2016 KIA CADENZA Features and Functions Guide

7
User Settings
To enter the User Settings
mode in the LCD Instrument
Cluster Modes, press the
Mode/Select button
A when
the vehicle is at a standstill
and with the ENGINE START/
STOP button in the ON
position and select User
Settings

You can navigate the selections on the display by pressing the
Move/Reset button
B, and then selecting the item by pressing
the Mode/Select button A
Door:
• Auto Door Lock
& Unlock
• Two Press Unlock
• Lock /Unlock Sound
• Horn Feedback

Lamp:
• One-Touch Turn
Lamp
• Headlamp Delay
• Welcome Light* Settings:
•
Temperature Unit
• Speed Unit ( Type B Cluster)*
• Speedometer Size ( Type
B Cluster)*
• AVG Fuel Economy Reset
• Easy Seat Access*
• Easy Steering Access*
• Welcome Sound
• Steering Position

Service Interval:
• ON/OFF
• Set mileage/months
Service Mode
To enter Service Mode, press the Mode/Select
button A, scroll to Service Mode by pressing Move/
Reset button B Then press the Mode/Select button A to
enter System will display number of miles remaining until
next service is due, and type of service
When service is required, the following will be displayed:
Service Required
To reset the Service Mode system, press and hold the
Move/Reset button
B for more than 1 second
To turn Service In OFF, go to User Settings
Service Interval Setting
To set the service interval when in
User Settings mode:
• Press the Move/Reset button
B and scroll to Service
Interval Press the Mode/Select
button
A to enter
• Press the Move/Reset button
B and toggle to ON, then
press the Move/Select button
A Then press the Move/Reset
button B to scroll and select
the desired miles or months for
your next service
• Press the Mode/Select button
A to enter


To view these videos on
your mobile device, snap
these QR Codes or visit the
listed websites
Refer to page 2 for more
information
LCD Display Video


LCD Display:
Maintenance VideoQR CODES
www. KuTechVideo s.c om/vg13/2016
www. KuTechVideo s.c om/vg13/2016ODO 123 456 miHold : Reset
Service in
or 15000 mi.
90 days
ODO 123 456 mi
Service in
OFF
ODO 123 456 miHold : Reset
Service required
or 0 mi.
0 days
ODO 123 456 miHold : Reset
Service in
or 15000 mi.
90 days
ODO 123 456 mi
Service in
OFF
ODO 123 456 miHold : Reset
Service required
or 0 mi.
0 days
ODO 123 456 miHold : Reset
Service in
or 15000 mi.
90 days
ODO 123 456 mi
Service in
OFF
ODO 123 456 miHold : Reset
Service required
or 0 mi.
0 days
(Type B cluster)
(Buttons located on right side of
steering wheel)
A
B
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS. *IF EQUIPPED
INSTRUMENT CLUSTER

8
Electronic Stability Control (ESC)
The ESC system is designed to help stabilize the vehicle during cornering
maneuvers It is a good idea to keep the ESC turned on for daily driving
whenever possible
Press ESC button
A to turn Traction Control OFF/ON
To turn OFF both the Traction Control and Stability Control, press and hold for
more than 3 seconds Press again to turn ON
(Button panel located left of Steering Wheel)
Hill-Start Assist Control (HAC)
HAC helps prevent the vehicle from rolling backwards when accelerating
from a stop while on a steep incline The HAC automatically activates
whether the ESC is OFF or ON but does NOT activate when the ESC
has malfunctioned
REMINDER: The HAC does not operate when the gear shift is in the P (Park) or the N
(Neutral) position

REMINDERS:

•ESC is active by default at vehicle start-up When ignition is cycled, ESC will turn ON again

• The ESC Indicator Light in the instrument cluster will illuminate whenever the ESC is
in operation
For more information on Electronic Stability Control (ESC) and its specific features and
operations, please refer to your Owner’s Manual.


