.
Before jacking up the vehicle

6197-2. Steps to take in an emergency
7
When trouble arises
LS460/LS460L_GE (OM50G06E)
Location of the spare tire, jack and tools
Parking brake release tool
Jack handle
Wheel nut wrench
Jack
Tools
Screwdriver
Spare tire
Towing eyelet
1
2
3
4
5
6
7
8

6287-2. Steps to take in an emergency
LS460/LS460L_GE (OM50G06E)
One of the following may be the cause of the problem:
●One or both of the battery terminals may be disconnected.
●The battery may be discharged. (P. 636)
●There may be a malfunction in the steering lock system.
Contact your Lexus dealer if the problem cannot be repaired, or if repair proce-
dures are unknown.
When the engine does not start, the following steps can be used as an
interim measure to start the engine if the engine switch is functioning nor-
mally:
Turn the engine switch to IGNITION ON mode ( P. 260) and check
that the parking brake is set.
Shift the shift lever to P.
Turn the engine switch to ACCESSORY mode.
Press and hold the engine switch for about 15 seconds while depress-
ing the brake pedal firmly.
Even if the engine can be started using the above steps, the system may be
malfunctioning. Have the vehicle inspected by your Lexus dealer.
The starter motor does not turn over, the interior lights and head-
lights do not turn on, or the horn does not sound.
Emergency start function
1
2
3
4

6297-2. Steps to take in an emergency
7
When trouble arises
LS460/LS460L_GE (OM50G06E)
●Shift the shift lever to P.
●Turn the engine switch off.
●Check that the parking brake indicator is off.
●Chock the tires.
Take out the parking brake release tool and the screwdriver from the
trunk. ( P. 619)
Replace the screwdriver head
with the parking brake release
tool.
Take out the spare tire. ( P. 622)
If the parking brake cannot be released
In the event that the battery is discharged or switch operation does not
release the parking brake, the parking brake can be released manually
using the procedure below. This pro cedure should be performed only if
necessary, such as in an emergency.
If the switch cannot be operated even when the battery is normal, the
parking brake system may be malfunctioning. Have the vehicle
inspected by your Lexus dealer immediately.
Before releasing the parking brake manually
Releasing the parking brake manually
1
2
3