When HAC is active (e g , during initial acceleration from a stop on an incline),
you may notice that the brakes will momentarily remain engaged after you
depress the accelerator QUICK TIP
A
CADENZA FEATURES & FUNCTIONS GUIDE
*IF EQUIPPED
DRIVER'S PANEL

9
Blind Spot Detection (BSD) System*
The BSD System uses radar sensors to help alert the driver before changing
lanes The BSD System is ON when the button A is pressed – the button light
will illuminate The outside rearview mirror warning lights will also illuminate for
3 seconds
The system will become active when the vehicle is traveling more than 9 mph
and will alert the driver if another vehicle is detected by the radar sensor
Blind Spot Detection / Lane Change Assist
1st-stage alert: When another vehicle is detected within the BSD System
boundary
B, a yellow indicator will illuminate on the outside rearview mirrors
2nd-stage alert: When 1st-stage alert is on and the driver activates a turn
signal, a flashing yellow indicator will illuminate on the outside rearview mirrors
and the system will sound an alert
RCTA (Rear Cross Traffic Alert)
If the RCTA system sensors detect approaching vehicles from the left or right
side
C, the system will sound an audible alert, the warning indicators on the
outside rearview mirror will illuminate and a message will appear on the LCD
screen, when these conditions are met:
• When the gear shift is in Reverse
• When the vehicles moves in reverse
• When the vehicle is moving less than 6 mph
REMINDERS:

• When the BSD System is ON and the ignition is cycled to OFF then ON again, the BSD System
returns to ON

•The RCTA feature can be turned OFF/ON in User Settings and will remain in OFF/ON as selected
For more information on the Blind Spot Detection System, please refer to the Owner’s Manual.


Blind Spot Detection
System w/RCTA Video

To view a video on your
mobile device, snap this
QR Code or visit the listed
website
Refer to page 2 for more
information QR CODE
www. KuTechVideo s.c om/vg13/2016
A
B
C
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS. *IF EQUIPPED
DRIVER'S PANEL

10


Lane Departure
Warning Video

To view a video on your
mobile device, snap this
QR Code or visit the listed
website
Refer to page 2 for more
information QR CODE
www. KuTechVideo s.c om/vg13/2016
Lane Departure Warning System (LDWS)*
With the ENGINE START/STOP button in the ON position, press
the LDWS button C to turn system ON The instrument cluster
indicator
will illuminate green LDWS will stay on when the
ignition is cycled
If the LDWS detects that you are veering outside of your lane,
the system may issue a warning on the LCD screen and an alert
may sound, under these conditions:
• The vehicle exceeds approximately 43 mph

• The LDWS system recognizes the lane the vehicle is
traveling in
REMINDER: LDWS will not issue a warning if the turn signal is activated
The Lane Departure Warning System (LDWS) is not a substitute for safe and
proper driving. Always drive safely and use caution. LDWS may not always alert
the driver if the vehicle is driven outside of it’s lane.
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
Instrument Panel Dimmer
With parking lights/headlights ON, press button D (+) or (-)
to adjust the brightness of the instrument panel illumination

REMINDER: The Instrument Panel Dimmer does not adjust brightness on the
Navigation System screen, use Navigation setup to adjust brightness on the
Navigation System
(Button panel located left of Steering Wheel)
D
C
When the LDWS sensor detects
the lane traveling inWhen the LDWS sensor does not
detect the lane traveling in
When the LDWS sensor detects the vehicle veering outside of the lane traveling
in, a yellow indicator will illuminate
CADENZA FEATURES & FUNCTIONS GUIDE
*IF EQUIPPED
DRIVER'S PANEL

11
Power Windows, Window Lock & Central Door Lock
A Pull/Press to operate Driver’s Window Auto Up/Down*
B Press to Unlock /Lock All Doors
C Press to disable Rear Passenger Windows
Power Folding Outside Mirrors*
Toggle middle switch D left or right to select mirror Then press arrows to
adjust Power Folding Outside Mirror position
Toggle button
E left /right to unfold/fold the outside rearview mirrors
Toggle button
E to center to automatically fold/unfold mirrors when:
• The Smart Key Lock /Unlock buttons are pressed
• The door outside handle button is pressed
REMINDERS:

• To automatically fold mirrors when exiting vehicle, press the LOCK button twice on the Smart Key

•To lock position of mirrors, toggle switch to the neutral (center) position
Heated Outside Mirrors
Mirror heaters are controlled with Rear Defroster
Automatic Door Lock/Unlock
Auto Door Lock /Unlock will engage when the gear shift is moved in to or
out of the P (Park) position Refer to the User Settings on how to turn Auto
Door Lock/Unlock ON/OFF
(Buttons panel located on Driver's Door )


The mirrors will automatically unfold when the Smart Key* is within close proximity
to the vehicle QUICK TIP
A
BC
D
E
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS. *IF EQUIPPED
DRIVER'S PANEL

12
Fuel Door and Trunk Release Buttons
Press the C button to release the fuel door
Press the
D button to open the trunk
Reverse Parking Aid Function*
When the gear shift lever is moved into R (Reverse) and while the vehicle is
moving backwards, the outside rearview mirrors A will rotate downward to
aid in reverse parking
To turn ON the Reverse Parking Aid Function, the outside mirror switch
B
needs to be in the left or right position
To turn OFF, place outside mirror switch in the center position.
The outside rearview mirrors will automatically return to their original
positions when:
• The ENGINE START/STOP Button is in the OFF position
• The gear shift lever is moved to any position except R (Reverse)
• Outside rearview mirror switch is in the middle position
REMINDER: When the outside rearview mirror switch B is in the middle position, the Reverse
Parking Aid Function will not operate and the outside rearview mirrors will not rotate downward
(Buttons panel located on Driver's Door ) (Buttons located left of Steering Wheel)
A
B
CD
CADENZA FEATURES & FUNCTIONS GUIDE
*IF EQUIPPED
DRIVER'S PANEL

13
Engine Start/Stop Button
To start the engine:
1 Depress the brake pedal
2 Press the ENGINE START/STOP button while in Park or Neutral

To turn the engine OFF, press the ENGINE START/STOP button
To use the ENGINE START/STOP button, you must have the Smart Key fob on
your person
REMINDERS:

• In an emergency situation while the vehicle is in motion, you are able to turn the engine off and to
the ACC position by pressing the ENGINE START/STOP button for more than 2 seconds or 3 times
successively within 3 seconds

• If Smart Key fob battery is dead, with the lock button facing the ENGINE START/STOP button, hold
the fob up against the ENGINE START/STOP button and press


Engine Start/Stop Button
& Smart Key Video

To view a video on your
mobile device, snap this
QR Code or visit the listed
website
Refer to page 2 for more
information QR CODE
www. KuTechVideo s.c om/vg13/2016
ENGINESTART
STOP


To use electrical accessories:
ACC position

•When in the OFF position and without depressing the brake pedal, press the ENGINE START/STOP button once (orange light A)
ON position

•When already in the ACC position (orange light A) and without depressing the brake pedal, press the ENGINE START/STOP button again
(red light B)
• When in the OFF position and without depressing the brake pedal, press the ENGINE START/STOP button twice (red light B)
Keeping the vehicle in ACC or the ON position for extended periods of time without turning engine on may discharge the
vehicle’s battery.
QUICK TIPS
A
B
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS. *IF EQUIPPED
DRIVER'S PANEL

14
It may be helpful to pull/push bottom of Steering Wheel towards/away from you to
adjust desired distance
Manual Tilt/Telescoping Steering Wheel*
To adjust the Steering Wheel, press the Lock-Release Lever A down and
adjust to desired distance B and angle C
When finished, pull the Lock-Release Lever
A up to lock Steering Wheel
in place
Power Tilt/Telescoping Steering Wheel*
To adjust the Steering Wheel angle D, move the switch E up or down
To adjust the Steering Wheel distance
F, move the switch E forward
or backward
A
B
C
D
F
E
QUICK TIP
CADENZA FEATURES & FUNCTIONS GUIDE
*IF EQUIPPED
STEERING WHEEL CONTROLS